Double skinned stainless steel with
exterior latch and inside release handle.
Spray Arm Assembly
Stainless steel jets, removable end caps
and hand operated quick release
mechanism for easy cleaning and
reassembly.
Filter
Perforated stainless steel screen type.
Double filtration system for increased
effectiveness and easy cleaning without
emptying the tank.
Water Pump
15 Hp, 208/240/480 volt, 3 phase,
60 cycle with output of 250 gallons
per minute at 35 to 45 P.S.I.
Digital Control & Information Center
110 volt control circuit with push pad
operation of “Power On”, “Stop” and “Short,
Medium or Long Wash Cycles”. A digital
display indicates “Time Remaining” for each
cycle. LED’s indicate wash, rinse and
unload functions. A buzzer is also included
to provide an audible indication of time to
unload. A pre-programmed circuit board
allows the push pad to be used as a
“Diagnostic Center” by displaying “Error
Codes” for ease of troubleshooting.
Gauges
Special moisture resistant gauges
measure wash temperature, rinse
temperature and wash jet pressure.
Wash Tank
Stainless steel with electric, infrared
gas, steam or steam coil heating,
thermostatically controlled, low water
protected, sloped to drain with a
72-gallon capacity.
Racks
Stainless steel rod built to match specific
washing requirements.
Due to an ongoing value analysis program at Champion, specifications contained in this catalog are subject to change without notice.
Champion Industries, Inc., P. O. Box 4149, Winston-Salem, NC 27115 • 336/661-1556 • Fax: 336/661-1979 • www.championindustries.com
2674 N. Service Road, Jordan Station, Ontario, Canada L0R 1S0 • 905/562-4195 • Fax: 905/562-4618
SPECIFICATIONS
MODEL 1527-N RACK, PAN
AND UTENSIL WASHER
WasherAutomatic washing machine designed to wash and sanitize items commonly used in
the bakery, meat, poultry, candy and food service industries. Machine is designed to
be installed in a pit or used at floor level with a ramping system.
Cabinet55" wide x 50" deep x 93" high. Clearance height: 123". Standard door opening:
30" wide x 76-1/2" high. Wash chamber: 30" wide x 32" deep x 76-1/2" high.
Constructed of 12, 14 & 16 gauge, type 304 #3 finish, stainless steel. All seams
tig-welded, cleaned and polished.
DoorStandard right hand or optional left hand swing constructed of 14 and 16 gauge, type
304 #3, stainless steel with integral stainless steel framework. Door double skinned
for added strength. Equipped with door latch and inside release handle. Door is
interlocked with limit switch to prevent machine operation while open.
Washer FloorConstructed of 12 gauge stainless steel formed sheets designed to provide
maximum strength. Supports constructed of 2" x 2" x 1/4" stainless steel angle.
Recirculating Wash TankHeated by 208/240 or 480 volt electric immersion heaters, 18 kW total,
thermostatically controlled wash temperature with low water protection system.
72 gallon capacity (64 gallons if infrared gas heated), 14 gauge stainless steel,
sloped to drain. Infrared gas and steam heating options available.
FiltersPerforated, stainless steelscreen type. Double filter system for increased
effectiveness and easy cleaning without emptying wash tank.
Fill ValveSize 1/2" brass material, solenoid type for automatic option.
Drain ValveSize 2" brass material, gate type for manual or electrically operated ball valve for
automatic option.
Wash Pump15 hp, 208/240 or 480 volt, 3 phase, 60 cycle. Close coupled; 250 gallons per minute
at 35 to 45 psi, mounted on 12 gauge stainless steel formed channel base.
Rotating Wash Hub &Water-driven stainless steel spray arm assembly with stainless steel jets, removable
Spray Arm Assemblyend caps and hand-operated, quick-release mechanism for easy cleaning and
reassembly. Mounted on stainless steel base.
Sanitizing Rinse TankStainless steel, 20 gallon capacity, with 208/240 or 480 volt electric booster heaters,
18 kW total, to provide 180°/190°F hot sanitizing rinse. Uses 12 gallons per 30
second cycle. Infrared gas and steam coil heating options available, as well as
pumped rinse system.
Final Rinse PipingType 304 stainless steel tubing with brass compression fittings and brass or optional
stainless steel full cone rinse jets.
Control and Information110 volt control circuit with push pad operation of “Power On,” “Stop” and “Short,
Center
External Rinse HoseExternally mounted rinse hose with spray gun for easy cleaning and maintenance
Medium or Long Wash.” A digital display indicates “Time Remaining” for each cycle.
LED’s indicate wash, rinse and unload functions. A buzzer is also included to provide
an audible indication when the machine is ready to unload. A programmable
controller allows the push pad to be used as a “Diagnostic Center” by displaying
“Error Codes” for ease of troubleshooting. Moisture resistant gauges measure Wash
Temperature, Wash Pressure and Rinse Temperature.
of machine.
2674 N. Service Road,
Jordan Station, Ontario, Canada L0R 1S0
Tel: 905/562-4195 Fax: 905/562-4618
(1M) 10/06 Printed in U.S.A.
Champion Industries, Inc.
P. O. Box 4149, Winston-Salem, NC 27115
Tel: 336/661/1556 Fax: 336/661-1979
www.championindustries.com
SPECIFICATIONS
MODEL 1527-N RACK, PAN
AND UTENSIL WASHER
Steam Exhaust VentSteam exhaust vent 12-7/8" diameter, consisting of 14 gauge rolled rolled for PVC
pipe connection bolted to the top of the machine. Machine pre-wired with control
timer for the addition of a fan.
Optional Exhaust Fan12" diameter exhaust fan mounted on washer to extract steam after rinse cycle.
Constructed for moisture laden air or other air steam contaminants. 500 CFM @
.5" static pressure. 1/4 Hp, 1725 RPM.
Optional Hood & FanStainless steel hood and fan assembly, mounted over door to evacuate steam that
escapes when door is opened.
RacksCustomized to hold your specific items. Constructed of stainless steel rod and formed
angle, mig welded. Supplied with stainless steel casters and nylon wheels.
ConnectionsWater Inlet: 120 degrees F, 1" NPT
Water Drain: 2" NPT
Overflow: 2" NPT
Electrical: Two point connection except 575 volt, which is single point.
Steam Heating Option: 1/2" NPT
Natural or Propane Gas Heating Option: 1/2" NPT
Services120 Volt — 1 phase, 5 running amps, 15 amp service, plus one of the following
(except for 575 volt, which is single point connection):