Cissell AGI44 Installation Manual
Gear Cabinet
TMB1274C
Starting Serial No. 0703014106
Through Serial No. 1103xxxxx
Refer to Page 3 for Model Identification
Installation/Operation
Keep These Instructions for Future Reference.
(If this machine changes ownership, this manual must accompany machine.)
www.comlaundry.com
Part No. FR00261R7
March 2011
FOR YOUR SAFETY, the information in
this manual must be followed to minimize
the risk of fire or explosion or to prevent
property damage, personal injury or
death.
W033
• Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
• WHAT TO DO IF YOU SMELL GAS:
– Do not try to light any appliance.
– Do not touch any electrical switch; do
not use any phone in your building.
– Clear the room, building or area of all
occupants.
– Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
– If you cannot reach your gas supplier,
call the fire department.
• Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
W052
WARNING
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
W053
POUR VOTRE SÉCURITÉ, les
informations de ce guide doivent être
respectées afin de réduire les risques
d’incendie, d’explosion ou d’éviter les
dommages matériels, personnels ou
blessures mortelles.
W033R3QU
AVERTISSEMENT
POUR VOTRE SÉCURITÉ
Ne pas entreposer ou utiliser d’essence
ou toutes autres vapeurs et liquides
inflammables à proximité de cette unité
ou de tout autre appareil.
W053R2QU
• Ne pas entreposer ou utiliser d’essence
ou toutes autres vapeurs et liquides
inflammables à proximité de cette
machine ou de tout autre appareil.
• QUE FAIRE EN CAS D’ODEUR DE GAZ :
– Ne pas mettre d’appareil en marche.
– Ne pas toucher aux interrupteurs
électriques ; ne pas utiliser le
téléphone des lieux.
– Évacuer la pièce, le bâtiment ou la
zone de tous les occupants.
– Appeler immédiatement le fournisseur
de gaz de la maison d’un voisin.
Respecter les instructions
communiquées par le fournisseur.
– Si vous ne pouvez pas joindre le
fournisseur de gaz, appeler le service
d’incendie.
• L’installation et l’entretien doivent être
effectués par un installateur, service
d’entretien qualifiés ou par le
fournisseur de gaz.
W052R5QU
FR00261
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
1
Table of
Contents
Introduction......................................................................................... 3
Model Identification ............................................................................. 3
Customer Service.................................................................................. 3
Serial Plate Location............................................................................. 3
Wiring Diagram .................................................................................... 3
Safety Information.............................................................................. 4
Important Safety Instructions ............................................................... 5
Installation........................................................................................... 7
Specifications and Dimensions............................................................. 7
Cabinet Dimensions and Drain Connection Locations.................... 8
Exhaust Outlet and Electrical Connection Locations ...................... 9
Pre-Installation Inspection .................................................................... 10
Location Requirements......................................................................... 10
Gear Cabinet Enclosure ........................................................................ 11
Position and Level the Gear Cabinet .................................................... 12
Gear Preparation .............................................................................. 12
Gear Rack Option ................................................................................. 13
Exhaust Requirements .......................................................................... 14
Layout .............................................................................................. 14
Make-Up Air.................................................................................... 14
Venting............................................................................................. 14
Electrical Requirements........................................................................ 15
Grounding Instructions .................................................................... 15
Operation............................................................................................. 16
DMP OPL Models ................................................................................ 16
General Operation............................................................................ 16
Description of the OPL Control Panel ............................................. 17
DMP OPL Features............................................................................... 18
Removing Gear Cabinet from Service.............................................. 19
Before You Call for Service ............................................................... 19
Customer Service.................................................................................. 19
© Copyright 2011, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any
means without the expressed written consent of the publisher.
2
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
FR00261
Introduction
Model Identification
Information in this manual is applicable to these
models.
.
AGC44
AGC45
AGC64
AGC65
AGC75
AGI44
AGI45
AGI64
AGI65
AGI75
AGU44
AGU45
AGU64
AGU65
AGU75
Customer Service
If literature or replacement parts are required, contact
the source from which the machine was purchased or
contact Alliance Laundry Systems at (920) 748-3950
for the name and address of the nearest authorized
parts distributor.
