Page 1
INSTALLATION INSTRUCTIONS
MODEL: HB-74P Custom Projector Bracket
Unpack carton and verify contents. If any listed parts are missing, immediately contact a Chief Customer Service representative by calling
1-800-582-6480.
PARTS
(1) BRACKET, Custom HB (4) NUT, Flange, Hex, 5/16-18
(4) SCREW, Phillips Flat Head, M6 x 16mm (4) SPACER, Nylon .50 x .260 x .1875
x 4
2
1
x
x 4
x
Toward front
of projector
Figure 1:
INSTALLATION
WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL INJURY! All components must be securely f astened
to each other and to the ceiling, and the ceiling must be capable of supporting five times the total weight of the installation.
1. Place four nylon spacers on top of projector.
2. Lower custom HB bra cket ont o spacers on top of projector. Ensure that the side hooks open towa rds back of t he proj ector. (See Figure 1)
3. Attach HB bracket to projector using four M6 x 16mm Phillips flat head screws through nylon spacers. (See Figure 1)
Continued...
Milestone AV Technologies, Inc., and its affiliated corporati ons and subs idiaries ( collectively, "Milestone"), intend t o make this ma nual accur ate and complet e. However, Mileston e
makes no claim that the information contained herein co vers all details, conditions or vari ati ons, nor does it provide for every pos sible c ontingency in connection with th e i nsta llation
or use of this prod uct. The i nfor mation c ontained in this doc umen t is subje ct t o change without noti ce or obl igat ion of any k ind. Milestone m ake s no repr esentati on of warran ty, expressed or implied, regarding the i nformation conta ined herein. Mi lestone assume s no responsibility for accuracy, completeness or sufficiency of t he information contai ned in this
document.
© 2008 Chief Manufacturing, 8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8803-000114
5/28/08
Page 2
INSTALLATION INSTRUCTIONS
Continued...
CAUTION: Installing a ceiling mount requires the presence of two persons familiar with mechanical installations. A third assistant is
recommended.
VCM H o using
5
x 4
Seat VCM in HB
bracket slot s
4
Figure 2:
4. Attach VCM housing to your method of support and tighten firmly so the VCM housing is square to the screen.
5. With help of assist ant s, l ift the projector and i nst all it to t he four studs extending from the VCM housing. Ensur e that the VCM housing is
seated in slots on HB bracket. (See Figure 2)
6. Tighten the four 5/16" flange nuts. (See Figure 2)
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
Loading...