CHIEF HB-75P Installation Instructions Manual

INSTALLATION INSTRUCTIONS

MODEL: HB-75P Custom Projector Bracket

Unpack carton and verify contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.

PARTS

(1) BRACKET, Custom HB (5) WA S HER, Flat, M 6
(4) NUT, Flange, Hex, 5/16-18 (5) SCREW, Phillips Pan Head, M6 x 20mm

(5) SPACER, .750 x .250 x. 250

2

x 5

Front

1

Figure 1

INSTALLATION

WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL INJURY! All compone nts must be securely fastened

to each other and to the ceiling, and the ceiling must be capable of supporting five times the total weight of the installation.

1. Lower custom HB bracket onto top of projector. Ensure that bracket front points toward front of projector. (See Figure 1)

2. Attach HB bracket to projector using five M6 x 20mm Phillips pan head screws, five M6 flat washers and five spacers through five holes
in the HB bracket. (See Figure 1)

Continued. . .

Milestone AV Technologies, Inc., and its affiliated corporati ons and subs idiaries ( collectively, "Milestone"), intend t o make this ma nual accur ate and complet e. However, Mileston e

makes no claim that the information contained herein co vers all details, conditions or v ariations, nor does it provide for every pos sible contingency in connectio n with the installation
or use of this prod uct. The i nfor mation c ontained in this doc umen t is subje ct t o change without noti ce or obl igat ion of any k ind. Milestone m ake s no repr esentati on of warran ty, ex­pressed or implied, regarding the i nformation conta ined herein. Mi lestone assume s no responsibility for accuracy, completeness or sufficiency of t he information contai ned in this
document.

Chief Manufacturing, a products division of Milestone AV Technologies

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

8401 Eagle Creek Parkway, Savage, MN 55378

©2011 Milestone AV Technologies ,

a Duchoss ois Group C ompany

8803-002018 Rev01

05/11

INSTALLATION INSTRUCTIONS

Continued . .

CAUTION: Installing a ceiling mount requires the presence of two persons familiar with mechanical installations. A third assistant is

recommended.

VCM Housing

5

x 4

Seat VCM in HB
bracket slots

4

Figure 2

3. Attach VCM housing to your method of support and tighten firmly so the VCM housing is square to the screen.

4. With help of assist ant s, l ift the projector and i nst all it to t he four studs extending from the VCM housing. Ensur e that the VCM housing is
seated in slots on HB bracket. (See Figure 2)

5. Tighten the four 5/16" flange nuts. (See Figure 2)