Specifications: typical @ 25 C ± 5 C
OO
SVC-10 Distribution System
Video
Digital audio
Analog audio
Power supply
Physical
Environmental
nominal level
impedance
3dB bandwidth (worst case 1000ft)
nominal level
impedance
3dB bandwidth (worst case 1000ft)
nominal level
impedance
3dB bandwidth (worst case 1000ft)
output voltage
input power
power consumption (transmitter)
power consumption (receiver)
transmitter size (hXwXd)
receiver size (hXwXd)
transmitter weight
receiver weight
operating temperature
storage temperature
humidity
1.0 Vp-p
75
10MHz
0.5 Vp-p
75
15MHz
1Vrms
10K nominal
20Hz-20KHz
15VDC
105-125VAC
5 watts typical
5 watts typical
1.75” X 17.0” X 6.5”
1.0” X 4.6” X 3.2”
2 lbs 10 oz
9.6 oz
OO
0 C to 50 C
-30Cto70C
5% to 90% (non-condensing)
OO
PERFORMANCE MULTI-ROOM VIDEO
Installation Manual
&
Users Guide
power
video
s-video
digital IR
CAT-5
Point to Point
SVC-10
Warranty
Multiplex Technology, Inc. warrants this product to be free from defects in
materials and workmanship for a period of one year from the date of
purchase or MTI will repair, or at its option, replace the defective product.
To obtain warranty service, call MTI for a return material authorization
(RMA) number and return the product prepaid to Multiplex Technology,
Inc., 3001 Enterprise Street, Brea, CA 92821, Attention: Customer
Service. Please put the RMA number on theoutsideofthe carton.
Any implied warranty arising from the sale of the product including implied
warranties of merchantability and fitness for purpose are limited to the
warranty stated above. MTI shall notbe responsible for losses ordamages
or expenses, whether direct, consequential or incidental arising from the
use of or the inability to use this product. Some states do not allow
limitations on how long the implied warranty lasts or the exclusion or
limitation or incidental or consequential damages, so the above limitations
and exclusions may not apply to you. This warranty gives you specific legal
rights, and you may have other rights which may vary from state to state.
600-227 Rev. B
Multiplex Technology, Inc., Brea, CA 92821
Video Distribution System
Model
SVC-10
This device complies with the FCC's Part 15 Rules for TV
interface devices. Any change or modification to this device
without the permission of Multiplex Technology, Inc. may
void the user's authority to operate this equipment.
3001 Enterprise Street, Brea, CA 92821-6213, U.S.A.
714-996-4100 * 800-999-5225 * FAX 714-996-4900 * www.channelplus.com
2
OVERVIEW
FREQUENTLY ASKED QUESTIONS
The SVC-10 is a complete audio/video/IR over CAT-5 tranmission
system. Each SVC-10 includes a rack-mountable transmitter and
a small receiver unit. The SVC-10 can transmit either composite
video or S-video and either Pro-logic encoded analog stereo or
Digital audio. The SVC-10 transmitter can be adjusted to
compensate for CAT-5 cable losses up to 1000 feet. In addition, an
IR target can be used with the receiver to control theremote source.
CONTROLS AND CONNECTIONS
Transmitter
power
video
s-video
digital IR
Front
Power LED is always lit when unit powered
Shows either composite or s-video source
LED lit when transmitting digital audio
LED flashes during IR data transmission
Digital audio coax output (loop-through)
Composite video output (loop through)Right analog audio output (loop through)
Left analog audio output (loop through) S-video output
Transmitter
Back
Receiver
Front
PCM/AC3/DTS
AUDIOOUT
AUDIOIN
LEFT
DIGITALOUT
DIGITALIN
RIGHT COAX OPTICAL
POWER
15VDC
300mA
Power supply input
Left analog audio input
Right analog audio input Cable length adjust
Digital audio coax input S-video input
Digital optical audio input Composite video input
Power LED lit while unit powered
Flashes during IR transmission
Receiver
power IR
SVC-10R
Power supply input
Left analog audio output
Right analog audio output
Digital audio coax output
Composite video output
VIDEOOUT
VIDEOIN
VIDEO S-VIDEO
Back
LENGTH
ADJUST
CAT-5
(infeet)
IRREPEATERS
600400
800
200
1000
0
IR target input
CAT-5 input
S-video output
AUDIO
AUDIO COAX
POWER
RIGHT DIGITAL
LEFT
IR emitter ports (2)
CAT-5 output
VIDEO S-VIDEO CAT-5 IR INPUT
SVC-10
Q: Can I transmit composite video from one source and s-video
from another source at the same time?
A: No, the SVC-10 can only handle either composite or s-video -
not both.
Q: Can I connect a CD player’s left&right analog outputs and the
digital coax from a DVD to the SVC-10?
A: Yes, but only one device can be used at a time. If you are
transmitting digital audio, make sure your CD player is off.
Likewise, if you are using the CD player, make sure the DVD
player is off.
Q: What happens if I use both the coax digital and optical
connector at the same time?
A: The coax digital always overrides the optical signal. When
the coax digital connector is plugged into the unit, the optical
signal is ignored, even if there is no signal on the coax cable.
Q: Can the SVC-10 transmit farther than 1000 feet?
A: Yes, but the system only compensates for up to 1000 feet.
