Help Alarm Response Kit With battery back-up
1st Ring to be 100mm from oor.
2
nd
Ring to be between 800/1000mm from oor.
Ceiling Pull Cord 3 Core 4 Core
230v AC
PSU & Lamp/Sounder
Reset/Sounder
to be 1200mm
max above oor.
The Help Alarm Response Kit meets the growing requirements for a
means of indicating that assistance is required.
The Help Alarm Response Kit provides a simple solution
to many such environments, these include:
• Disabled persons facilities
• Medical facilities
• Reception areas
• Lone workers
• Gym & spa
• Educational facilities
Equipment positioning within disabled persons
facilities.
Approved Document M- ‘Access to & use of Buildings’
states the following:
…Pull cords for emergency alarms…are coloured red,
located as close to a wall as possible, and have two
red 50mm bangles, one set 100mm and the otherset
between 800 & 1000mm above the oor.
These should be reachable from the WC.
…Simple push buttons (reset unit) are notset more
than 1200mm above the oor. This should be
reachable from the WC.
…The emergency assistance signal (Lamp/sounder)
is located so thatit can be easily seen & heard by
those able to give assistance.
Additional pull cord units can be added to the
system to allow for larger rooms or multi area
coverage. Please note that additional pull cords
will operate & be reset by the same unit as the
initial pull cord
Installation
Installation of this equipment must be carried out
by a competent electrician to the requirements of
the current IEE wiring regulations.
Connection details
230v AC
E L N
Power Supply incorporating
To additi onal equipment
Including
CH/HKI Multi-way
indicator
To next pull cord
Lamp/Sounder
and battery back-up
12v 0v
12v 0v X1 X2
12v 0v X1 X2
RESET
UNIT
12v 0v X1
12v 0v X1
PULL
CORD
UNIT
12v 0v X1
Use ‘intruder
alarm’ type
stranded cable for
interlink wiring.
DO NOT USE
‘TWIN & EARTH’
or other rigid cable
types!
Additional options
The Help Alarm Response Kit can be linked to a
remote multi-way indicator panel (for use in a
reception orsta ed area). Our reference is CH/HKI/22 way, through to CH/HKI/11-11 way.
A 12 volt relay unit(S/E60/A) can be used to interface
the unitto a wide range of equipment such as:-
• BMS
• Fire alarms
• Intruder Alarms
• Paging transmitters
1 | www.channelsafety.co.uk 0845 884 7000 @ sales@channelsafety.co.uk
Operation
Once the pull cord(s) are activated the
reassurance LED on the pull cord will illuminate,
the reset unit will illuminate & operate its internal
sounder, and the external lamp/sounder unit will
operate along with any optional equipment
installed.
Simply pressing the illuminated resetswitch will
return the system to the ‘normal’ State.
Battery details
A23 12V AlkalineBattery
10.3mmdiameter x 28.5mmlong
Loading...