Cleveland GMF User Manual
Cleveland
™
P
roject ________________________________
I
tem __________________________________
Quantity _______________________________
FCSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
OPTIONS & ACCESSORIES
WATER METERS
AUTOMATIC WATER METER & DISPENSING SYSTEM
GMF, LMF SERIES
GMC1, LMC1 SERIES
Cleveland Standard Features
n Automatically meters and dispenses water up to a
maximum temperature of 80° F. (27° C).
n All 304 Stainless Steel Exterior Construction.
n Power On/Off Switch controls operation.
n Water Resistant Controls and Switches.
n Adjustable Volume Setting Indicator to measure the
correct amount water requirements.
n Digital LED readout indicates gallon output during
operation.
n Start Switch with Reset and Continue Mode operation
for starting and stopping in-between filling operation.
n Interrupt Control Switch to stop filling during operation.
n 115 Volt, 60 Cycle, 1 Phase Standard. 220 Volt, 60 Cycle,
1 Phase optional. Supplied with Cord and Plug.
n Cold Water connection only,
required.
n Large Flow
3
⁄4˝ Stainless Steel Swing Spout fills kettles
quickly.
n For wall mounted models, three
pre-punched from the factory to bolt against a wall.
Options & Accessories
3
⁄4˝ potable cold water line
5
⁄16˝ diameter holes are
Wall or Stand Mounted Models:
c MODEL GMF - U.S GALLONS
c MODEL LMF - LITERS
t Form Specifications
Shor
Shall be CLEVELAND, Model ___ M _____ Water Meter; 115 Volt, 60
Cycle, 1 Phase; Supplied with Cor
exterior constr
Switches; Adjustable V
Switch with Reset and Continue Mode operation; Lar
Steel Swing Spout.
uction; Power On/Of
olume Setting Indicator; Digital LED Readout; Star
Console Mounted Models:*
c MODEL GMC1 - U.S. GALLONS
c MODEL LMC1 - LITERS
d and Plug; all type 304 Stainless Steel
f Switch; W
ater Resistant Controls and
3
ge Flow
⁄4˝ Stainless
t
p Model SWM Stand for GMF and LMF models.
*For Console Mounted Models:
p Requires Console Mounting Option (CM)
vailable for all KEL
p A
MKEL and MKDL mixer kettles
p GMC1, LMC1 is not available on KGL or MKGL
series kettles
and KDL floor model kettles,
SECT. XIII PAGE 1
0707
HOSE BRKT
1
2.13”
(308mm)
1
7.38”
(
441mm)
1
2.50”
(
318mm)
9
.63”
(
24mm)
48.50”
(1232mm)
22.00”
(559mm)
41.5”
(105.4mm)
12.00”
(305mm)
DIA.
5.63”
(
143mm)
1
0.00”
(254mm)
4.75”
(
121mm)
9
.50”
(241mm)
3/4” UNION
W
ATER INLET
48.00”
(
122mm)
RECOMMENDED
OPTIONAL WALL MOUNT UNIT SHOWN
WITH OPTIONAL FILLER HOSE
STANDARD WATER METER SHOWN
ON OPTIONAL PEDESTAL MOUNT
1.88”
(
48mm)
6’ - .75” O.D.
(
183cm x 19mm O.D.)
O
PTIONAL HOSE
.55” (14mm) DIA.
ON 10.75” (273mm) BCD.
LEVEL ADJUSTABLE
115V / 1PH
5
’ (152cm) CORD
WALL
FLOOR
6.00”
(152mm)
STANDARD:115V, 1PH, 60HZ
OPTIONAL: 208-240V, 1PH, 50/60HZ
ELECTRICAL RATINGS
TES
NO
:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Installation of backflow preventers, vacuum breakers and other specific coder requirements is the responsibility of the owner and installer.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., A.G.A., NSF, ASME/N.Bd., CSA, CGA, ETL and others.
SECT
.
AGE
XIII P
Litho in U.S.A.
2
0707
Loading...