ClearOne Interact Wired Controller User Manual
INSTRUCTION SHEET
INTERACT PRO, AT WIREDCONTROLLER
Connecting the Wired Controller
1. Connect the wired controller to the mixer’s RS-232 serial port using the supplied RJ-11 to DB-9
adapter.
Note: Since the wired controller uses the serial port, you must use the mixer’s USB port in
order to connect your computer to the mixer (see the INTERACT User's Manual for connection
instructions).
2. Using the INTERACT software, configure the serial port to a baud rate of 57600 with flow control OFF
(see the INTERACT User’s Manual for more information).
Note: You can also set flow control to OFF via the controller’s menu system.To do this, press
the MENU button, navigate to the CONFIGURATION screen and press ENTER. Next, navigate
to the WIRED CONTROLLER screen and press ENTER. Finally, select ENABLED and press
ENTER.This turns flow control OFF.
Technical Support
Telephone 1-800-283-5936 Fax 1-801-977-0087
1-801-975-7200 E-mail Tech.Support@ClearOne.com
© 2011 ClearOne - All rights reserved. Information in this document is subject to change without notice. Other product names may be
registered trademarks of their respective owners who do not necessarily endorse ClearOne or ClearOne’s products in the United States
and/or other countries. ClearOne Document: 800-154-035 Revision 2.1 January 2011.
Loading...