Page 1
INSTALLATION INSTRUCTIONS
1
2
x 4
MODEL: HB-95C Custom Projector Bracket
Unpack carton and verify contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
PARTS
(1) BRACKET, Custom HB (4) WASHER, Flat, M12
(4) NUT, Flange, Hex, 5/16-18 (4) SCREW, Hex Head Cap Screw, M12 x 20mm
Figure 1
INSTALLATION
WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL INJURY! All components must be securely fastened
to each other and to the ceiling, and the ceiling must be capable of supporting five times the total weight of the installation.
1. Lower custom HB bracket onto top of projector. Ensure that triangle in bracket points toward front of projector. (See Figure 1)
2. Attach HB bracket to projector using four M12 x 20mm hex head cap screws through four M12 washers and holes in the HB bracket. (See
Figure 1)
Milestone AV Technologies, Inc., and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone
makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation
or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained he rein. Milestone assumes no responsibilit y for accuracy, completeness or suffi ciency of the i nformation con tained in t his document.
Chief, a products division of Milestone AV Technologies
6436 City West Parkway, Eden Prairie, MN 55344
• P: 800.582.6480 / 952.225.6000 • F:877.894.6918 / 952.894.6918
Continued. . .
8800-002848 Rev00
©2016 Milestone AV Technologies
www.milestone.com
04/16
Page 2
INSTALLATION INSTRUCTIONS
4
5
VCM Housing
x 4
Seat VCM in HB
bracket slots
Continued . .
CAUTION: Installing a ceiling mount requires the presence of two persons familiar with mechanical installations. A third assistant is
recommended.
Figure 2
3. Attach VCM housing to your method of support and tighten firmly so the VCM housing is square to the screen.
4. With help of assistants, lift the HB bracket with projector and install it to the four studs extending from the VCM housing. Ensure that the
VCM housing is seated in slots on HB bracket. (See Figure 2)
5. Tighten the four 5/16" flange nuts. (See Figure 2)
Loading...