Cisco Systems WIC-1DSU-56K4 User Manual

Cisco − WIC−1DSU−56K4 Cable Specifications

Table of Contents

WIC−1DSU−56K4 Cable Specifications...........................................................................................................1
Document ID: 46794................................................................................................................................1
Introduction..........................................................................................................................................................1
Prerequisites.........................................................................................................................................................1
Requirements..........................................................................................................................................1
Components Used...................................................................................................................................1
Conventions............................................................................................................................................1
WIC−1DSU−56K4 WAN Interface Card............................................................................................................1
Cables...................................................................................................................................................................2
Connecting the 56/64 Kbps Card to the Network................................................................................................2
56/64 Kbps WAN Interface Card LEDs..............................................................................................................2
Related Information.............................................................................................................................................3
i
WIC−1DSU−56K4 Cable Specifications

Document ID: 46794

Introduction

Requirements

Components Used

Conventions

WIC−1DSU−56K4 WAN Interface Card
Cables
Connecting the 56/64 Kbps Card to the Network
56/64 Kbps WAN Interface Card LEDs
Related Information
Introduction
This document provides cable specifications for the WIC−1DSU−56K4 WAN interface card.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.
WIC−1DSU−56K4 WAN Interface Card
Cisco − WIC−1DSU−56K4 Cable Specifications

Cables

The 4−wire Channel Service Unit/Data Service Unit (CSU/DSU) module uses a standard straight−through RJ−45 cable to connect from the RJ−48S jack on the CSU/DSU to the wall jack.
Connector Pinout
RJ−48S Pin
1 2 7 8
Signal
Receive ring Receive tip Ring Tip

Connecting the 56/64 Kbps Card to the Network

This connection requires a straight−through RJ−48S−to−RJ−48S or a straight−through RJ−48C−to−RJ−48C cable.
Follow these steps:
Verify that the router is OFF.1.
Connect one end of the cable to the card's 56/64 kbps port.2.
Connect the other end of the cable to the 56/64 kbps services wall jack.3.

56/64 Kbps WAN Interface Card LEDs

The table below shows the different LEDs on the card and their meaning.
56/64 Kbps WAN Interface Card LEDs
LED
TD Data is being transmitted to the Data Terminal
RD LP The internal DSU/CSU is in loopback mode. Solid
Cisco − WIC−1DSU−56K4 Cable Specifications
Meaning
Equipment (DTE) interface.
Data is being received from the DTE interface.
illumination any time a loopback is active.
One of these alarm conditions is present: no receive
AL
CD The internal DSU/CSU in the WAN interface card is
signal, loss of frame signal from the remote station, or
out of service signal from the remote station. This LED
is off during normal operation.
communicating with another DSU/CSU.

Related Information

Understanding the 1−Port 4−Wire 56/64 Kpbs CSU/DSU WAN Interface Card
(WIC−1DSU−56K4)
Technical Support − Cisco Systems
All contents are Copyright © 1992−2005 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Updated: Jun 26, 2005 Document ID: 46794
Cisco − WIC−1DSU−56K4 Cable Specifications
Loading...