Clarke 4003060 User guide

Download

Page 1

2 IN 1 WORKLIGHT

MODEL NO: CWLCOB3

PART NO: 4003060

USER INSTRUCTIONS

ORIGINAL INSTRUCTIONS GC0121 rev 2

Page 2

INTRODUCTION

Thank you for purchasing this CLARKE worklight. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.

SPECIFICATIONS

COBLED Worklight output = 150 Lumens

LED Torch output = 80 Lumens

IP Rating: 20

ENVIRONMENTAL RECYCLING POLICY

Through purchase of this product, the customer is taking on the obligation to deal with the WEEE in accordance with the WEEE regulations in relation to the treatment, recycling & recovery and environmentally sound disposal of the WEEE.

In effect, this means that this product must not be disposed of with general household waste. It must be disposed of according to the laws governing Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal facility.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase.

This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for its intended purpose.

Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not effect your statutory rights.

SAFETY PRECAUTIONS

1. This product must not be immersed in water.

2. Do not use this worklight in hazardous locations, such as flammable or explosive environments.

3. Never shine the light directly into the eyes of any person or animal.

4. Keep out of reach of children. Batteries should be changed by an adult.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Page 3

OPERATING INSTRUCTIONS

To operate, press the On/Off button on the front of the workght in the sequence shown.

BATTERY REPLACEMENT

1. Push the battery compartment cover latch with your thumbnail and lift away the cover.

2. Install 3 x AAA batteries (not supplied), into the compartment.

• Note that the negative end of

each one bears against the matching spring in the housing.

3. Replace the battery cover.

Your worklght is now ready for use.

There are no user serviceable parts in the worklight, DO NOT attempt to disassemble it.