Data Sheet
Cisco Video Surveillance 2630V IP Dome
The Cisco® Video Surveillance 2630V IP Dome is a feature-rich digital camera designed to provide superior
performance in a wide variety of video surveillance applications and environments. The camera employs H.264
compression of up to 30 frames per second (fps) at D1 NTSC resolution (720 x 480) or 25 fps at D1 PAL resolution
(720 x 576), offering efficient network utilization while providing high-quality video. This vandal-resistant dome can be
deployed indoors or outdoors. With its open, standards-based design, the camera provides an ideal platform for
operation as an independent device or as part of a Cisco Video Surveillance network.
Figure 1 shows the Cisco Video Surveillance 2630V IP Dome.
Figure 1. Cisco Video Surveillance 2630V IP Dome
The Cisco Video Surveillance 2630V IP Dome offers a variety of benefits, including:
●
Optimal imaging efficiency. The 2630V IP Dome can stream video using H.264 compression, reducing
network traffic and storage requirements while providing superior image quality.
●
Motorized focus and zoom. The lens on the 2630V IP Dome allows the focus and zoom to be controlled
remotely, greatly simplifying installations and field of view adjustments.
●
Wide dynamic range. The camera employs powerful digital imaging technology, allowing it to capture highquality images in a wide variety of indoor and outdoor lighting conditions. It uses a progressive scan image
sensor with global electronic shuttering to ensure natural color rendition, zero blooming and smear, and
minimal motion blurring.
●
Dual streaming. The camera can deliver two simultaneous video streams over the network. A combination of
H.264, MPEG4, and MJPEG can be configured. Each video stream can be configured with individual
resolution, quality, and frame rate settings.
●
Outdoor mounting options. When used outdoors, the camera must be mounted using a separate conduit
base accessory (CIVS-IPCA-1006=) or pendant cap accessory (CIVS-IPCA-1010=) for IP66 protection. The
camera is equipped with a motorized varifocal motorized lens mounted to a manual pan and tilt mechanism
that allows the camera to be rotated and placed at the proper angle.
●
Dome options. The 2630V IP Dome comes standard with a clear dome. A smoked dome is available as an
optional accessory.
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 1 of 1
Data Sheet
●
Day/night operation. The camera provides true day/night operation and includes an IR filter that switches to
night mode in low-light scenes. This function can be set to manual or automatic control.
●
Fan/heater operation. The camera includes a fan and heater unit that automatically maintains a desirable
internal temperature, allowing the camera to operate in outdoor conditions.
●
Embedded security and networking. The camera provides 802.1X authentication and supports IP Multicast
for enhanced bandwidth management.
●
Event notification. The camera can examine designated areas in the video for motion activity and then notify
users or other applications when it detects activity that exceeds a predefined threshold.
●
Bidirectional audio.* The camera supports full-duplex audio, and options for half-duplex operation.
Note: Features with an asterisk are not supported or applicable when the camera is used with Cisco Video
Surveillance Manager.
Features
Table 1 describes the features of the Cisco Video Surveillance 2630V IP Dome.
Table 1. Cisco Video Surveillance 2630V IP Dome Features
Item Specification
Imaging Device 1/3-in. progressive-scanRGB CMOSsensor with wide dynamic range
Image Control Automatic white balance (AWB), automatic gain control (AGC), automatic exposure (AE), auto iris
Dynamic Range 102 dBtypical/120 dB maximum
Minimum Illumination
Signal-to-Noise Ratio (SNR) >48 dB
Shutter Electronic shutter
Lens Motorized DC auto-iris lens with day/night filter
Camera Angle Adjustment Pan: 340°
Video Compression H.264, MPEG-4, MJPEG
Audio Compression* G.711 A-Law, G.711 U-Law, G.726
Resolution and Frame Rate NTSC/PAL
Video Streaming Single and dual video streams supported. Refer to Tables 2, 3, and 4 for details.
