Cine Gears 1000TT User Manual

MANUAL BOOK

Product Name:Wireless HD/SDI video transmission system with TALLY and TALKBACK

Model Name:1000tt

Manufacture:ShenZhen LanGi Technology Co. LTD

Contents

Cautions

2

Wireless Video Transmission Systems

Product Features

Specifications

Transmitter
Receiver

User Manual

Setting Up the Unit
Setting Up the Intercom
Setting Transmission Output Power

3

4
5

7
9

11
11

13
13

Channel Settings 14
Turning Fan On/Off

Troubleshooting

14
15

Disclaimers

17

1

Cautions

Warning

Please read this user introduction manual to become familiar with the features before operation.
Failure to operate the product correctly can result in damage to the product,
or interference with other devices. This is a sophisticated product which must be operated with caution and
common sense. Failure to operate this product properly might result in disturbing other film equipment on set.
This product is not intended for use by children without direct adult supervision. Do not use with incompatible
components, or alter this product in any way outside of the documents provided by. These safety guidelines
contain instructions for installation, operation, and maintenance. It is essential to read and follow all of the
instruction in the manual, and all the notices and warnings regarding series products prior to assembly, setup,
or use to prevent any damage or interference.

1. Do not use this product in extreme heat, cold, dusty, or humid environments.

2. Prevent friction against hard objects.

3. Prevent jarring, such as from falling from high places, or from improper packaging during transportation.

4. These products are not waterproof; prevent moisture from getting in, on, or around the unit(s).

5. Do not dismantle, assemble, or otherwise alter the product(s) arbitrarily.

Electrical Considerations

1. When this device is sharing a power supply or battery with other equipment, please make sure all signal
and power cables are well connected before turning on the unit power.

2. When this device is sharing a power supply or battery with other equipment, please make cables from the
unit.

3. When this device is sharing a power supply or battery with other equipment, please check the polarity of
the power connectors of all equipment to ensure the inside conductor is positive. If the polarity of the power
connector is unknown, please check the user manual to make sure the outer conductor of the SDI or HDMI
connector is connected to the negative of the power supply. Otherwise, the equipment will not be able to
share the same power supply with the unit.

2

Product Features

Transmits 10-bit color, YCbCr, 4:2:2 color depth, proprietary color matching algorithm on OFDM
chips.

Optimized uncompressed 10-bit 4:2:2 2GBps video stream, or 12-bit 4:4:4 3GBPs wireless video
transmission on other models.

Optimized video processor for on-screen movement.
Fully supports all audio formats.
Static channel selection. The channel number and frequency can be modified by software to avoid

interference from other devices. Supports multiple receivers and AES 128 bit video encryption.
FPGA technology adopting American IRTA programmable logic matrix chips.
Follows the international film association time code protocols. Accurate time code extraction,

transmission, and encryption using embedded time code transmission method. Hardware
encrypted time code to IRTA chips.

Software allows user to adjust transmission output power to avoid interference.
Uses a separate channel to transmit tally information. Fully supports different intercom interfaces.
Integrated wireless intercom feature supports up to 300 meters for microphone and speakers.

4

Specifications

Transmitter SPECIFICATION

Frequency

Low band: 5190 and 5230MHz
High band: 5755 and 5795MHz

2.4-2.483GHz with ISM band

Modulation method and
Bandwidth

OFDM/40MHz for video
GFSK/1MHz for intercom system
1080p 23.98/24/25/30/50/60

1080psf 23.98/24/25

Video Formats

1080i 50/59.94/60

Supported

720p 50/59.94/60
576p 576i 480p 480i

Audio Formats

PCM, DTS-HD, Dolby TrueHD

Supported
Time Code SMPTE-12M
Transmission Range 2500ft(Line of sight)

Transmitter

External Antenna 5G × 2pcs

Antenna

External Antenna 2.4G x1pcs

Transmission Power 18dBm

HDMI Input; SDI Input; SDI Loop Output; Mini
USB; LEMO Power IN; Antenna RPSMA

Functional Interface

Socket; Power ON/OFF,3.5mm HP/MIC socket
TALLY output for Wrist

Mounting Structure 1/4” Hot-shoe connection

Channel Info; Video status; Battery capacity;

OLED Display

Status Menu, Audio Volume

Power Source 9-18V for DC input, V-Mount or G-Mount

battery (depending on the model)

Power Consumption 7.5-8.5W

5

Specifications

Net Weight(with

400g

antenna)
Temperature

-10-40º (Operating); -40-80º (Storage)
Receiver

External Antenna for 5G × 5pcs

Antenna

External Antenna for 2G x1pcs

Receiving Sensitivity -70dBm

SDI Dual Output; HDMI Output; Mini USB;
LEMO Power IN; Antenna RPSMA Socket;

Functional Interface

Power ON/OFF, 3.5mm HP/MIC socket;3.5mm
TALLY socket; LEMO 6 needle

Locating Structure 1/4” Hot-shoe connection

Channel Info; Signal Strength; Power Info;

OLED Display

TALLY indicator

Power Source 9-18V for DC input; V-Mount or G-Mount

battery (depending on the model)
Power Consumption 7.5-8.5W
Net Weight(with

800g
antenna)

Temperature

-10-40º (Operating); -40-80º (Storage)

6