Cisco PDS2100 Series Safety Sheet

IMPORTANT SAFETY INSTRUCTIONS

Notice to Installers

The servicing instructions in this notice are for use by quali ed service
personnel only. To reduce the risk of electric shock, do not perform any
servicing other than that contained in the operating instructions, unless
you are quali ed to do so.

Note to System Installer

For this apparatus, the coaxial cable shield/screen shall be
grounded as close as practical to the point of entry of the cable
into the building.For products sold in the US and Canada, this
reminder is provided to call the system installer's attention to
Article 820-93 and Article 820-100 of the NEC (or Canadian
Electrical Code Part 1), which provides guidelines for proper
grounding of the coaxial cable shield.

This symbol is intended to alert you that uninsulated voltage
within this product may have sufficient magnitude to cause
electric shock.Therefore, it is dangerous to make any kind of
contact with any inside part of this product.

Ce symbole a pour but d’alerter toute personne qu’un contact
avec une pièce interne de ce produit, sous tension et non isolée,
pourrait être suffisant pour provoquer un choc électrique. Il est
donc dangereux d’être en contact avec toute pièce interne de
ce produit.

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near water.

6) Clean only with dry cloth.

7) Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.

8) Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.

9) Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding-type plug has two
blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided
plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.

10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.

11) Only use attachments/accessories specified by the
manufacturer.

12) Use only with the cart, stand, tripod, bracket, or

13) Unplug this apparatus during lightning storms or when

14) Refer all servicing to qualified service personnel. Servicing

Power Source Warning

A label on this product indicates the correct power source for this
product. Operate this product only from an electrical outlet with
the voltage and frequency indicated on the product label. If you are
uncertain of the type of power supply to your home or business, consult
your service provider or your local power company.

table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to

avoid injury from tip-over.

unused for long periods of time.

is required when the apparatus has been damaged in any
way, such as a power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.

CAUTION: To reduce the risk of electric shock, do not remove cover (or
back). No user-serviceable parts inside. Refer servicing to qualified
service personnel.

This symbol is intended to alert you of the presence of important
operating and maintenance (servicing) instructions in the literature
accompanying this product.

Ce symbole a pour but de vous avertir qu’une documentation
importante sur le fonctionnement et l’entretien accompagne ce produit.

WARNING

TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.

20080814_Installer820

The AC inlet on the unit must remain accessible and operable at all times.

Ground the Product

WARNING: Avoid electric shock and  re hazard! If this
product connects to coaxial cable wiring, be sure the cable
system is grounded (earthed). Grounding provides some
protection against voltage surges and built-up static charges.

WARNING: Avoid electric shock and  re hazard! Do not
locate an outside antenna system in the vicinity of overhead
power lines or power circuits. Touching power lines or circuits
might be fatal.

This product may contain a tuner capable of receiving o -the-air
broadcasts.

Protect the Product from Lightning

In addition to disconnecting the AC power from the wall outlet,
disconnect the signal inputs.

Verify the Power Source from the On/O Power Light

When the on/o power light is not illuminated, the apparatus may still
be connected to the power source. The light may go out when the
apparatus is turned o , regardless of whether it is still plugged into an
AC power source.

Eliminate AC Power/Mains Overloads

overload AC power/mains, outlets, extension cords, or integral
convenience receptacles. For products that require battery
power or other power sources to operate them, refer to the
operating instructions for those products.

Handling Disposable Batteries

This product may contain disposable batteries. Heed the following
warning and follow the Battery Safety and Battery Disposal
instructions below.

mishandled or incorrectly replaced. Replace only with the same
type of battery. Do not disassemble it or attempt to recharge it
outside the system. Do not crush, puncture, dispose of in  re,
short the external contacts, or expose to water or other liquids.
Dispose of the battery in accordance with local regulations and
instructions from your service provider.

Battery Safety

• Insert batteries correctly. There may be a risk of explosion if the
batteries are incorrectly inserted.

• Do not attempt to recharge ‘disposable’ or ‘non-reusable’ batteries.

• Please follow instructions provided for charging ‘rechargeable’
batteries.

• Replace batteries with the same or equivalent type that we
recommend.

• Do not expose batteries to excessive heat (such as sunlight or  re).

• Do not expose batteries to temperatures above 100°C (212°F).

Battery Disposal

• The batteries may contain substances that could be harmful to the
environment.

• Recycle or dispose of batteries in accordance with the battery
manufacturer’s instructions and local/national disposal and recycling
regulations.

• The batteries may contain perchlorate, a known hazardous
substance, so special handling and disposal of this product might
be necessary. For more information about perchlorate and best
management practices for perchlorate-containing substance, see

www.dtsc.ca.gov/hazardouswaste/perchlorate

Provide Ventilation and Select a Location

• Remove all packaging material before applying power to the product.

• Do not place this apparatus on a bed, sofa, rug, or similar surface.

• Do not place this apparatus on an unstable surface.

