Do not operate the unitinways other than describedinthis guide.
Doing so may damage it and may void your warranty.
3.
SAFETY FIRST! For rear seat use only!
displaying video information
be located
in
the motor vehicle at any point forward of the back of
the front seats. Monitors must never be use
would distract driver or interfere with driver's save operation of the
motor vehicle.
4.
Be careful not to run down the car battery while using the unit with
the car stopped.
in
DC
12V,
negative ground vehicles.
Do
not install monitors
in
view of the driver. Monitors must not
in
any manner that
Page 3
5.
Do not disassemble or modify the unit. Doing so may result in
damage and it voids your warranty.
6.
Keep drinks and drops from umbrellas away from the unit. Water may
damage the internal circuitry.
in
7. Do not let the unit become hot. If temperature
the car is extremely
hot or the tuner is exposed to direct sunlight, please allow adequate
time to cool off.
8.
Install the unit away from any obstacles which may damage the unit.
For example: near doors and foot wells.
DESCRIPTION
• Auto detect NTSC system
• Full TV frequency range for VHF/UHF
• TV channel Auto/Manual scanning and memory
• 4 channel diversity antenna inputs
•1 RCA composite video output for TV/Monitor display
• 2 RCA audio outputs
It also has preset tuning (for a total of 12 VHF/UHF stations), manual
tuning and automatic tuning to permit easy tuning of the desired broadcast stations
PACKAGE CONTENTS
The TTX005 comes with the following items:
• TV Tuner
• Remote Control
• Power Cables
IR
•
•
Remote Eye
AN
RCA Cable
• Owner/Installation Manual
2
Page 4
CONNECTOR LOCATIONS
1.
Power Inputs
2.
Audio Outputs
3.
Video Output
4.
IR Remote Eye Input
5.
TV Antenna Inputs
WIRING PRECAUTIONS
Read all wiring precautions. If you are not sure of the connections,
contact your authorized Clarion Dealer.
1.
Disconnect the negative(-)lead of the battery before making any
power connections.
2.
When creating passage holes for the power wires, use grommets to
eliminate any sharp edges created during drilling. This will protect
the wire from being nicked and causing a short circuit.
3.
When connecting the ground lead, fasten the ground lead (black)
securely to a clean metal plate on the vehicle.
3
Page 5
WIRING CONNECTIONS
it
ii
RED:+12V
YELLOW:+12V
MEMORY
'-------------
BLACK:
'--
GROUND
LFROM
'--------
TV
(ZCB104 OR EQUIVALENT)
FROM REMOTE EYE SOURCE
TO
TO
OR FM MODULATOR
REMOTE EYE CONNECTOR SPEC
___
ANTENNA SOURCE
VIDEOINOF
AUDIO INOFRECEIVER UNIT
DISPLAY
---..II:::J
I I I
1 2 3
4
Page 6
REMOTE CONTROL
To
•
use the remote control, press the Power button to turn on the
TV tuner. -
L t
(if...
~""-+-+O-7
--+----t--+--
r---~.==:::::;:::;_t_-
1\.._,"""",-
6
8
9
1.
Power
2.
Auto Memory
3.
EraselWrite
4.
Previous
5.
Number
6.
Channel
7.
Volume (+)
8.
Volume (-)
9.
Next
10. Mute
Pad
(A)
/ Channel
('..)
o
l
,
USING THE REMOTE CONTROL
The following Remote Controls buttons are the only functional commands for this unit.
•Power unit ON/OFF.
Press the Power button.
• Volume Control.
Allows the user to change volume output.
• Auto Memory.
Allows the unit to search for available channels and automatically
saves it into the memory.
Note: Not all channels are availible
in
all areas, this process
may need to be repeated when entering a new area.
5
Page 7
•
To
Mute the sound.
Press the Mute button.
•Number Pad.
Use the Number button (0-9) to select available channels
Use the (10+) button to select double numeric channels.
•Channel Selections.
Use the CH up button to select next available channel.
Use the CH down button to select the previous channel.
•EraselWrite.
Allows the user to selectively add or remove Television channels
to and from the unit's memory.
•Previous.
Use this button to return to the last viewed channel.
•Next.
Use this button to change to the next channel.
