Chase-Durer Cloud Chaser Automatic User Manual

OPERATION MANUAL

CLOUD CHASER
AUTOMATIC

SpecificationS

CLOUD CHASER AUTOMATIC

Technical Specications

• SWISS Made, 26-jewel precision SW 200 automatic movement.

• Display window for date.

• Super-LumiNova system on hands and dial.

• Screw-in exhibition back.

• Water resistant to 10atm/333ft

• Scratch-resistant sapphire crystal

• Diameter - 44mm

• Serial numbered.

• 2 year limited international warranty.

Hour hand

Winding and Setting
Positions

WATCH HANDS

Second hand

Setting Crown

WinDing / Setting LocaL tiMe

NOTE: If your watch stops, it must be wound by turning the crown clockwise approximately

25 full turns. Although the watch is automatic, the mainspring may not have enough reserve
to keep it running accurately. Once wound, the normal movement of wearing the watch will
provide enough power to keep accurate time.

Postion 1 of setting crown is for normal
operation and also used for winding

Setting crown in position 3 is used to
adjust both hour and minute hands*

Setting Crown Positions

1 > Winding position.
2 >> Date adjustment position.
3 >>> Stops second hand, setting minute and hour hands position.

Setting Date

Date changes each time the hour hand passes midnight (24:00 hours)

Date Window

Minute hand

*Setting crown in position 3 Stops the

Second Hand to allow synchronizing

with a time signal.

Date changes each time hour hand
passes midnight (24:00 hours)

Note - When setting the time, pay attention to the Date window to make sure you are setting
the time correctly for AM or PM. The Date begins changing at 11:30PM (23:30 hours).

CHASE-DURER

9601 Wilshire Blvd. #1118
Beverly Hills, CA 90210 USA
Tel: [phone]
Fax: [phone]
E-mail: [e-mail]

Turn crown forward in
position 2 to set the Date

www.chase-durer.com

© Copyright 2007 CHASE-DURER LTD all rights reserved.