CINEGEARS 1000M User Manual

GHOST EYE WIRELESS HDMI/SDI VIDEO TRANSMISSION SYSTEM

GHOST EYE

1000M

MANUAL BOOK

Trademarks

Ghost-Eye Wireless Video Transmission SystemsTM are trademarks of Cine Gears Inc. Web Interface.

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability, Cine Gears Inc. reserves the right to make changes to the products described in this document without notice. Cine Gears Inc. does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.

FCC Compliance Notice: Radio Frequency Notice

The device has met the FCC 15.247 requirement. In order to comply with the FCC RF exposure requirement, the user must keep 20cm away from the antenna. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Information to the user

The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. In cases where the manual is provided only in a form other than paper, such as on a computer disk or over the Internet, the information required by this section may be included in the manual in that alternative form, provided the user can reasonably be expected to have the capability to access information in that form.

Contents

Cautions

Ghost Eye Wireless Video Transmission Systems

Specifications

Transmitter Receiver

Installation

Transmitter

Receiver LCD Screen

User Manual

Troubleshooting

Disclaimers

About Cinegears

5 7

9 11 13

Cautions

Warning

Please read this user introduction manual to become familiar with the features of the Ghost-Eye series products before operation. Failure to operate the product correctly can result in disturbing other film equipment on set. This product is not intended for use by children without direct adult supervision. Do not use with incompatible components, or alter this product in any way outside of the documents provided by Cinegears. These safety guidelines contain instructions for installation, operation, and maintenance. It is essential to read and follow all of the instructions in the manual, and all the notices and warnings regarding Ghost Eye series products prior to assembly, set up, or use to prevent any damage or interference.

1. Do not use this product in extreme heat, cold, humidity, or environments with dust.

2. Do not drop the unit or cause impact against hard surfaces.

3. These products are not waterproof: do not expose the units to moisture.

4. Do not dismantle, assemble, or otherwise alter the products.

Electrical Considerations

1. When this device is sharing a power supply or battery with other equipment, please ensure all signal and power cables are well connected before turning on the Ghost Eye units' power.

2. When this device is sharing a power supply or battery with other equipment, please ensure the power switch is turned off before connecting or disconnecting any signal or power cables from the Ghost Eye units.

3. When this device is sharing a power supply or battery with other equipment, please check the polarity of the power connectors of all equipment to ensure the inside conductor is positive. If the polarity of wer connectors of all equipment to ensure the inside conductor is positive. If the polarity of the power connector is unknown, please check the user manual to make sure the outer conductor of the SDI or HDMI connector is connected to the negative of the power supply. Otherwise, the quipment will not be able to share the same power supply with the Ghost Eye unit.

Ghost Eye HD Wireless Video Transmission Systems

Here at Cinegears, we supply some of the best wireless HD video transmitters and receivers available. During the development of the Ghost Eye line of products, we subjected our prototypes to rigorous testing on set with professional film crews, and took customer feedback and suggestions into serious consideration. After careful review, the Ghost Eye products have integrated all of the in-demand wireless video transmission features recommended by you, the user. The fruit of our efforts are catalogued below in the form of our unique Ghost Eye Wireless Video Transmission Kits, across the affordable price range spectrum.

Ghost Eye Wireless Video Transmission Kits each fit a different set of wireless HD video transmission needs. The most powerful video transmitters and receivers will satisfy even the most high-end professional film crew, and our lightweight models fit a more versatile brand of film set. Ghost Eye transmission kits transmit and receive 10-bit 4:4:4 video, support both HD and SD, and can broadcast with under 1 millisecond of latency.

Frequency

5.1-5.9(GHz)

Bandwidth

40MHz

Supported

Time Code

SMPTE-12M

Transmitter

Specifications

Specification

ITEM Specification

Video Formats Supported

1080p 23.98/24/25/30/50/60 1080i 50/59.94/60 720p 50/59.94/60 576p 576i 480p 480i

Audio Formats

Transmission range 1000m(MAX)

Antenna External Antenna x 2 pcs

Transmission power 18dbm

Functional Interface

Locating Structure 1/4” Hot-shoe connection

LCD Screen Wireless Channel Info; SDI/HDMI Signal Info

Working Voltage 9V-18V

Power Consumption 9W

Dimensions 142.5 x 76 x 24.3 mm

Temperature

Antenna External Antenna x 5pcs

Receiving sensitivity -70dBm

Functional Interface

Locating Structure 1/4” Hot-shoe connection; V-Mount

LCD Screen Wireless Channel Info; SDI/HDMI Signal Info

Working Voltage 9V-18V

Power Consumption 7-8W

Dimensions 169.5 x 122 x 25.2 mm

Temperature

PCM, DTS-HD, Dolby TrueHD

HDMI Input; SDI Input; SDI Loop Output; Mini USB; LEMO Power IN; Antenna RPSMA Socket; Power ON/OFF

-10~60# (operating) 10%-90% humidity; -40~80# (storage) 10%-90% humidity.

Receiver

SDI Dual Output; HDMI Output; Mini USB; LEMO Power IN; Antenna RPSMA Socket; Power ON/OFF

-10~60# (operating) 10%-90% humidity; -40~80# (storage) 10%-90% humidity.

*Since the product’s improving process, all the performance, design and specifications of our products are subject to minor change without prior notice.

Transmitter

Structure & Interface

Transmitter SH700M

+ 16 hidden pages

CINEGEARS 1000M User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual