Cisco SPA100, SPA122 Quick Start Manual

Quick Start Guide

Cisco SPA100 Series Analog Telephone
Adapters

SPA112 Two Port Phone Adapter
SPA122 ATA with Router

Package Contents

• Analog Telephone Adapter

• Ethernet Cable

• Power Adapter

• Quick Start Guide

• Product CD-ROM

2 Cisco SPA100 Series Analog Telephone Adapters

Welcome

Thank you for choosing a Cisco SPA100 Series Analog Telephone Adapter.

This product family includes the following models:

• SPA112 Two-Port Phone Adapter: 2 FXS ports and 1 10/100 WAN
port.

• SPA122 ATA with Router: 2 FXS ports, 1 10/100 WAN port, 1 10/100
LAN port, and built-in router.

This guide describes how to physically install the equipment and how to
get started with the configuration.

Before You Begin

Before you begin the installation, make sure that you have the following
equipment and services:

• An active Internet account and Voice over IP account

• Ethernet cable to connect to your broadband network device

• Phone to connect to your SPA112/122

• Phone cable to connect your phone

• Optional: Uninterruptible Power Supply (UPS) to provide backup power

Product Features

Top Panel

1

2

Cisco SPA100 Series Analog Telephone Adapters 3

Back Panel

Feature Description

Phone 1
Phone 2

Steady green—On hook.
Slow flashing green—Off hook.
Off—Port not ready.

Internet

Flashing green—Transmitting or receiving data through

the WAN port.

Off—No link.

System

Steady green—System ready, IP address acquired.
Slow flashing green—Acquiring IP address. (By default,

uses DHCP.)

Fast flashing green—Upgrading firmware.
Off—No power or system can not boot up.

Feature Description

Reset Using a paperclip or similar object, press this button

briefly to restart the unit. Press and hold for 10
seconds to restore the factory default settings.

Phone 1,
Phone 2 (Gray)

Connect to an analog phone, using an RJ-11 phone
cable.

Ethernet (Yellow)

SPA122 Only

Can be used to connect to a device on your network,
such as a computer, using an Ethernet cable.

Internet (Blue) Connect to a broadband network device (DSL or

cable modem) or a network router, using an Ethernet
cable.

Power Connect to a power source, using the provided

power adapter.

4 Cisco SPA100 Series Analog Telephone Adapters

Connecting the Equipment

NOTE For wall-mounting instructions, see Mounting the ATA, page 9.

STEP 1 Connect one end of the provided Ethernet cable to the Internet

(Blue) port. Connect the other end directly to your broadband
network deviceConnect one end of a phone cable to the Phone1
(Gray) port. Connect the other end to your analog phone or fax

machine.

STEP 2 Connect one end of another phone cable to another analog phone

or fax machine. Connect the other end to the Phone 2 (Gray) port.

STEP 3 SPA122 Only: Optionally, connect one end of an Ethernet network

cable to the ETHERNET (Yellow) port of the ATA. Connect the other
end to a device on your network, such as a computer.

STEP 4 Connect the provided power adapter to the Power port.

3

239795

WAN