Protocols Dynamic Host Control Protocol (DHCP), File Transfer Protocol (FTP), Hypertext Transfer Protocol (HTTP), Secure
Quality of Service (QoS) Differentiated services code point (DSCP) marking
Power Power 24 VAC, isolated external power supply
Power Consumption 15W (maximum)
●
Color mode: F1.4 @ 0.65 lux
●
Black and white mode: F1.4 @ 0.08 lux
3.3mm–12mm
Zoom: 3.6x
Field of view:
●
Horizontal: 24°–90°
●
Vertical: 18°–64°
Tilt: 160°
Rotation: 200°
●
720 x 480/576 @ 30/25 fps (D1)
●
704 x 480/576 @ 30/25 fps (4CIF)
●
352 x 240/288 @ 30/25 fps (CIF)
HTTP (HTTPS), Network Time Protocol (NTP), Real-Time Transport Protocol (RTP), Real-Time Streaming
Protocol (RTSP), Simple Mail Transfer Protocol (SMTP), Secure Sockets Layer/Transport Layer Security
(SSL/TLS), Transmission Control Protocol/Internet Protocol (TCP/IP), 802.1x
When heater is on: 35W (maximum)
* Not supported or applicable when the camera is used with Cisco Video Surveillance Manager.
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 2 of 6
Table 2 lists supported single stream configurations on the Cisco Video Surveillance 2630V IP Dome.
Table 2. Supported Single Stream Configurations
Data Sheet
Single
Streaming
H.264 D1 @ 30 fps D1
MPEG-4 D1 @ 30 fps D1
MJPEG D1 @ 30 fps D1
Maximum Resolution and
Frames Per Second (FPS)
Resolutions Supported (NTSC
& PAL)
4CIF
CIF
4CIF
CIF
4CIF
CIF
NTSC FPS Supported PAL FPS Supported
30, 25, 20, 15, 10, 8, 6, 5 25, 20, 15, 10, 8, 6, 5
30, 25, 20, 15, 10, 8, 6, 5 25, 20, 15, 10, 8, 6, 5
30, 25, 20, 15, 10, 8, 6, 5 25, 20, 15, 10, 8, 6, 5
Table 3 lists the supported primary and secondary video stream combinations on the Cisco Video Surveillance
2630V IP Dome.
Table 3. Supported Primary and Secondary Video Stream Combinations
Primary Secondary
H.264 H.264
H.264 MJPEG
MPEG4 MPEG4
MPEG4 MJPEG
Table 4 lists the supported primary and secondary video streams on the Cisco Video Surveillance 2630V IP Dome.
Table 4. Cisco Video Surveillance 2630V IP Dome Video Stream Support
NTSC Primary Channel
Resolutions
4 CIF, CIF 30, 25, 20, 15, 10, 8, 6, 5 CIF 15, 10, 8, 6, 5
PAL Primary Channel
Resolutions
4 CIF, CIF 25, 20, 15, 10, 8, 6, 5 CIF 15, 10, 8, 6, 5
NTSC Primary Frame Rate NTSC Secondary Channel
Resolutions
PAL Primary Frame Rate PAL Secondary Channel
Resolutions
NTSC Secondary Frame Rate*
PAL Secondary Frame Rate*
* If a secondary frame rate is selected in Cisco Video Surveillance Manager that is not listed in the table, the camera will
automatically use the closest frame rate.
Connectors
Table 5 describes the connectors on the Cisco Video Surveillance 2630V IP Dome.
Table 5. Cisco Video Surveillance 2630V IP Dome Connectors
Item Specification
Network Connectivity 10/100 BASE-TX Ethernet with RJ-45 connector
Video 3.5-mm service connector, provides analog video (use with optional mini cable with BNC adapter during installation)
Audio*
Alarm Input Two logic-level programmable inputs
Alarm Output* Two logic-level programmable outputs
Power Input 3-pin terminal
* Not supported or applicable when the camera is used with Cisco Video Surveillance Manager.
●
3.5-mm audio jack: audio input for optional external microphone and audio output for optional external speaker
supported through Y-cable adapter
●
Two-way (full- or half-duplex), one-way, or audio off
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 3 of 6
Software
Table 6 describes the primary features of the Cisco Video Surveillance 2630V IP Dome software.
Table 6. Cisco Video Surveillance 2630V IP Dome Primary Software Features
Item Specification
Video Format NTSC and PAL
Day/night Settings Auto or manual day/night operation with user-definable thresholds
Image Settings Configurable brightness, sharpness, saturation, and white balance
Overlay Capabilities Time, date, and text
Selectable Bit Rate Support for Constant Bit Rate or Variable Bit Rate
IP Filtering Users can enter a list of allowed or blocked IP addresses for viewing video and configuring camera settings
Discovery* Cisco Discovery Protocol, Bonjour zero-configuration discovery
Configuration
Motion Detection 4 user-definable motion detection areas
Event Actions
* Not supported or applicable when the camera is used with Cisco Video Surveillance Manager.
