Cetacea Sound Ensémble 603 User Manual

QUICK START GUIDE

ENSEMBLE 60

Model No. “ENS-60-3”

Congratulations. You have purchased an advanced surround sound system for

presentations. Please read this instruction guide thoroughly before attempting to

use the

1. There are three (3) source-input plugs on the Ensemble speaker base
that can have either mono or stereo inputs depending on your “source”,
i.e., computer, VCR, DVD, VCD, etc. If required, use only Mediaphile
AV approved in-line volume controls for connections. The right angle
plug of the volume control must be plugged into the “source”. In order to
connect to the speaker, use a single male-to-male extension which is also
supplied with your Ensemble accessories. One end will fit the volume
control and the other will plug directly into one of the Inputs labeled A,
B, or C. Refer to the hook-up drawings on our specification sheet if you
have questions.

2. Do not adjust the volume on the “source” above 75 %, because
computers and CD players exhibit distortion at high volume levels.

3. Turn the volume down as low as it will go on your in-line volume
control.

4. If your source has a “BASS BOOST”, or special effects like
Spatializer, SRS, or controls that say “JAZZ”, “ROCK”, “BLUES”, etc.,
turn them off for now!

5. The Ensemble speaker requires power from the Mediaphile AV
approved “Power Adapter/Conditioner”. Plug the power adapter into a
suitable source of 110v power and the opposite small end into the base of
the Ensemble speaker. (It will only fit in one location.)

6. Place Ensemble speaker on any flat surface and turn on the source
and slowly turn up the volume on the in-line volume control. Be sure to
use a high quality recording to fully appreciate the awesome sound of the
speaker. Once you are satisfied with the sound, add another source to one
of the other input jacks so you can select whichever one you want to hear
without having to change connections every time.

5RMF-ENS-60-3.doc

Mediaphile AV

with hook-up drawings can be printed from our web site at

Ensemble products. A copy of this guide and a spec sheet

www.cetaceasound.com.

(OVER)

Page two

ENSEMBLE 60

Model No. ENS-60-3

Accessory Kit

Volume control- 1 is supplied. Use per instructions on other side of this

page. Take particular note of the right angle plug. It needs to be
connected to the source of sound, i.e., VCR, computer, DVD,
microphone, etc. that you are using. The other end goes to the speaker
inputs, choose any one, A, B, or C.

VERY IMPORTANT: If connecting the Mediaphile AV CVSII
microphone to the Ensemble, use the Volume Control and Line Cord as
instructed. The right angle plug of the Volume Control must be
plugged directly into the LINE OUT jack of the CVSII receiver.

Stereo line cord- 1 is supplied. Use between straight end of Volume
Control and speaker as an extension cable. Or, use between the

headphone jack and speaker inputs if supplied volume control is not
required.

RCA to 3.5mm adapter- 1 is supplied. Attach to mono outputs of TV’s,
VCR’s, etc. Plug the supplied Volume Control right angle plug into

3.5mm female jack of RCA adapter.

Stereo RCA adaptor cable to 3.5mm stereo- 1 is supplied. The red and
white RCA style plugs on one end and the 3.5 mm small diameter female
jack on the other end identify this cable. Plug the supplied Volume

Control right angle plug into 3.5mm female jack of this Stereo RCA
Adapter. Use it with the Stereo Line Cord as described above if an

extension is required.

For any further questions, please see our web site for additional
information, instructions, and spec sheets.

Cetacea Sound Corp

Minneapolis, MN 55441

www.cetaceasound.com

5RMF-ENS-60-3.doc