THE CHAMBERLAIN GROUP, INC.
A Unit of Duchossois Industries, Inc.
845 Larch Ave., Elmhurst, Ill. 60126
Owners Manual
Garage Door Opener
ALL MODELS IN ARE BOLD ARE DELUXE (2 LIGHTS)
MODEL NUMBERS
550 550-9 550-6
450 450-9 450-6 140GM
350 350-9 350-6
240 240-9 240-6 500TV
150 150-9 150-6 250TV
140 140-9 140-6 140TV
250-9TV 140-6TV
140-9TV
550-9TV
500-9TV 250-6TV
450GM
550TV
550-6TV
500-6TV
FEATURES OF YOUR OPENER
1. Opener Lights: Turn on and off automatically with 4-1/2
minute illumination for your safety and convenience. Provide
constant LIGHT when Light Switch is ON.
2. Safety System: Independent up and down force adjustment.
The door REVERSES automatically when obstructed in DOWN
direction. The door STOPS when obstructed in UP direction.
3. Emergency Disconnect: Pull cord disconnect permits manual
door operation.
4. Automatic Reconnect: Trolley halves reconnect for automatic
operation when opener is energized after emergency disconnect.
SPECIFICATIONS
MOTOR
Type........................................Permanent split capacitor
Speed......................................1500 rpm
Volts........................................120 Volts AC - 60 Hz. Only
Current....................................4.5 amperes
DRIVE MECHANISM
Gears......................................16:1 worm gear reduction
Drive........................................Roller chain with two-piece trolley on
steel Tee-rail.
Length of travel........................Adjustable to 7 1/2 feet
Travel rate ..............................6 to 8 inches per second
Lamp.......................................On when door starts to travel, off 4 1/2
minutes after stop. Also separate
LIGHT Switch.
Door linkage............................Adjustable door arm. Pull cord
trolley release.
5. Motor Power: Permanently lubricated motor with automatic
reset.
6. Digital Radio Controls: Codes can be easily changed by the
owner.
7. Easy Limit Adjustment: Limits of door opening and closing
adjusted by turning screws without removing chassis cover.
8. Lock Switch: Prevents operation of opener from transmitter.
When LOCK Switch is ON, the opener can be operated in the
UP direction ONLY, from the Wall Control or optional Key
Switch and Keyless Entry accessories, (See below).
SAFETY
Personal..................................Push button and automatic reversal in
down direction. Push button and
Automatic stop in UP direction.
Electronic................................Independent UP and DOWN force
adjustment screws.
Electrical.................................Motor overload protector & low voltage
push button wiring.
Limit device.............................Circuit actuated by limit nut
Limit Adjustment.....................Screwdriver adjustment on side panel
Start circuit .............................Low voltage push button or radio
control.
DIMENSIONS
Length (overall).......................128 inches
Headroom required.................2 inches
Hanging weight.......................32 pounds
4
Adjustment
STEP 1
LIMIT ADJUSTMENT settings regulate the points at which the
door will stop when moving up or down.
NOTE: Door STOPS in the UP direction if anything interferes
with door travel. Door REVERSES in the DOWN direction if
anything interferes with the door travel (including binding or
unbalanced doors).
PROCEDURE: To operate opener, press wall push button. Run
the opener through a COMPLETE TRAVEL CYCLE. Limi
adjustments are not necessary when the door opens and closes
completely and doesn't reverse unintentionally in the fully closed
position.
The following chart outlines adjustment procedures. Run the opener through a COMPLETE TRAVEL CYCLE AFTER EACH
ADJUSTMENT. NOTE: REPEATED OPERATION OF THE OPENER DURING ADJUSTMENT PROCEDURES MAY CAUSE MOTOR
TO OVERHEAT AND SHUT OFF. SIMPLY WAIT 15 MINUTES AND TRY AGAIN. Read chart carefully before proceeding to Step 2. Use a
screwdriver to make limit adjustments.
Adjust UP and DOWN Limits
Left Side
Panel
Limit
Adjustment
Screws
Adjustment Label
LIMIT ADJUSTMENT CHART
IF DOOR DOES NOT OPEN COMPLETELY
BUT IT OPENS AT LEAST FIVE FEET
Increase UP travel. Turn the UP LIMIT adjustment screw
clockwise. One turn equals 2" of travel.
If door does not open at least 5 feet: adjust OPEN FORCE as
explained in Step 2.
IF SECTIONAL DOOR DOES NOT CLOSE COMPLETELY
Increase DOWN travel. Turn down limit adjustment screw
counterclockwise. One turn equals 2" of travel.
If the door still will not close completely, the header bracket is
positioned too high. Repeat Step 1, page 7.
IF ONE-PIECE DOOR DOES NOT CLOSE COMPLETELY
Increase DOWN travel. Turn down limit adjustment screw
COUNTERCLOCKWISE One turn equals 2 inches of travel.
IF OPENER REVERSES IN FULLY CLOSED POSITION
Decrease DOWN travel. Turn down limit adjustment screw
clockwise. One turn equals 2" of travel.
IF DOOR REVERSES WHEN CLOSING AND THERE
IS NO INTERFERENCE TO TRAVEL CYCLE
Test door for binding: Pull emergency release handle. Manually
open and close door. If door is binding, call a door serviceman. If
door is not binding or unbalanced, adjust CLOSE FORCE. See
Step 2.
17