●
Browser-based using Internet Explorer 8 with SP3
●
Multiple user access levels with password protection
●
Email
●
FTP upload of captured video or JPEG snapshot depending on stream configuration
●
HTTP alert
●
Alarm output
Data Sheet
Specifications
Table 7 provides specifications of the Cisco Video Surveillance 2630V IP Dome.
Table 7. Cisco Video Surveillance 2630V IP Dome Mechanical Specifications
Item Specification
Housing Metal base and polycarbonate transparent cover with tamper-resistant mounting
LEDs Power and Ethernet
Dimensions
(W x H)
Weight 3.1 lb
Standards Compliance Safety:
Operating Temperature –30° to 55°C
Heater and Fan Heater turns ON: Internal temperature falls below 5°C (41°F)
6.10 x 4.64 in.
155 x 118 mm
1.4 kg
EMC-Emissions:
UL 60950
CAN/CSA-C22.2 No. 60950
EN 60950
IEC 60950
AS/NZS 60950
–22° to 131°F
Heater turns OFF: Internal temperature rises above 15°C (59°F)
Fan turns ON: Internal temperature rises above 70°C (158°F)
Fan turns OFF: Internal temperature falls below 60°C (140°F)
47CFR Part 15 (CFR 47) Class B
AS/NZS CISPR22 Class B
CISPR22 Class B
EN55022 Class B
ICES003 Class B
VCCI Class B
EN61000-3-2
EN61000-3-3
KN22 Class B
CNS13438 Class B
EMC-Immunity:
EN55024
CISPR24
EN50130-4
KN24
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 4 of 6
Figure 2 shows the dimensions of the Cisco Video Surveillance 2630V IP Dome without the conduit case.
Figure 2. Cisco Video Surveillance 2630V IP Dome Dimensions Without Included Conduit Case
Data Sheet
Package Contents
Table 8 describes the items that ship with the Cisco Video Surveillance 2630V IP Dome.
Table 8. Cisco Video Surveillance 2630V IP Dome Package Contents
Item
Cisco Video Surveillance 2630VIP Dome
Quick start guide
Regulatory compliance and safety information
●
Mounting template
●
0.9-mm Allen wrench for locking/unlocking the lens focus ring
●
Torx security wrench for tamper-resistance screws
●
8-32 x 5/16" screws (qty. 4)
●
Security wire and screw
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 5 of 6
Availability
The Cisco Video Surveillance 2630V IP Dome is available through Cisco Authorized Distributors.
Ordering Information
Table 9 lists the part numbers for the Cisco Video Surveillance 2630V IP Dome and accessories.
Table 9. Cisco Video Surveillance 2630V IP Dome Ordering Information
Part Number Description
CIVS-IPC-2630V Indoor/Outdoor Cisco Standard-Definition IP Clear Dome, D/N, 2.8–10 mm, vandal-resistant
Accessories
CIVS-IPCA-1004= Dome, Clear, 2500 and 2600 Series
CIVS-IPCA-1005= Dome, Smoked, 2500 and 2600 Series
CIVS-IPCA-1006= Conduit base with extra gaskets, 2500 and 26xxV Series
CIVS-IPCA-1007= Ceiling mount support
CIVS-IPCA-1010= Pendant cap, 2500 and 26xxV Series
CIVS-IPCA-1011= Wall mount for use with CIVS-IPCA-1010
CIVS-IPCA-1012= Ceiling mount for use with CIVS-IPCA-1010
CIVS-IPCA-1013= Pendant cap adapter (3/4" to 1.5" male NPT thread)
CIVS-IPCA-1014= Round pole mount adapter for use with wall mount
CIVS-IPCA-1017= Audio/video cables
CIVS-IPCA-1018= Sun shield
Data Sheet
Using the Camera with Cisco Video Surveillance Manager
Features that are marked with an asterisk (*) are not supported when using the camera with Cisco Video
Surveillance Manager. Please refer to the latest release notes for Cisco Video Surveillance Manager for more
information.
Service and Support
Cisco offers a wide range of services programs to accelerate customer success. These innovative programs are
delivered through a unique combination of people, processes, tools, and partners, resulting in high levels of
customer satisfaction. Cisco services help you to protect your network investment, optimize network operations, and
prepare your network for new applications to extend network intelligence and the power of your business. For more
information about Cisco services, visit
Cisco Technical Support Services or Cisco Advanced Services.
For More Information
For more information about Cisco Video Surveillance solutions, visit
http://www.cisco.com/en/US/products/ps6712/index.html or contact your local account representative.
Printed in USA C78-635608-02 03/11
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 6 of 6
Loading...