Checkline ESH User Manual

2 YEAR WARRANTY (RESTRICTIONS APPLY)

Imada, Inc. warrants its products to the original purchaser to be free from defects
in workmanship and material under normal use and proper maintenance for two
years (one year for adapters, attachments, batteries, and cables) from original
purchase. This warranty shall not be effective if the product has been subject to
overload, shock load, misuse, negligence, accident or repairs attempted by others
than Imada, Inc.

During the warranty period, we will, at our option, either repair or replace
defective products. Please call our customer service department for a return
authorization number and return the defective product to us with freight prepaid.

The foregoing warranty constitutes the SOLE AND EXCLUSIVE WARRANTY, and we
hereby disclaim all other warranties, express, statutory or implied, applicable to the
products and/or software, including but not limited to all implied warranties of
merchantability, fitness, non-infringement, results, accuracy, security and freedom
from computer virus. In no event shall Imada, Inc. and/or its affiliated companies be
liable for any incidental, consequential or punitive damages in connection with the
use of its products and/or software.

.

Specifications subject to change without notice.

Model PS
Model MF

Model PSH
Model ESH

Model FB

INSTRUCTION MANUAL

GENERAL OPERATION

1. Press (or rotate for Model PSH/ESH) Peak Switch OFF.

2. Hand tighten (no tool!) attachment to the measuring shaft.

3. Rotate Tare Ring to read “0” to tare the weight of attachment and

measuring shaft orientation.

4. Begin measuring.

Real Time Mode: the Peak Switch is OFF and the gauge dis­plays force as it changes. During Real Time Mode, you can hold a
critical reading by turning the Peak Switch to the ON position.
Peak Mode: the Peak Switch is ON and the gauge will retain
highest reading taken which will not change until a higher
value is measured. Turn the Peak Switch OFF to zero the gauge
and turn it ON again to measure Peak values.

DIMENSIONS

MOUNTING

When mounting IMADA mechani­cal gauges to IMADA test stands,
hold the gauge firmly and unscrew
the 4 screws in back, making sure
the case does not separate. (FIG.1)

AP-002 adapter plate mounts IMADA
mechanical gauges to IMADA test
stands. Align plate and gauge holes
and insert the 4 long screws sup­plied to attach gauge. Then utilize
the 4 PEM nuts on the adapter plate
to mount to IMADA test stands
with the mounting bolts supplied.

AP-001 adapter plate mounts IMADA
low capacity gauges to most other
brands of test stands. Use the 4
screws (supplied) to mount the
IMADA gauge to the AP-001 adapter
plate. Then utilize the 2 PEM nuts
on the AP-001 adapter plate to
mount to other brands of test stand.

MOUNTING PS/FB/MF

AP-002 ADAPTER PLATE

LONGER SCREWS

PEM NUT

AP-001 ADAPTER PLATE

LONGER SCREWS

PEM NUT

FIG.1

REMOVE CASE

SCREWS

WITH 4 PEM NUTS

MOUNTING BOLTS

WITH 2 PEM NUTS

MOUNTING BOLTS

Use this bolt only!

Speciications subject to change without notice.

page 2

page 7