Page 1
CAR RAMPS CR2000 & CR2500W
Part Nos 7610149 and 7610153
INSTRUCTIONS FOR USE - (PLEASE KEEP)
These ramps are suitable for most low ground clearance cars but check that
car valance clears ramp when driving up.
1. Place ramps (and CR-EX1
extensions if used) on firm
ground and only use in pairs.
2. Use on a hard level surface e.g.
concrete.
3. Check the ramps are correctly
in position before mounting.
4. Ensure tyres are fully inflated.
5. Use only as a pair - front or rear wheels - not one side of the vehicle.
6. Take great care to drive up centrally.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Page 2
7. Take extra care with 3-wheeled vehicles/trailers.
8. After mounting, apply handbrake and chock wheels.
• A slight set may occur in the ramps on first use, this will not impair the
future use of the product.
SPECIFICATIONS
CR2000 CRW2500W
Capacity per pair (MaxGross Vehicle Weight)
Construction 20x20/25x25 angle 25mm x 25mm angle
Dimensions (Per Ramp) 800mm x 220mm x 240mm 800mm x 220mm x 240mm
Platform width 180mm 205mm
Approx platform height 180 mm 190 mm
Weight (per pair) 9.5kg 10.5kg
2000kg (2 Tonne) 2500kg (2.5 tonne)
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of
12 months from the date of purchase. Please keep your receipt as proof of
purchase. This guarantee is invalid if the product is found to have been
abused or tampered with in any way, or not used for the purpose for which it
was intended.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission. This guarantee does not effect your
statutory rights.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Loading...