Citronic PD-45 Owner's Manual

Direct Drive Turntable
Direct Drive Turntable
Direct Drive Turntable
Direct Drive Turntable

Direct Drive Turntable

Ref. No: 170.519

170519 Manual 5/3/04 1:40 pm Page 1

Safety Warnings:

All the safety and operating instructions should be read before the
appliance is operated.
To prevent fire or shock hazard, do not expose this appliance to rain or
moisture.
To reduce the risk of electric shock, do not remove the cover (or back).
There are no serviceable parts inside. Always refer servicing to qualified
service personnel.

Cautionary Notes:

Care must be taken not to damage the power supply cord housing,
which could expose line parts and cause electric shock. When removing
from wall outlet, be sure to remove by holding the plug and not by
pulling the cord.
In order to prevent electric shock; do not open the top cover. If a
problem occurs, contact your dealer.
Do not place metal objects or spill liquid inside. Electric shock or
malfunction may result.

Any use of the controls, or any adjustment, or the performance of any
procedure other than those specified herein may result in serious
damage to your health.
The unit should not be opened or repaired by anyone except properly
qualified service personnel.
Double insulated - when servicing, use only identical replacement parts.

Check List

Check that the following parts are included in the package with the

main unit:

Instruction Manual
Counter Weight
Target light
Headshell
Platter
Slipmat
AC Cord
Connecting leads

2

Main Features

1) START/STOP

Dual start/stop buttons for normal or battle mode.

2) STROBE DOTS

These dots around the edge of the platter can be used to assess the
speed of rotation in conjunction with the strobe light (3). When the
dots are flowing to the right the speed is lower than the display
speed (33,45,78). When flowing to the left the speed is faster than
the display speed. When the strobe is static the platter is rotating
at the display speed.

3) POWER ON/OFF & STROBE LIGHT

On – rotate right
Off – rotate left

4) PLATTER SPEED

33rpm – press 33
45rpm – press 45
78rpm –press 33 & 45 together

5) TARGET LIGHT

Removable light giving illumination to the styli position

6) START SPEED

Rotary knob to adjust the starting speed of the Platter. Setting to
Max will give the fastest start-up time of 0.2~6 seconds. Setting to
minimum will allow the platter to increase to full speed gradually.

170519 Manual 5/3/04 1:40 pm Page 2