Chapin B2397702 User Manual

SPREADER Assembly / Operation Instructions / Parts

Model 81008A

80 lb. Spreader

Go to www.

chapinmfg.com

for Details

DO NOT RETURN TO THE STORE

Please call 800-950-4458 if you are missing any parts, having trouble assembling, or have any questions regarding the
safe operation of this product.

WARNING

Carefully Read These Instructions Before Use

IMPROPER USE OR FAILURE TO FOLLOW INSTRUCTIONS CAN RESULT IN PRODUCT FAILURE OR INJURIES. FOR SAFE
USE OF THIS PRODUCT YOU MUST READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING.

- Do not allow anyone to operate the broadcast spreader without proper instructions

- Do not permit children to operate the broadcast spreader

- Wear protective eyewear and gloves when handling and applying lawn and garden chemicals

- Read the chemical label instructions and warnings for handling and applying the chemicals you plan to
spread – application settings provided are only a guideline

MODEL 81008A

CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458

016311 R1018

WARNING

Auger is designed to work in forward motion. Excessive reverse motion could cause binding. If resistance is felt while pulling
spreader backwards, stop and clear salt from auger.

ASSEMBLY INSTRUCTIONS

Approximate assembly time is 5-10 minutes

Suggested Tools:

Wrench and/or Ratchet Set

• Assemble handle to uprights with Hex bolts and nuts.

• Tighten M6 nuts completely.

• Assemble linkage to bail assembly (Fig. A).

• Assemble linkage to rotate link (Fig. B).

• Rotate the turnbuckle to adjust the gate (Fig. C).

Bail Position for adjusting Gate:

1) Bail must be in rest position for Gate Closed.

2) Bail must be depressed for Gate Open.

To Close Gate
(Increase Length)

To Open Gate
(Decrease Length)

Figure A

Bail
(rest position)

Bolts

Handle

M6 Hex
Nuts

Figure C

AUGER INSTALLATION

• Screw auger onto impeller sha. Screw auger retaining nut into auger hole with M6 socket driver.
Tighten completely with wrench to secure.

GENERAL OPERATING INSTRUCTIONS

• Be sure gate control is in the closed position. Do not hold bail down when lling. If gate is not fully closed see
Figure C above for adjustment.

• Determine appropriate setting for material being used by reading the suggested setting on the material’s bag.
Be sure to read the instructions on the bag/box of the material you’re spreading to identify accurate setting needed).

• To begin spreading, start walking (about 3 mph pace) and pull the bail system down to open gate.

• To stop spreading simply let go of the bail and the gate will close.

Fully Assembled

Figure B

BAFFLE OPERATING INSTRUCTIONS

• Adjust bae by hand to block distribution accordingly.

• Use wing nuts to adjust tension on baes.

Not Fully Closed Fully Closed

STORAGE AND MAINTENANCE

• When nished spreading empty hopper of any remaining material

• oroughly wash spreader and allow to dry before storing

• To fold down handle:

- Simply remove the bottom two bolts on the handle

- Loosen two M6 Hex nuts and fold down handle

- Replace two bottom bolts

- Tighten M6 Hex nuts completely

GRATE

• If salt or spreading material is too large for the grate, remove grate before use.

CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458

ESPARCIDORA Armado / Operación Instrucciones / Partes

Model 81008A

36 kg (80 lb) Esparcidora

Visite www.

chapinmfg.com

para conocer más

detalles.

NO DEVUELVA A LA TIENDA

Por favor llame al 800-950-4458 si le falta alguna parte, si tiene problemas con el armado o si tiene alguna pregunta sobre
la operación segura de este producto.

ADVERTENCIA

Lea estas instrucciones atentamente antes de utilizarlo

EL USO INAPROPIADO O NO SEGUIR LAS INSTRUCCIONES PUEDE RESULTAR EN FALLAS DEL PRODUCTO O LESIONES.
PARA USAR ESTE PRODUCTO DE MANERA SEGURA DEBE LEER Y SEGUIR TODAS LAS INSTRUCCIONES ANTES DE USARLO.

- No permita que nadie opere el esparcidor a voleo sin las instrucciones apropiadas

- No permita que niños operen el esparcidor a voleo

- Use gafas de seguridad y guantes al manejar y aplicar sustancias químicas a patios y jardines

- Lea las instrucciones y advertencias químicas en la etiqueta respecto al manejo y aplicación de las sustancias que
planea esparcir – las configuraciones de aplicación proporcionadas son sólo una guía

MODEL 81008A

CHAPIN INTERNATIONAL, INC BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458

016311 R1018