APPENDIX
B
Declarations of Conformity and Regulatory
Information
This appendix provides declarations of conformity and regulatory information for the Cisco Aironet
1400 Series Wireless Bridge.
This appendix contains the following sections:
• Manufacturers Federal Communication Commission Declaration of Conformity Statement, page
B-2
• Industry Canada, page B-3
• International Models, page B-3
• European Community: Ireland, page B-4
• Declaration of Conformity for RF Exposure, page B-5
• Administrative Rules for Cisco Aironet Bridges in Taiwan, page B-6
• Operation of Cisco Aironet Bridges in Brazil, page B-7
OL-4072-04
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
B-1
Appendix B Declarations of Conformity and Regulatory Information
Manufacturers Federal Communication Commission Declaration of Conformity Statement
Manufacturers Federal Communication Commission
Declaration of Conformity Statement
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
Models: AIR-BR1410A-A-K9
AIR-BR-1410-A-A-K9-N
FCC Certification number: LDK 102047
LDK 102047P
Manufacturer: Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician.
Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this
frequency when using integrated antennas or those listed in Tab l e B-1. Any changes or modification to
the product not expressly approved by Cisco could void the user’s authority to operate this device.
B-2
Caution To meet regulatory restrictions, the bridge with the antenna connector and the external antenna must be
be professionally installed.
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
OL-4072-04
Appendix B Declarations of Conformity and Regulatory Information
Table B-1 External 5.8-GHz Antennas
Cisco Part Number Model Gain
AIR-ANT58G9VOA-NAironet Vertically polarized
AIR-ANT58G10SSA-NAironet Sector 9.5 dBi
AIR-ANT58G28SDA-NAironet Dish 28 dBi
Industry Canada
Canadian Compliance Statement
This Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing
Equipment Regulations.
Industry Canada
9 dBi
omnidirectional
Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material broilleur du
Canada.
This device complies with Class B Limits of Industry Canada. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Cisco’s 54-Mbps, 5.8-GHz bridges are certified to the requirements of RSS-210 issue 5, RSP 100, and
RSS 102 for 5-GHz spread spectrum devices.
International Models
The international bridge models are listed in Tab le B-2 .
Table B-2 International Bridge Models
Models Regulatory Region
AIR-BR1410A-E-K9 Europe
AIR-BR1410A-K-K9 Korea
AIR-BR1410A-Z-K9 New Zealand
OL-4072-04
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
B-3