• Do not install this apparatus in an enclosure, such as a bookcase or

rack, unless the installation provides proper ventilation.

• Do not place entertainment devices (such as VCRs or DVDs), lamps,

books, vases with liquids, or other objects on top of this product.

• Do not block ventilation openings.

Operating Environment

This product is designed for operation indoors with a temperature range
from 32° to 104° F (0° to 40°C). Each product should have adequate
spacing on all sides so that the cooling air vents on the chassis are not
blocked.

WARNING: Avoid electric shock and  re hazard! Do not

WARNING: There is danger of explosion if the battery is

Protect from Exposure to Moisture and Foreign Objects

AUDIO IN

DVI/HDCP

L

WARNING: Avoid electric shock and  re hazard! Do not
expose this product to dripping or splashing liquids, rain, or
moisture. Objects  lled with liquids, such as vases, should not
be placed on this apparatus.

Connecting to an SDTV with RCA Cable

Back of Set-Top

CABLE OUT ETHERNETR

L S/PDIF

CVBS USB IR INCABLE IN

WARNING: Avoid electric shock and  re hazard! Unplug
this product before cleaning. Do not use a liquid cleaner or an
aerosol cleaner. Do not use a magnetic/static cleaning device
(dust remover) to clean this product.

WARNING: Avoid electric shock and  re hazard! Never
push objects through the openings in this product. Foreign
objects can cause electrical shorts that can result in electric
shock or  re.

Service Warnings

WARNING: Avoid electric shock! Do not open the cover
of this product. Opening or removing the cover may expose
you to dangerous voltages. If you open the cover, your warranty
will be void. This product contains no user-serviceable parts.

Check Product Safety

Upon completion of any service or repairs to this product, the service
technician must perform safety checks to determine that this product is
in proper operating condition.

Protect the Product When Moving It

Always disconnect the power source when moving the apparatus or
connecting or disconnecting cables.

20110316_Cable_Safety

Cisco PDS2100 Series Set-Top

Model: PDS2100 Series

Manufactured by:

Cisco Systems, Inc.

5030 Sugarloaf Parkway

Lawrenceville, Georgia 30044 USA

Telephone: [phone]

Notice to Consumers

The Cisco® PDS2100 Series Set-Top receives digital signals from your
service provider and delivers programs in standard de nition (SD) and
high de nition (HD) formats (720p and 1080i).

You must have an HDTV to display HD programming. Programming
must originate in HD format and be broadcast in HD format.

Please read the safety instructions before connecting your set-top.

Cable Input

Back of

SDTV

Y

SCART VIDEO IN

B

P

PR

AUDIO

VIDEO

IN

IN

RL

To Wall Jack

AUDIO

VIDEO

OUT

OUT

RF IN

RL

RF OUT

T15922

Connecting to an HDTV with HDMI Cable

Back of Set-Top

Cable Input

Back of

HDTV

CABLE OUTCABLE IN

S-VIDEO

VIDEO

AUDIO

L/
MONO

R

L S/PDIF

IN

ETHERNETR

CVBS USB IR IN

To Wall Jack

SCART VIDEO IN

SCART VIDEO OUT

VIDEO

Y

PBPRL

AUDIO

R

HD 1

IN

L/
MONO

R

HD 2

R

Y

PBPRL

HDMI

IN

ANT (75 )

ANT-1

AUDIO

OUT

R

ANT-2

INOUT

T15923

Open Source GNU GPL Statement

Cisco PDS2100 Series set-tops contain(s), in part, certain free/open
source software (“Free Software”) under licenses which generally make
the source code available for free copy, modi cation, and redistribution.
Examples of such licenses include all the licenses sponsored by the Free
Software Foundation (e.g. GNU General Public License (GPL), GNU Lesser
General Public License (LGPL), Berkeley Software Distribution (BSD), the
MIT licenses and di erent versions of the Mozilla and Apache licenses).
To  nd additional information regarding the Free Software, including a
copy of the applicable license and related information, please go to: (i)
for North America http://www.cisco.com/web/consumer/support/

open_source.html, or (ii) for outside North America http://www.cisco.
com/web/consumer/support/open_source.html#~international. Once

at the site, search for the product listing and click on the related items
identi ed. If you have any questions or problems accessing any of the links,
please contact: [e-mail].

Cisco Systems, Inc. http://www.cisco.com
170 West Tasman Drive Tel: [phone]

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its a liates in the U.S. and other countries. To view a list
of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks.

owners. The use of the word partner does not imply a partnership
relationship between Cisco and any other company. (1110R)

San Jose, CA 95134-1706 USA 800 553-6387

The terms HDMI and HDMI High-De nition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks
of HDMI Licensing LLC in the United States and other countries.
Other third party trademarks mentioned are the property of their respective

© 2013 Cisco and/or its a liates. All rights reserved.
April 2013 Part Number 78-20808-01 Rev B0