Cisco Unified IP Phone Documentation Guide for
Cisco Unified Communications Manager 8.0(1)
Published: February 2, 2010
This guide describes the documents for installing, configuring, administering, and using
Cisco Unified IP Phones 3900, 6900, 7900, 8900, and 9900 for the following:
The Cisco Unified IP Phone series, such as for the Cisco Unified IP Phone 7900 Series, are shown under
the following tabs that you can see on the left side of the website:
• General Information Documents, page 3
• Reference Guides > Technical References, page 4
• Design > Design Guides, page 4
• Install and Upgrade > Install and Upgrade Guides, page 4
• Configure Guides > Programming Guides, page 5
• Maintain and Operate Guides > End-User Guides, page 5
• Maintain and Operate > Maintain and Operate Guides, page 8
• Training Resources, page 9
• Translated Documents, page 9
If no documents exist that would fall under a particular category, you will not see the tab on the left side
of the website. Also, some of the documents within these categories are maintained by other groups, such
as Marketing and Customer Advocacy, such as the troubleshooting tech notes under Troubleshoot and
Alerts.
This documentation guide focuses on the Cisco Unified IP Phone user documents that Cisco Technical
Documentation produces.
The guides are listed here in the order of the tabs shown above.
Cisco Unified IP Phone Documentation Guide for Cisco Unified Communications Manager 8.0(1)
2
OL-21542-01
General Information Documents
This section lists the most recent Cisco Unified IP Phone documents under the General Information
section:
• Documentation Roadmaps, page 3
• Licensing Information, page 3
• Release Notes, page 3
Documentation Roadmaps
These guides describe the documentation sets for a Cisco Unified IP Phones series and for
Cisco Unified CM.
• Documentation guide for a Cisco Unified IP Phone series. You can find this guide under General
Information > Documentation Roadmaps for each IP Phone series: 9900, 8900, 7900, 6900,
and 3900.