Centro 120407, 85-1140-8, A01201 Assembly Manual

Page 1
Sink & Preparation Centre
Assembly Manual
85-1140-8 (A01201)
Limited 3-Year Warranty
Read and save manual for future reference.
Assemble your grill immediately.
Missing or damaged parts should be
Call the Centro Hotline at 1-877-707-5463.
Manual Revision #: 120407
Attention: Garden hose NOT included.
Page 2
DANGER
1. If you smell Gas: a. Shut o gas to the appliance b. Extinguish any open ame c. Open lid d. If odor continues, keep away from the appliance and immediately call your gas supplier or your re department
2. Do not store or use gasoline or other
ammable vapours and liquids in the vicinity of this or any other appliance.
3. An LP cylinder not connected for use shall
not be stored in the vicinity of this or any other appliance.
4. Requires two people to complete the
assembly process.
5. Beware of sharp edges.
WARNING
Failure to follow all of the Manufacturers instructions could result in hazardous res, explosions, property damage, or serious personal injury or even death.
Follow all leak check procedures carefully prior to operation of barbecue, even if grill was dealer assembled. Do not try to light this barbecue without reading the Lighting Instructions section of this manual.
THIS MANUAL MUST REMAIN WITH THE PRODUCT AT ALL TIMES
To ORDER non-warranty replacement parts or accessories,
or to register your warranty, please visit us on the web at
www.centrobbqs.com.
CAUTION
Re ad a nd follow all safety stateme nts, as sembly i nstruction s, and use and c are directions before attempting to assemble and cook.
CAUTION
Sharp edges. Wear gloves when assembling your grill.
THIS BARBECUE IS FOR OUTDOOR USE ONLY
CONTACT CALL CENTRE IF ANY PARTS ARE MISSING
INSTALLER OR ASSEMBLER/CONSUMER
This manual should be kept with the BBQ at all times.
HEAVY ARTICLE NEEDS 2 TO LIFT
Page 3
1
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED FOR ASSEMBLY
• #2 Phillips screwdriver (long and short)
• ¼” Slotted screwdriver (long and short)
• Adjustable wrench
• Pliers
• Rubber Mallot
Before assembling the barbecue, read these instructions carefully.
Assemble the barbecue on a at, clean surface. Grill is heavy.
Notes: Do not fully tighten all the nuts during this initial stage.
No. Description Part Number Quantity
1 1/4"-20UNC×13 Screw 20120-13013-250 10
2 ø7 Flat Washer 41400-07000-250 10
3 ø7 Lock Washer 40300-07000-250 10
4 NO.10-24UNC x10 Screw 20124-10010-250 14
5 ø5 Lock Washer 41400-05000-250 14
6 ø5 Washer 40300-05000-250 14
7 Wrench G413-0032-9082 1
#1. ¼” - 20UNC×13 Screw (x10)
#4. NO.10-24UNC x10 Screw (x14)
#10. Wrench (x1)
#2. ø7 Flat Washer (x10)
#5. ø5 Lock Washer (x14)
#3. ø7 Lock Washer (x10)
#6. ø5 Washer (x14)
Caution: Sheet metal can cause injury. Wear gloves when installing the grill.
Page 4
2
PARTS LIST FOR 85-1140-8 (A01201)
Item Quantity Description Part No.
