Clarion TTX754 User Manual

Owner’s manual & Installation manual
使用說明書和安裝說明書
TTX754
CeNET TV TUNER (PAL)
CeNET電視調諧器(PAL制式)
MODEL
TTX754
CeNET TV Tuner
12V GROUND
VHF 45.75MHz-224.25MHz UHF 471.25MHz-855.25MHz
8mmMAX
280-8285-00
English
Thank you for purchasing this Clarion product.
• Please read this Owner’s manual & Installation manual in its entirety before proceeding with wire connection and installation.
• After reading this manual, be sure to keep it in a handy place (e.g., glove compartment).
If you sell the motor vehicle, please leave the manual in it so that the new owner can use it.
• Read the contents of the enclosed warranty card and keep it with this manual.
Contents
1. PRECAUTIONS ........................................ 3
2. PACKAGE CONTENTS............................ 3
3. SET COUNTRIES LIST ............................ 4
4. SPECIFICATIONS ....................................5
5. TROUBLESHOOTING .............................. 6
6. INSTALLATION ........................................ 7
7. CAUTIONS ON WIRING .......................... 7
8. WIRING CONNECTIONS ......................... 8
感謝購買本 Clarion 公司產品。
在進行接線和安裝之前,務必通讀本使用說明 書和安裝說明書。
讀完本使用說明書後,請保管在手頭便于取閱 的地方(例如:手套箱)。
如果您出售汽車,請將使用說明書留放在汽車 內,以便新的車主能夠使用它。
請閱讀另附保用卡的內容並與本使用說明書一 起妥善保管。
目錄
1. 注意事項 ............................. 9
2. 包裝內容 ............................. 9
3. 設定國家一覽表 ...................... 10
4. 規格 ................................ 11
5. 故障檢修 ............................ 12
6. 安裝 ................................ 13
7. 接線注意事項 ........................ 13
8. 接線 ................................ 14
2 TTX754
280-8285-00
1. PRECAUTIONS
English
This equipment uses DC 12 V only. Do not use this equipment on 24 V vehicles such as large trucks.
When driving, keep the TV tuner volume down to a level where you can hear sounds from outside the vehicle.
If a problem occurs such as entry of a foreign object, water gets into the tuner, or it produces smoke or strange smells, stop using the tuner immediately, and consult your dealer.
Tuner Handling
Disconnecting the cables while the system is operating may cause a system breakdown. Always turn off the power (ACC-OFF) before you disconnect the cables.
If the power supply to the system is stopped due to battery replacement, etc., the details you have entered into the microcomputer memory may be erased and the settings may return to the default settings. If this occurs, enter your settings again.
INFORMATION FOR USERS:
CHANGES OR MODIFICATIONS TO THIS PRODUCT NOT APPROVED BY THE MANUFACTURER WILL VOID THE WARRANTY.
Reception
If your vehicle is outside the broadcast transmission range, the radio waves will become weak and reception will deteriorate. UHF stations and regional broadcast stations output a comparatively weak radio transmission, so the reception conditions may get worse while driving over a distance of only a few kilometers.
The screen image may be disturbed and output noise due to train lines, high voltage power lines and traffic signal lights.
This equipment does not have a display function, so the screen will be black during driving.
中 文
2. PACKAGE CONTENTS
1. TV tuner unit (TTX754)
2. Users Manual / Installation Manual .................................................................................................. 1
3. CeNET cable (2.5 m) ......................................................................................................................... 1
4. RCA video cable (2.5 m) ................................................................................................................... 1
5. Accessories Bag ................................................................................................................................1
6. PKB connection cable ....................................................................................................................... 1
TTX754 3
280-8285-00
English
3. SET COUNTRIES LIST
The TV area function can be used to set the following country areas.
No. Set Countries Display Title
0 ALBANIA 1 AUSTRIA 2 BELGIUM 3 BOSNIA I H 4 CZECH 5 DENMARK 6 FINLAND 7 GERMANY 8 HUNGARY
9 ICELAND 10 IRELAND 11 ITALY 12 NETHERLNDS 13 NORWAY 14 PORTUGAL 15 RUMANIA 16 SLOVAKIA 17 SLOVENIA 18 SPAIN 19 SWEDEN 20 SWITZERLND 21 TURKEY 22 UK 23 AFGHAN. 24 ALGERIA 25 ANGOLA 26 AUSTRALIA 27 BAHRAIN
No. Set Countries Display Title
28 CHINA 29 N.KOREA 30 GHANA 31 HONGKONG 32 INDIA 33 INDONESIA 34 ISRAEL 35 JORDAN 36 KENYA 37 KUWAIT 38 LIBERIA 39 MALAYSIA 40 MOLDIVES 41 N.ZEALAND 42 NIGERIA 43 OMAN 44 PAKISTAN 45 QATAR 46 SINGAPORE 47 S.AFRICA 48 SRILANKA 49 SUDAN 50 THAILAND 51 U.ARABE. 52 UGANDA 53 YEMEN 54 ZAMBIA
Note:
• In Australia, the channel display for channel 9A may not appear properly, depending on the kind of main unit with which this component is combined.