REMOTE CONTROL BATTERY INSTALLATION
If the remote control does not function correctly or the operating
range is reduced, replace the battery with a new lithium CR2025 type
battery. Make sure to observe the proper polarity placement.
~:,
,®
CD
1.
Push tab to the right.
Pull out the battery
tray.
2.
Place battery
into the
tray.
3.
Return tray to
remote control.
6
Page 8
TROUBLESHOOTING
Before assuming malfunction of the unit, check the following:
PROBLEM
No power to unit.
re
The pictu
The picture has double
or triple images.
is not clear.
SOLUTION
Push the Power button
·
Check the wire connections and
·
connect them properly.
•Check the car battery.
•The reception condition is poor. This
may be due to an insufficient signal
in
due to being
mountains or buildings. Check again
a location exposed to a stronger signal.
Make sure that the TV antenna is
•
connected properly.
•There is an signal interference.
The signal might be reflected from
mountains or buildings. Check by
changing location or direction.
the shadow of
in
re
The pictu
or lined pattern.neon signs, or other interfering
Unit does not respond
to command.
PRODUCT SPECIFICATIONS
Power Source Voltage:DC 9-16V, 200mA
Power Consumption:
Operation Temperature: 30 - 113 degree F
7
has static
•There may be effects from cars, trains,
signals. Check by changing location.
Make sure that the battery
·
remote control is not the culprit.
Change the battery and try again.
2.4W±0.5W
on
the
Page 9
WARRANTY STATEMENT
This product is warranted against all defectsinmaterial workmanship for a period of one year from the
date of original purchase. Clarion ProAudio products, except for speakers, are covered by a two year limited warranty when installed by an authorized Clarion dealer.The conditions of this limited warranty and the
extent of responsibility of Clarion Corporation of America ("Clarion") under this limited warranty are as follows:
1. PROOF
UCT.
UCT, PROOF OF INSTALLATION BY AN AUTHORIZED DEALER IS REQUIRED. INFORMATION ABOUT
CLARION AUTHORIZED WARRANTY SERVICE CENTERS MAY BE OBTAINEDBYCONTACTING OR
WRITING CLARION
2. This limited warranty will become void if service performed by anyone other than an approved Clarion
Warranty Service Center results in damage to the product.
3.
This limited warranty does not apply to any product which has been subject to misuse, neglect or accident,
installed, adjusted
4. This limited warranty does not cover car static or other electrical interferences, tape head
up cleaning or adjustments, or labor costs for the removal or reinstallation
5. The sole responsibility
or
replacement of the product, at the sole discretion of Clarion.
6. Product must be shipped
prepaid. Clarion will not assume any responsibility for any loss
OF
DATEOFPURCHASE WILL BE REQUIRED FOR WARRANTY SERVICEOFTHIS PROD-
IN
THE CASEOFTHE TWO (2) YEAR LIMITED WARRANTY FOR CLARION PROAUDIO PROD-
AT
THE ADDRESS LISTED BELOW.
or
which has had the serial number altered, defaced or removed,orwhich has been connected,
or
repaired, other than in accordance with the instructions furnished by Clarion.
or
laser pick-
of
the unit for repair
of
Clarion under this limited warranty shall be limited to the repairofthe product
in
its original carton or equivalent carton, fully insured, with shipping charges
or
damage incurred in shipping.
WARRANTY INFORMATION
ALL IMPLIED WARRANTIES EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW SHALL
HAVE NO GREATER DURATION THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO
CIRCUMSTANCES SHALL CLARION BE LIABLE FOR ANY LOSS OR DAMAGE,
DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INABILITYTO USE THE PRODUCT.
ON
BECAUSE SOME STATES DO NOT ALLOW LIMITATIONS
LASTS OR EXCLUSIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.
YOU
THIS LIMITED WARRANTY GIVES
OTHER RIGHTS WHICH VARY FROM STATE TO
SHOULD
THE
WARRANTY PERIOD, PLEASE CALL OR VISIT OUR WEB SITE FOR A LISTINGOFAUTHORIZED
WARRANTY SERVICE CENTERS
CUSTOMER SERVICE
WITH CLARION PRODUCTS.
CLARION CORPORATION
661
WEST REDONDO BEACH BLVD.
GARDENA, CA 90247
ATTN: CUSTOMER SERVICE MANAGER