For technical assistance, call (920) 748-3121.
Serial Plate Location
When calling or writing for information about your
product, be sure to mention model and serial numbers.
Model and serial numbers are found on serial plate on
the right side of machine.
Wiring Diagram
The wiring diagram is located in the junction or
contactor box.
FR00261
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
3
Safety Information
Indicates an imminently hazardous
situation that, if not avoided, will cause
severe personal injury or death.
DANGER
Indicates a hazardous situation that, if not
avoided, could cause severe personal
injury or death.
WARNING
Indicates a hazardous situation that, if not
avoided, may cause minor or moderate
personal injury or property damage.
CAUTION
Failure to install, maintain, and/or operate
this machine according to manufacturer’s
instructions may result in conditions which
can produce serious injury, death and/or
property damage.
W051R1
WARNING
Precautionary statements (“DANGER,” “WARNING,”
and “CAUTION”) followed by specific instructions,
are found in this manual and on machine decals. These
precautions are intended for the personal safety of the
operator, user, servicer, and those maintaining the
machine.
NOTE: The WARNING and IMPORTANT
instructions appearing in this manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense, caution and carefulness are factors which
CANNOT be built into this gear cabinet. These
factors MUST BE supplied by the person(s)
installing, maintaining or operating the gear
cabinet.
Always contact your dealer, distributor, service agent
or the manufacturer on any problems or conditions you
do not understand.
Additional precautionary statements (“IMPORTANT”
and “NOTE”) are followed by specific instructions.
IMPORTANT: The word “IMPORTANT” is used
to inform the reader of specific procedures where
minor machine damage will occur if the procedure
is not followed.
NOTE: The word “NOTE” is used to communicate
installation, operation, maintenance or servicing
information that is important but not hazard
related.
4
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
FR00261
Save These Instructions
Hazardous Voltage. Can cause shock, burn
or cause death. Allow machine power to
remain off for two minutes prior to working
in and around AC inverter drive.
W359
WARNING
Safety Information
Important Safety Instructions
1. Read all instructions before using the gear
cabinet.
2. Refer to the Grounding Instructions for the
proper grounding of the gear cabinet.
3. Do not dry articles that have been previously
cleaned in, washed in, soaked in, or spotted with
gasoline, dry cleaning solvents, or other
flammable or explosive substances as they give
off vapors that could ignite or explode.
4. Do not allow children on or in the gear cabinet.
This appliance is not intended for use by young
children or infirm persons without supervision.
Young children should be supervised to ensure
that they do not play with the appliance.
5. Before the gear cabinet is removed from service
or discarded, remove the doors to the drying
compartment.
6. Do not install or store the gear cabinet where it
will be exposed to water and/or weather.
7. Do not tamper with the controls.
8. Do not repair or replace any part of the gear
cabinet, or attempt any servicing unless
specifically recommended in the usermaintenance instructions or in published userrepair instructions that you understand and have
the skills to carry out.
9. Do not use fabric softeners or products to
eliminate static unless recommended by the
manufacturer of the fabric softener or product.
10. To reduce the risk of fire, DO NOT DRY plastics
or articles containing foam rubber or similarly
textured rubberlike materials.
11. Keep area around the exhaust opening and
adjacent surrounding area free from the
accumulation of lint, dust, and dirt.
12. The interior of the gear cabinet and the exhaust
duct should be cleaned periodically by qualified
service personnel.
13. Do not put articles soiled with vegetable or
cooking oil in the gear cabinet, as these oils may
not be removed during washing. Due to the
remaining oil, the fabric may catch on fire by
itself.
14. To reduce the risk of fire, DO NOT put clothes
which have traces of any flammable substances
such as machine oil, flammable chemicals,
thinner, etc. or anything containing wax or
chemicals in the gear cabinet.
15. Use the gear cabinet only for its intended
purpose, drying water-washed fabrics.
16. ALWAYS disconnect the electrical power to the
gear cabinet before servicing. Disconnect power
by shutting off appropriate breaker or fuse.
17. Install this gear cabinet according to these
Installation Instructions. All connections for
electrical power and grounding must comply
with local codes and be made by licensed
personnel when required.
FR00261
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
5
Loading...