Classe Audio Delta IR Interface Owners manual

Classé Audio Inc.

Date:
Model Number:

Subject:

April 25, 2005

3032-001
Delta Series IR Interface

Introduction

IR repeater systems are commonly designed for use with flashers (A.K.A. IR emitters, micro/mouse flashers, blink-IR).

Flashers are placed in front of the equipment to be controlled and require an active-high-idle-low frequency modulated
signal.

Classé offers a rear panel hardwired IR connection on all of its Delta series components, for remote IR control.

The format of this IR signal must be active-low-idle-high without modulation (carrier stripped).

Many IR repeater systems do not yet support an active-low-idle-high carrier stripped signal requirement. To
accommodate most third party IR repeater systems, Classé has designed an IR interface box.

DELTA Series IR Interface Connections

TYPICAL APPLICATIONS

Contact info Tel. : [phone], Fax : [phone], Email : [e-mail]

PRO-UPD_FORM-1011 Rev. 01 3032-001 (IR Interface) Rev02.doc Page 1 of 2

Classé Audio, Inc. 5070 Francois Cusson Lachine, Québec Canada H8T1B3

TROUBLE SHOOTING

SYMPTOM POSSIBLE CAUSE CHECK FOR:

No IR response or

sluggish IR response

No IR response or

sluggish IR response

No IR response or

sluggish IR response

IR receiver and unit in close proximity Delta Series units will process both front and

rear IR signals – whichever it senses first.

Watch for reflections off of white walls.

Too many components daisy chained. Check for voltage drops at end of the chain

Signal saturation Remote control too close to IR receiver

Consult your IR repeater system instruction manual for other trouble shooting guidelines.

PRO-UPD_FORM-1011 Rev. 01 3032-001 (IR Interface) Rev02.doc Page 2 of 2