Cleveland Range KGT-6-T, KGT-12-T User Manual
Cleveland
™
P
roject ________________________________
I
tem __________________________________
Quantity _______________________________
FCSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
GAS KETTLES
TABLE TOP, GAS-FIRED KETTLES
TILTING, 2⁄3 STEAM JACKETED
“SPLASH PROOF SERIES”
6 or 12 GALLONS (23 or 45 LITERS)
Cleveland Standard Features
n Self contained gas tilting kettle is easily installed, only needs a
g
as connection and a 115 volt outlet.
n Precise, consistent temperature control, less than 1°C
temperature variance (ideal for simmering). Operating
temperature range from 145°- 260°F (63°C-127°C).
n “Splash Proof” solid state control panel for temperature,
low water safety
indicators for heat cycle and low water warning.
n Kettle and all exterior surfaces are a 304 Stainless Steel
with a #4 finish.
n Energy efficient (65%), high performance gas-fired
heating system for fast heat up and recovery time:
n
Six gallon model with a 34,000 BTU firing rate, and
n
22,100 BTU directly applied to the product.
n
Twelve gallon model with a 53,000 BTU firing rate, and
n
34,450 BTU directly applied to the product.
n Supplied with Gas Pressure Regulator
n Standard for natural gas operation.
n Self locking marine type tilting mechanism prevents
accidental tilting. Balanced design makes it easy to tilt. The tilt
handle easily mounts on left or right side. Double safety gas
shut off turns off the gas when the unit is tilted.
e pouring lip f
g
n Lar
Rolled Rim design provides strong reinforcement, prevents
damages from abuse.
n “Splash Pr
n Steam jacket permanently filled with treated distilled
n 50 PSI Steam Jacket Rating. Safety valve mounted toward
n A
n Supplied with cord and plug for 115 volt controls.
n T
venting and / or refilling is not required.
water,
rear of kettle to avoid tampering.
utomatic Electr
ypical approvals include
, and power “on/of
or easier, faster pouring.
oof” recessed pressure/vacuum gauge.
onic Spark Ignition System.
AGA, CSA, CE, NSF and ASME.
f” switch.
Options & Accessories
p Stainless Steel equipment stand with sliding drain drawer and
splash shield (ST-28)
p Hot and cold water faucet (DPK), or Cold Water (SPK).
Requires bracket (FBKT)
p 316 Stainless Steel Liner (316G)
p Cooking Baskets (BS)
p Food Strainers (FS)
Accurate L.E.D.
.
Heavy duty
MODELS: c KGT-6-T
c KGT-12-T
Short Form Specifications
ype, self-contained, tilting,
Shall be CLEVELAND, gas kettle, T
Model KGT- _____ -T; _____gallons, natural or LP gas, 2/3 steam jacketed, type 304 Stainless Steel and supports. Jacket rated at 50 psi
with Safety Valve. Complete with solid state water level, temperature, and safety low water power cut off, including LED indicators.
Option lift off cover.
p Measuring Strips (MS)
p Spray Hose (PRS-K)
p Lift Of
p Propane Gas Operation (PG)
p Self Locking Hand
p Kettle Markings (KM)
p Protective Control Panel (PCE)
f Cover (CL)
ilt Mechanism
(HTK - 12 gallons only)
T
able T
SECT
.
IX P
AGE
1
0707
CAPACITIES: (in 4 oz. servings, other sizes may be
C
H
•
calculated)
16 gallons / 23 liters .......192 servings
12 gallons / 45 liters .......352 servings
SIZE
KETTLE
GALS. LITERS
623
12 46
NA
piping:
Supply pressure: Supply pressure:
4.5˝ W
14.00˝ W.C. maximum 14.00˝ W.C. maximum
Manufacturer must be notified if unit will be operated above 2,000 ft. [610m] altitude.
TES
NO
:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Installation of backflow preventers, vacuum breakers and other specific coder requirements is the responsibility of the owner and installer.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., A.G.A., NSF, ASME/N.Bd., CSA, CGA, ETL and others.
INCHES
mm 610 490 340 279 476 594 730 108 826 610 940 400 692
INCHES 27 203⁄8 163⁄4 141⁄16 23 27 39 57⁄8 43 30 43 161⁄2 31
mm 686 518 425 357 584 686 991 149 1092 762 1092 419 787
TURAL
3
⁄4˝ NPT. piping: 3⁄4˝ NPT.
.C. minimum 11.00˝ W.C. minimum
ABCDEFGHJ KLMN
24 191⁄4 133⁄8 11 1 83⁄4 233⁄8 283⁄4 41⁄4 321⁄2 24 37 153⁄4 271⁄4
GAS CLEARANCE
ANE
PROP
12 gal. 53,000
TING
.U. RA
B.T
6 gal. 34,000
ELECTRIC
120V 1 ph
60 hz
6 ft. [1.8m] cord
c/w u-ground
plug supplied.
5 amps
WATER
3
⁄8˝ O.D. copper tube
or
1
. pipe.
.T
⁄2˝ N.P
When ordered with
optional faucet.
RIGHT = 0˝
LEFT
REAR = 4˝ [102cm]
0˝
=
O SCALE)
T
(NOT
.
SECT
AGE
IX P
0707
Litho in U.S.A.
2
Loading...