Clarion TTXOOI, TTX001 Owner's Manual

TTXOOI

lo

oj

TV

TUNER

clarion

TTX001

INTRODUCTION

The Clarion
multimedia system.

Two
Quick tuning to your desired stations

• Stereo broadcast reception
Video/audio (stereo) output jacks

Display function when using audio

TTXOOIisa TV Tuner.Itcan be integrated into a mobile

It

has a numberoffeatures, including:

typesofwiring permitted - stand alone or with VMA

1131

ABOUT

To
instructions listed
Please fill out and send
and aid in warranty service. Also, save
purchase.

THE

MANUAL

start enjoying your new Clarion

in

AND

this manual. Keep all instructions for future reference.

in

WARRANTY

the enclosed warranty card to protect your purchase

TTXOOI

TABLEOFCONTENTS

Precautions
Description
Package Contents
Connector Locations
Wiring Precautions

Applications
Using the Remote Control

Troubleshooting
Product Specs

Notes

·····································2

·····································3

·································3

·······························3

································4

••

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • ·5

····························9

•••

- • • - - - - - • • - • • • • - • • • - • • • - • • • • • -10

••

•••••••••••••••••••••••••••••••••••••••

- • • • • - • - • • • • • • • • • • • • • • • • • • • • • • - -

PRECAUTIONS

1.

This unitisfor use in DC

12V,

negative ground vehicles.

TV Tuner, please readthe

your

original sales receipt as

-II

·11

proof

of

2.

Do not operate the unitinways other than described in this guide. Doing
may damageitand may void your warranty.

3.

SAFETY FIRST! For rear seat use
video information anywhere that would permit viewing by the driver.
Monitors must not be located in the motor vehicle at any point forward
the backofthe front seats. Monitors must never be used in any manner that
will distract driver or interfere with driver's safe operation
vehicle.

4.

Be careful nottorun down the car battery while using the unit with the car

stopped.

5.

Do not disassemble or modify the unit. Doingsomay damage it and voids

your warranty.

6.

Keep

drinks>

damage the internal circuitry.

and drops from umbrellas away from the unit. Water may

2

only.

Do

not install monitors displaying

of

the motor

so

of

OWNER'S

7.

Do not let the unit become hot.Iftemperature in the carishigh or the set

is

has been exposed to direct sunlight and

it.

using

DESCRIPTION

The Clarion
instance, the
Clarion VMA1131.

It

also has preset tuning (for a totalof12 VHFfUHF stations), manual tuning

and automatic tuning to permit easy tuning

TTXOOI

TTXOO

TV tuner has a numberofexceptional features. For

1 allows two typesofwiring: stand alone or with the

hot, lower the temperature before

of

the desired broadcast stations.

MANUAL

PACKAGE

The

TTXOO
TV tuner
RC-300 remote control

16

IR Receiver

AN

Power harness

3.5mm Male to Male IR extension
Y connector for IR

CONNECTOR

CONTENTS

1 comes with the following items:

pin to

AN,

RCA cable

IR and power inputs

LOCAnONS

TTXOOI

CD

Figure

G) 3.5mm Antenna Connector

@ IR Sensor

1-

® Connector

@ IR Sensor Connector

@ Video Output Connector

® R Audio Output Connector

(J)

LAudio Output Connector

@ Power Connector

® IR Input Connector

3

Clarion

TTX001

WIRING PRECAUTIONS

Read all wiring precautions.Ifyou are not sureofthe connections, contact
your authorized Clarion dealer.

1.

Disconnect the negative (-) leadofthe battery before making any power
connections.

2.

When creating passage holes for the power wires, use grommets to
eliminate any sharp edges created during drilling. This will protect the wire
from being nicked and causing a short circuit.

3.

When connecting the ground lead, fasten the ground lead (black) securely
to a clean metal plate on the vehicle.

r-----------------------------

IN-DASH

r61

__

LYJ((I7)

t

I
I
I

I I

~----------------------------~

..

TTXOOI

~

I
I

I
I

I
I

I

I

I

I

I

l
I
I

I

I
I
I

I
I

I
I
I

I
I

I
I

I

I~

~

Figure 2- Wiring

4

TO

VIDEO INOFDISPLAY

TO AUDIO OUT

OF

SOURCE

APPLICATIONS

The

TTXOO

1.

Place tuner into the channel on the backofthe monitor and slide the tab
into the slot.

1 canbeoperated in a numberofapplications. Find yours below.

With the VMAl131

Mount

tuner with the two machine screws supplied.

2. Plug the
the back

3.

Mount the antenna (ZCB-003orequivalent) and plug into the antenna input
of

the tuner.

4. Plug the

16to16
of

power

pin cable (supplied with the monitor) into the tuner and

the monitor.

connector into the monitor and connect to vehicle accessory

and ground.

Operation

• The tuner can be controlledbythe buttonsonthe monitor orbythe remote

control.

'i' 'i'

TTXOOI

$

Figure 3-

TTXOOI

with

~

..

@

~

~

IlllllUllllllUllutllll1

IIIttllllllllll

VMA1l31

$
$

5

Clarion

TTX001

With the VDH9600, OHM641 and the

1.

Pick a location to mount the tuner. Typically the tuner will be located close
to

the

Vep.

Avoid areas with excessive heat or moisture and mount the

tuner.

2.

Mount the TV antenna (ZCB-003 or equivalent) and plug into the tuner.

3.

Plug the16pin to A!V out connector into the tuner. Plug the
cables, IR extension and power plug into the
the video player.

4.

Plug the A/V RCA cable into the
connector into the player and plug the IR extension into the Y connector.

5.

At the
OHM641. Run these cables to the back
RCA into the video output
other leg
will be run to the radio location.

6.

Plug

audio RCA and main power cables to the radio location. Remove the radio
and plug the audio RCA into the FMIOOS audio inputs.

7.

Mount the switch for the

location. The power and ground wires
OHM641 and the FM 1
accessory and ground wires.

8.

Plug the vehicle antenna into the antenna inputofthe FM100S. Plug the
antenna output

g.

The
Pick the frequency that has the least amount

frequency on the modulator and into a radio preset memory.

OHM64l,

of

the

audio RCA cable into the audio outputofthe player and run the

FM

100S has a two position switch to select the modulation frequency.

plug the IR extension and power cables supplied with the

of

the Y connector. Tie all the power wires together. These wires

FMIOOS

ODS

of

the FM 1

OOS

AN

inputofthe player. Plug the Y

the player. Plug the IR extension into the

and run its power wire to the radio

of

can be joined and connected to the radio

into the radio.

16

of

the video player. Plug the video

the

TTXOO1,video player,

of

FMI00S

AN

RCA

pin connector and run to

radio reception and set that

Operation

• Similar to a home system, the VDH9600 allow their auxiliary AJV inputs to

loop through to their
Because the IR lines have been linked together, each component can be

controlled by its respective remote control when pointed to the IR eye
located on OHM641.

Tum the vehicle ignition switch to the accessory position. Point the video
player remote at the IR eye and press power to
remote (Re-300) at the

• You should now see the TV displayed on the monitor.
Tum

the modulator and the radio on and tune to the modulated frequency.

Tum

the FM100S's switch on. The audio can now be heard over the sound

system. You can control the video player and the TV tuner by pointing their
respective remotes at the IR eye in the monitor.

6

AN

outputs when they are not playing a video tape.

tum

on the player. Point the

IR

eye and press power to

tum

on the tuner.