Clarke CWB 1200E, CWB 1550E, CWB 1800E, 7637715, 7637720 User guide

...
ENGINEERS WORKBENCH
MODELS: CWB1200E, CWB1550E & CWB1800E
Part Nos: 7637715, 7637720 & 7637725
ASSEMBLY INSTRUCTIONS
11/08
INTRODUCTION
Thank you for purchasing this CLARKE workbench. Please follow these assembly instructions carefully.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended. Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not effect your statutory rights.
PARTS LIST
Unpack your workbench and check to ensure that no damage was suffered during transit. Should any damage be apparent, you should contact your Clarke dealer immediately.
The kit comprises:16 x sets of bolts & nuts c/w 2 flat washers
1 x Worktop 1 x Shelf 4 x Legs
Tools required: 2 x 17mm spanners
ENVIRONMENTAL PROTECTION
Do not dispose of this product with general household waste. All tools, accessories and packaging should be sorted, taken to a re-cycling centre and disposed of appropriately.
SPECIFICATION
oNledoM oNtraP mm)hxdxl(smiD thgieW daoLlatoT daoLpotkroW daoLflehS
E0021BWC5177367688x646x0221gk03gk006gk003gk003
E0551BWC0277367688x646x4251gk53gk006gk003gk003
E0081BWC5277367688x646x
9281gk04gk006gk003gk003
2
ASSEMBLY
The workbench is best assembled with the use of an assistant.
1. Identify which is the front and rear of both the lower shelf and the table top. Note; the table top and shelf have an ‘open’ front and an upstand at the rear.
Note: the legs will be positioned to the outside of the table top and shelf. All fixings should have the bolt head on the visible face of the assembly.
2. Rest the workbench top on its rear edge.
3. At each of the bolt holes attach a leg, with the foot pad downwards, using two bolts with each leg. Ensure a flat washer is used with both the nut and bolt.
Lift the assembly clear of the floor to install the second nut and bolt. Nip up the nuts - DO NOT fully tighten.
4. With the help of an assistant, position the lower shelf on the legs, and bolt it to the legs. DO NOT fully tighten the nuts.
5. Attach the second pair of legs in a similar manner using two bolts, nuts, and flat washers where each leg joins a shelf. DO NOT fully tighten.
6. Finally, turn the workbench on to its feet and wriggle it vigourously to ensure it is completely stable and resting evenly on all four legs, then fully tighten all the nuts/ bolts. Two spanners will be required to tighten the fixings, moving in opposition to each other.
7. The workbench is then ready to use.
For parts & Servicing, please contact your nearest dealer, or CLARKE Interna-
tional, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400 / FAX: 020 8558 3622
or e-mail as follows:
PARTS: Parts@clarkeinternational.com
SERVICE: Service@clarkeinternational.com
3
Loading...