The SVC-10 is optimized for lengths from 0 to 1000 feet.
Operating beyond this is possible but not recommended.
Q: Can I expand the SVC-10 using an expansion panel to
connect several receivers to a single transmitter?
A: No, the SVC-10 system is designed to work point-to-point. It
is not designed to be expanded at this time.
Q: What digital formats is the SVC-10 compatible with?
A: All commonly available formats such as PCM, Dolby Digital®
(AC-3), Dolby Digital Surround EX , DTS and DTSES .
®® ®
Q: How do I set the length adjustment if I don’t know how long
my CAT-5 run is?
A: You can adjust the control until the picture looks normal for
contrast and brightness.
7
Sample System Diagram 3:
3
Transmitting S-video and DTS from a DVD
600 feet with IR
Connect a local monitor here
Connect a local receiver here
POWER
15VDC
300mA
350-103 power
supply (included)
AUDIOOUT
AUDIOIN
LEFT
PCM/AC3/DTS
DIGITALOUT
DIGITALIN
RIGHT COAX OPTICAL
Digital
audio
VIDEOOUT
VIDEOIN
VIDEO S-VIDEO
s-video
200
600400
800
Set LENGTH ADJUST to 600
1000
0
LENGTH
ADJUST
CAT-5
(infeet)
IR REPEATERS
600400
800
200
1000
0
2171
FEATURES
EASY WIRING
The SVC-10 transmitter and receiver communicate over a single
run of CAT-5 wire. A back panel control is on the transmitter to
allow compensation for any length of wire up to 1000 feet. Wire
RJ-45 connections according to TIA T568A standard.
FLEXIBLE VIDEO INPUT
Choose between s-video input or composite video. The SVC-10
has its own connector for each - no need for a converter plug.
UNIVERSAL AUDIO
The SVC-10 accepts either left&right analog audio or digital
audio. It can handle either coax or fiber optic (TOSLINK) digital
audio. When using the fiber optic cable, the SVC-10 converts
this signal and puts it on the coax digital loop out connector.
When using analog audio, the SVC-10 will maintain Dolby Prologic® encoding if present.
Attach the IR emitter
directly over the IR
sensor.
350-103 power
supply (included)
Surround Sound
POWER
Digital
Processor
DVD
AUDIO
LEFT
AUDIO COAX
RIGHT DIGITAL
6
600 feet CAT-5
VIDEO S-VIDEO CAT-5 IR INPUT
TV
2132
LOOP OUT CONNECTORS
All SVC-10 connectors have built in loop through connectors for
a second device such as a local monitor.
ACTIVE TERMINATE FEATURE
The SVC-10 terminates the inputs into a 75 ohm load. When a
second cable is connected to the output, the SVC-10
automatically disconnects this termination to allow the second
device to provide the termination.
IR CONTROL
Standard 12 volt ChannelPlus IR targets and emitters can be
used with the SVC-10 to allow control of the source from the
remote location.
MOUNTING
The SVC-10 can be mounted in standard 19” racks by attaching
the included mounting ears. Remove the rubber feet on the
bottom of the unit to ensure clearance when inserted into a rack.
Sample System Diagram 1:
Transmitting video and analog audio from a DVD
800 feet
Connect a local monitor here
Connect a local receiver here
200
600400
800
Set LENGTH ADJUST to 800
1000
0
Sample System Diagram 2:
Transmitting composite video and analog audio
from a VCR 350 feet with IR
Connect a local monitor here
Connect a local receiver here
200
600400
800
Set LENGTH ADJUST to 350
1000
0
350-103 power
supply (included)
350-103 power
supply (included)
POWER
15VDC
300mA
AUDIOOUT
DIGITALOUT
AUDIOIN
DIGITALIN
LEFT
RIGHT COAX OPTICAL
DVD
800 feet CAT-5
AUDIO
AUDIO COAX
POWER
RIGHT DIGITAL
LEFT
PCM/AC3/DTS
VIDEOOUT
VIDEOIN
VIDEO S-VIDEO
VIDEO S-VIDEO CAT-5 IR INPUT
LENGTH
ADJUST
CAT-5
(infeet)
IR REPEATERS
600400
800
200
1000
0
350-103 power
supply (included)
POWER
15VDC
300mA
Left
audio
AUDIOOUT
AUDIOIN
LEFT
PCM/AC3/DTS
DIGITALOUT
DIGITALIN
RIGHT COAX OPTICAL
Right
audio
Composite
video
VIDEOOUT
VIDEOIN
VIDEO S-VIDEO
LENGTH
ADJUST
CAT-5
(infeet)
IR REPEATERS
600400
800
200
1000
0
2171
Wiring Modular Plug
(T568A)
Insert wires in this order:
Do not untwist
more than 0.5"
Brown
White/Brown
Orange
White/Blue
Blue
White/Orange
Green
White/Green
Attach the IR emitter
directly over the IR
sensor.
350-103 power
supply (included)
POWER
VCR
AUDIO
LEFT
AUDIO COAX
RIGHT DIGITAL
350 feet CAT-5
VIDEO S-VIDEO CAT-5 IR INPUT
left
audio
right
audio
4
video
Stereo
TV
Pro-logic
Surround Sound
Processor
2132
TV
5
Loading...