4 TTX754
280-8285-00
4. SPECIFICATIONS
Reception channels: VHF CCIR 2 to 12ch
UHF CCIR 21 to 69ch
Antenna input: 75 unbalanced
voltage: 14.4 V
Grounding: Negative terminal grounding
Power consumption: 0.4 A or less
External dimensions: 178 mm (Width) 25 mm (Height) 100 mm (Depth)
Weight: 0.5 kg
100
English
6.6
* The specifications and design may be subject to change without prior notice due to
improvements.
178
25
TTX754 5
280-8285-00
English
5. TROUBLESHOOTING
The following symptoms may not be the result of a breakdown, so perform the remedy suggested below before contacting your Dealer for repairs.
Symptom Cause Remedy
No power
No image
Unclear image from rear seat monitor
Image is unclear
Double or triple image
Image is spotty or striped
Wiring is incomplete.
Parking brake is not engaged.
Image output for front and rear is connected in reverse.
Poor reception
Poor reception
Electrical interference
Check the wiring method in the manual again, then connect the wiring properly.
Check that the parking brake is engaged completely.
Check the connection method in the manual again, then connect the wiring properly.
The transmission may not be reaching you properly because you are in a valley or the shadow of a building. Check again at a location where the transmission can reach you properly.
The image may be affected by transmission reflected from mountains or buildings. Change your location or the reception direction.
Reception may be affected by radio interference from another vehicle, a train, high voltage or neon signs. Check your reception again at another location.
6 TTX754
280-8285-00
6. INSTALLATION
CAUTION
• Disconnect the battery negative cable before connecting the wiring.
• If you are making holes in the vehicle body in order to install the unit, first confirm the position of pipes, tanks and electrical wiring to avoid contact and interference.
• When installing the wiring for connection cords on a vehicle equipped with airbags, do not install the wiring where it may affect the airbag system.
• Do not cover the ventilation holes and heat-radiating parts of the tuner.
English
Installation Using Screws
1. When using the installation holes at the sides of the unit, use M4 8 screws. Using
Installation Using Velcro Tape
1. Apply Velcro tape to the bottom surface of the unit.
screws other than the specified screws may cause a malfunction.
2. Attach the unit to the floor carpet beneath the seat.
2. If you are going to drill holes in the dashboard, make sure beforehand that there are no harnesses behind the dashboard at that position or nearby.
MODEL
CeNET TV Tuner
12V GROUND
VHF 4
5.75MHz-224.25MHz
UHF 4
71.25MHz-855.2
Chassis
Max. 8 mm
7. CAUTIONS ON WIRING
Pay particular attention to the following points when laying out the cords.
Keep the unit’s cables as far away as possible from the vehicle’s wiring bundles.
Keep the unit’s RCA pin cord and the power cord separated as far as possible.
TTX754
5MHz
ISO
8mmMAX
CAUTION
• When you have finished connecting the cords, secure them with clamps and insulating tape for protection.
• Make sure that the connection cables will not get caught on burrs and edges of the metal parts under the seat. It could damage the cables and cause noise from the unit.
• To assist safe driving, connect the parking brake connection terminal to the lead wire on the lamp side of the parking brake lamp switch.
TTX754 7
280-8285-00
English
8. WIRING CONNECTIONS
Connect the unit as follows.
Notes:
*1 Connect the cable to the terminal of equipment (center unit) that is connected by connection
cables (CeNET cable) with the L-shaped terminals.
*2 Connection requires a CCA-389 conversion cord (RCA3P mini DIN8P) which is sold
separately.
*3 If you are connecting an antenna other than a 4 system diversity antenna, connect it to the MAIN
terminal on the far right.
*4 Connect the terminal to the lead wire on the lamp side of the parking brake lamp switch. After
connection, apply the parking brake, then check that the TV displays an image.
If the PKB cable is not connected to the side brake, some units may not operate.
For connection of the Clarion CD changer (sold separately) for CeNET use.
For connection of the rear seat monitor (sold separately).
For connection of the monitor (such as the Clarion VRX756VD, sold separately).
For connection of a video appliance (2) such as a handy camera (sold separately).
For connection of a Clarion CCD camera (sold separately). *
For connection of VRX756VD, connect the CCD camera to the NAVI/CCD terminal of VRX756VD.
Antenna main (MAIN) terminal
8 TTX754
This unit (TTX754)
Supplied CeNET cable (1)
Main unit (
NAVI/CCD terminal.
such as the Clarion VRX756VD
For connection (3) of a Clarion antenna such as ZCP-104 (sold separately).
To parking brake
)
Terminal (4) for connection to parking brake.
Supplied PKB cable
Supplied RCA video cable (1)
280-8285-00
Loading...