Chief HB35B Installation Guide

INSTALLATION INSTRUCTIONS

MODEL: HB-35B Custom Projector Bracket

Unpack carton and verify contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.

PARTS

(1) BRACKET, Custom HB (3) WA S HER, Flat, M 8
(3) SCREW, Button Head, M8 x 16mm (4) NUT, Flange, Hex, 5/16-18

2

x 3

1

Figure 1

INSTALLATION

WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL INJURY! All components must be securely fastened

to each other and to the ceiling, and the ceiling must be capable of supporting five times the total weight of the installation.

1. Lower custom HB bracket onto top of projector. Ensure that triangle in bracket points toward front of projector. (See Figure 1)

2. Attach HB bracket to projector using three M8 x 16mm button head screws and three M8 flat washers through three holes in the HB
bracket. (See Figure 1)

Continued. . .

Milestone AV Technologies, Inc., and its affiliated corporati ons and subs idiaries ( collectively, "Milestone"), intend t o make this ma nual accur ate and complet e. However, Mileston e

makes no claim that the information contained herein co vers all details, conditions or vari ati ons, nor does it provide for every pos sible c ontingency in connection with th e i nsta llation
or use of this prod uct. The i nfor mation c ontained in this doc umen t is subje ct t o change without noti ce or obl igat ion of any k ind. Milestone m ake s no repr esentati on of warran ty, ex­pressed or implied, regarding the i nformation conta ined herein. Mi lestone assume s no responsibility for accuracy, completeness or sufficiency of t he information contai ned in this
document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

©2010 Milestone AV Technologies,

a Duchoss ois Group C om pany

8803-002012 Rev00

05/10

INSTALLATION INSTRUCTIONS

Continued . .

CAUTION: Installing a ceiling mount requires the presence of two persons familiar with mechanical installations. A third assistant is

recommended.

VCM Housing

5

x 4

4

Seat VCM in HB
bracket slots

Figure 2

3. Attach VCM housing to your method of support and tighten firmly so the VCM housing is square to the screen.

4. With help of assist ant s, l ift the projector and inst all it to t he fo ur st uds extending from the VCM hous ing . Ensur e that t he V CM housing is
seated in slots on HB bracket. (See Figure 2)

5. Tighten the four 5/16" flange nuts. (See Figure 2)