Cerwin-Vega CV-5000 User Manual
CV-5000
HEAVY DUTY PROFESSIONAL AMPLIFIER
USER MANUAL
IMPORTANT SAFETY INSTRUCTIONS
2
TABLE OF CONTENTS
Introduction ……………………………………………..... 4
Features ………………………………………………….. 5
Front Panel Controls …………………………………...…. 6
Rear Panel Controls ………………………………………. 8
Protection ……………………….……………………....... 10
Setup ………………………………..…………………… 11
Connections …………………………………………..….. 13
Wiring…………………………………………………….. 15
Specifications…………..........……………………………. 17
3
INTRODUCTION
UNPACKING AND INSTALLATION
Thank you for your decision to purchase Cerwin-Vega’s innovative new CV Series
professional power amplifier! Engineered for superior sound reproduction, the CV
Series line of professional amplifiers deliver top quality audio at an affordable price.
The CV Series offers a standard of reliability and efficiency that makes them the
perfect solution for every DJ, musician, and sound engineer. Welcome to a new level
of professional quality sound performance!
Although it is neither complicated to install nor difficult to operate your amplifier, a
few minutes of your time is required to read this manual for a properly wired
installation and to become familiar with the amp’s features and how to use them.
Please take care in unpacking your amp and do not discard the carton and other
packing materials. They may be needed when moving your amp, and are required if it
ever becomes necessary to return the unit for service. Never place the unit near a
radiator, in front of heating vents, in direct sun light, in excessive humidity, or dusty
locations to avoid damageto the amp and to guaranty it lives a long and reliable life.
Connect your amp according to the description on the following pages.
4
FEATURES
The CV-5000 amplifier delivers the following power ratings.
2 x 1100 Watts at 8 ohm, 2 x 1800 Watts at 4 ohms and 2 x 2500 Watts at 2
ohms
2-channel, parallel or bridged mono operating modes for flexible application 5000 Watts
…and the following features.
Independent limiters for each channel reduce distortion.
Independent input level controls for each channel allow precision
adjustments.
Precise signal and clip LED indicators to monitor performance, allow you to
correct for overloading (clipping) condition.
Low-frequency filters (30Hz or 50Hz) remove rumble and subsonic
frequency.
Twin-tunnel and two temperature-sensitivity forced-air cooling system to
maintain a low, temperature working condition.
Balanced XLR or balanced 1/4-inch TRS Combination input connector for
each channel and LINK ports.
5-way output binding posts or Speaker connectors enable secure operation.
High-current toroidal transformer for absolute reliability.
Independent DC and thermal overload protection on each channel
automatically protects amplifier and speaker.
The CV-5000 can be mounted in any standard 19” rack.
5
FRONT PANEL CONTROLS
1. Rack Mounting Ears
Two front panel mounting holes are provided on each mounting ear.
2. Fan Vent
CV-5000 amplifier is cooled by two rear-mounted fans. Cool air flows through the front fan
filters, reducing the temperature of the inside components while forcing the heat out the rear
vents. Never block these vents and keep them clean at all time.
3. AC Power Switch
This switch controls the unit’s main power.
4. Signal Indicators
These green and yellow LED will illuminate to indicate that a signal is present at the amplifier
input, and that the signal is being amplified.
5. Clip Indicators
These red LED will illuminate at the clipping threshold. If it lights frequently, you could be
overloading the amplifier and a distorted signal is possibly being output. Under heavy clipping
activity, lower the channel gain controls to reduce the risk of damage to your speakers and
amplifier.
6. Active Indicators
These blue LEDs indicate that AC power is connected and the amplifier is turned on.
6
Loading...