Cleveland IWC-PDW User Manual
Cleveland
™
P
roject ________________________________
Item __________________________________
Quantity _______________________________
F
CSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
OPTIONS & ACCESSORIES
IN-WALL CARRIER
FOR USE WITH WALL MOUNTED,
DIRECT STEAM, PRESSURE STEAMERS
Cleveland Standard Features
II
Welded Steel Construction
II
Furnished with 8 each 5/8"-11 NC studs for supporting
steamer Carrier Channels. Does not include necessary
Double Hex Nuts (16 each 5/8"-11 NC)
II
Provided with eight, floor studs holes (11/16" Diameter)
to receive pre-set floor studs (5/8" diameter)
II
To be imbedded in floor and wall and covered with
appropriate surfaces
II
In-Wall Carrier is required for Wall-Mounted Units and
should be included in specification for Steamer
II
Completed installation provides unobstructed floor area
for cleaning
Options & Accessories
Ë Mounting Studs, in lengths other than standard
MODEL: IWC-PDW
Short Form Specifications
Shall be CLEVELAND, Model IWC-PDW, In-Wall Carrier, Steel, for installing
Cleveland Pressure Steamers. Includes (8) Supporting Studs 5/8" - 11 x
2 1 /2" long .
SECT. XIII PAGE 5
0609
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., NSF, CGA, CSA, ETL and others.
(NOT TO SCALE)
SECT. XIII PAGE 6
0609
Litho in U.S.A.
Loading...