Cisco Linksys RV042 Setup Manual
Linksys RV042 Setup
Note
1. Obtain the following information from your internet service provider:
•IP address
•Subnet mask
•Default gateway
• DNS server address(es).
2. Connect port 1 of the VPN router to the elevator LAN (typically to an available port on
the LAN switch of the iCentral).
• Linksys RV042 Setup
VPN Router Setup
If the iCentral contains a hub instead of a switch, connect the cable to the last
available port on the hub and make sure the switch is in the “uplink” or “crossover” position.) You should see a light on both the VPN router and the LAN switch for the
connected ports.
3. Connect an Ethernet cable from an available port of your DSL/Cable Modem to the
Internet port of the VPN router.
4. Connect the included AC power adapter to the VPN router and plug it in.
Instruction # 42-IS-0160, Rev A1. Copyright 2008, Motion Control Engineering.
1
5. Using the iView computer, go to Start > Control Panel > Networ k connections. Right
click the LAN Ethernet connection and click Properties.
6. Double-click on Internet Protocol (TCP/IP). Write down your current IP settings.
You will need to re-enter them in a later step.
7. Click the radio button marked Obtain IP address automatically.
8. Click OK, then click OK again to return to the network connections screen.
9. Click Start > Programs > Internet Explorer.
2 Instruction # 42-IS-0160, Rev A1
Loading...