CHIEF OXCM1U, OLCM2X1U Installation Instructions Manual
I N S T A L L A T I O N I N S T R U C T I O N S
Extra Large Outdoor Floor/Ceiling Mount
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
OXCM1U
OXCM1U Installation Instructions
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located within the mounting system of the
OXCM1U mounts does not exceed 250 lbs (113.4 kg).
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
DEFINITIONS
MOUNTING SYSTEM: A MOUNTING SYSTEM is the
primary Chief product to which an accessory and/or component
is attached.
ACCESSORY: AN ACCESSORY is the secondary Chief
product which is attached to a primary Chief product, and may
have a component attached or setting on it.
COMPONENT: A COMPONENT is an audiovisual item
designed to be attached or resting on an accessory or mounting
system such as a video camera, CPU, screen, display,
projector, etc.
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Use this mounting system with other outdoor
products only.
WARNING: Always use two people or a mechanical lifting
device to safely lift and position equipment.
NOTE: The OXCM1U flat panel floor/ceiling mounts are
intended to be used with UL Listed ODAC Series
columns (not included): ODAC0203, ODAC0304,
ODAC0405, ODAC0506, ODAC0708.
--SAVE THESE INSTRUCTIONS--
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all mounting systems
are properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this mounting system can result in serious personal injury
or damage to equipment! It is the installer’s responsibility to
make sure the structure to which this mounting system is
attached can support five times the combined weight of all
equipment. Reinforce the structure as required before
installing the mounting system.
2
Installation Instructions OXCM1U
DIMENSIONS
+5°AND -15°
HOLE LOCKOUT
0° HOLE
LOCKOUT
+7.6° HOLE
LOCKOUT
-10° HOLE
LOCKOUT
2.48
63.0
1.91
48.4
-5° AND -20°
HOLE LOCKOUT
- 10°
DIMENSIONS: INCHES
[MILLIMETERS]
3
OXCM1U Installation Instructions
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Drill Hole
Perforar
Bohrloch
Fazer furo
Praticare un foro
Gat boren
Percez un trou
Adjust
Ajustar
Einstellen
Ajustar
Regolare
Afstellen
Ajuster
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
By Hand
A mano
Von Hand
Com a mão
A mano
Met de hand
À la main
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
Remove
Quitar
Entfernen
Remover
Rimuovere
Verwijderen
Retirez
Optional
Opcional
Optional
Opcional
Opzionale
Optie
En option
Security Wrench
Llave de seguridad
Sicherheitsschlüssel
Chave de segurança
Chiave di sicurezza
Veiligheidssleutel
Clé de sécurité
4
Installation Instructions OXCM1U
TOOLS REQUIRED FOR INSTALLATION
PARTS
#2
[Interface Bracket Hardware Kit]
A (4)
M6x16mm
E (4)
.750x.323x.250
B (4)
M6x25mm
H (2)
[Mount assembly]
.750x.344x.500
F (4)
C (4)
M8x20mm
G (4)
5/16"
1/2”
9/16”
3/8"
D (4)
M8x30mm
[Box-column Hardware Kit] - (2) - (qty. per bag)
5/32” (included)
[Interface Lockout Bag] - (2) - (qty. per bag)
M (1)
#10-24 x 1/2"
Q (1)
1/4-20
N (1)
1/4-20 x 2"
R (1)
5/16-18
S (2)
5/16"
P (1)
5/16-18 x 2"
T (2)
1/4"
J (2)
[Side wind shield]
[Center wind shield]
[Interface bracket]
FF (1)
[X-large adapter]
K (1)
X (2)
1/4-20 x 1 1/4"
[Wind shield connector]
GG (2)
[Side cover]
BB (4)
5/16-18
HH (4)
U (2)
3/8-16 x 4"
Y (4)
5/16 x 5/8"
CC (8)
5/16"
V (2)
3/8-16
Z (16)
1/4-20 x 5/8"
DD (16)
1/4"
JJ (1)
[X-large rail]
W (4)
3/8"
AA (4)
1/4 x 3/4"
EE (1)
5/32"
5
Loading...