Champion RS-11 Operation Manual

Operation Manual

Monster Mini Spreader

RS-11

 Technical Specifications
 General Safety/Operating Instructions
 Using the Monster Mini Spreader
 Maintenance Instructions

This is a detailed instruction guide specific to Champion Rescue Tools Mini Spreader – please see separate
information provided for general hydraulic tool usage, warranty information, MSDS information, etc.

when every second counts

trust a CHAMPION

Champion Rescue Tools – RS-11 Monster Mini Spreader Detailed Tool Instructions

Operating Pressure

5,000 or 10,500 psi

Weight (Cutter)

27.5 lbs

Length

27.5 inches

Width

6.75 inches

Height

7.75 inches

Spreader Opening

11 inches

Max Spreading Force (10,500)

25,000 lbs

Max Spreading Force (5,000)

14,000 lbs

Hydraulic Fluid Type

Specified by Customer

Introduction

Thank you for purchasing the RS-11 Monster Mini
Spreader – a tool designed for maximum portability and
maneuverability – perfect for hundreds of rescue

operations. For General Operating and Safety

Instructions please refer to the “General Operating
Procedures” Booklet furnished with your tool.

General Safety and Operating Instructions

1. Always turn the power unit to the “off” position and

place the control valve in the “off” position for any
service or clearing work. You should also “dump”

the valve by pushing it all the way to one side and
then the other – this releases any stored energy and
eliminates tool creep.

2. Familiarize yourself with the tool(s) and control

valve, moving the control valve back and forth until
familiar with the valve action and operation. NEVER
put any part of your body between the moving parts
of this or any other tool!

3. Using a hydraulic tool is a one person operation

with no exceptions.

4. The mini spreader is designed to get into tight

places and do the lion’s share of your spreading,

however it is not designed to replace a full size
spreader. Inspect the spreader arms and tips after
each use to make sure it is in good condition.
Inspection of the tips before each use is a MUST! If
tips are suspect in any way, pull the tool out of
service immediately. Remember you are working
with many thousands of pounds of force.

5. The Hydraulic Cylinder on your new tool operates

under extreme pressure and is a sealed unit. Under
normal use, it does not require service. The factory
sealed cylinder must NEVER be taken apart. Doing
so will void your warranty and could potentially
result in severe injure or even death.

6. As long as the cylinder remains sealed and is not

tampered with, any defect or malfunctions are
covered by the Champion limited lifetime warranty

(to the original purchaser). See the “Champion
Rescue Tools Statement of Lifetime warranty” for

additional information.

7. The control valve must be kept clean. Blow off sand

and dirt with an air hose. Use WD-40- on the valve
spring. Valve does not need any maintenance.

8. As with all Champion Rescue Tools, the operating

speed can be slowed down or increased by moving
the trigger accordingly. If the trigger is opened
partial the movement will be slow; if the trigger is
opened all the way movement will be faster.

Always use proper safety gear and follow all safety
instruction as outlined in this manual.

© Champion Rescue Tools