A1 1 Main Cart Frame Assembly A012-0100-01
A2 1 Sink Assembly A006-0900-01
A3 1 Upper Back Panel A012-0008-01
B 1 Connector A006-0018-01
C 1 Faucet A006-0009-01
D 1 Cutting Board A012-0002-01
E1 1 Sink Strainer A006-0028-01
E2 1 Sink Hose A006-0022-01
F1 1 Condiment Holder A012-0005-01
F2 1 Cuisine Logo A012-0006-01
F3 1 Towel Bar G502-0016-01
G 1 Front Brace A012-0001-01
H1 1 Handle for Trash Basket A012-0014-01
H2 1 Trash Basket A012-0013-01
I 1 Back Panel A012-0007-01
J 1 Left Side Panel, Cart A012-0200-01
K 1 Right Side Panel, Cart A012-0300-01
L1 1 Pillar, Left A012-0600-01
L2 1 Pillar, Right A012-0700-01
L3 2 Magnet Assy G401-0052-01
M 1 Door Assy A012-3000-01
N 1 Bottom Shelf A012-0500-01
O 2 Caster Assy W/ Lock G401-0061-01
P 2 Caster Assy G606-0027-01
Q 1 Joint Hook A012-0016-01
1 Hardware Pack A012-B001-01
1 Assembly Manual A012-M001-01
1 Safety & Care Manual G617-M001-02
Page 5
3
EXPLOADED DIAGRAM FOR 85-1140-8 (A01201)
A2
B
C
A1
E1
I
G
D
F1
Q
H1
H2
L2
K
L1
L3
L3
F2
F3
O
N
M
J
P
Manual
Safety & Care
Manual
Hardware
Pack
A3
E2
Page 6
4
ASSEMBLY INSTRUCTIONS
1
2
P
J
K
N
O
N
Front view
#3 ø7 Lock Washer(X6)
#1 1/4"-20UNCx13 Screw(X6)
#2 ø7 Flat Washer(X6)
Separate the 2 dierent types of wheels, 2 locking wheels (O) and 2 regular wheels (P).
Attach the locking wheels (O) to the back of the bottom shelf (N) and the regular wheels (P) to the front of the bottom shelf (N).
To secure the 4 wheels, hand tighten rst. Then, tighten further using the wrench provided in the hardware pack.
Ensure that the wheels are rmly locked in the “ON” position before continuing.
Assemble the left side panel (J) and the right side panel (K) to the bottom shelf (N).
Page 7
5
ASSEMBLY INSTRUCTIONS
L2
L1
A
B
#3 ø7 Lock Washer(X4)
#1 1/4"-20UNCx13 Screw(X4)
#2 ø7 Flat Washer(X4)
#4 No.10-24UNC x10 Screw(X6)
#5 ø 5 Lock Washer(X6)
#6 ø 5 Washer(X6)
4
3
I
K
J
Front view
J
K
Back view
Attach the left pillar (L1) and the right pillar (L2) to the side panels (J & K) and to the bottom shelf (N), as shown in Figure A and B.
Attach the back panel (I) to the rear of the left and right cart side panels (J & K).
Page 8
6
ASSEMBLY INSTRUCTIONS
#4 No.10-24UNC x10 Screw(X6)
#5 ø 5 Lock Washer(X6)
#6 ø 5 Washer(X6)
A3
5
6
E1
E2
Underside of the main cart frame.
I
K
Back view
From underneath the sink cart, attach the sink hose (E2) to the sink assembly (A2).
THIS STEP REQUIRES 2 OR MORE PEOPLE. DO NOT ATTEMPT ALONE. EXTREMELY HEAVY!
a. Position the main cart frame (A) onto the cart
assembly, as shown in Figure A.
b. Use the hardware to connect both parts, on the
left and right sides, at the four points indicated in Figure B.
A.
B. B.
Page 9
7
ASSEMBLY INSTRUCTIONS
#4 No.10-24UNC x10 Screw(X2)
#5 ø 5 Lock Washer(X2)
#6 ø 5 Washer(X2)
7
8
L1
L2
G
Front view
L2
L2
L1
L1
M
Attach the front brace (G) to the left and right pillars (L1 & L2).
TIP: One person should align the left side, while the second person assembles the right side.
a. Locate the door anchor pins on both the left
and right pillars (L1 & L2).
b. Locate the holes on the bottom of the door (M).
Insert the door anchor pins into the door.
Tip: push in on the door anchor pin with something solid so that the door can slide into place.
Page 10
8
ASSEMBLY INSTRUCTIONS
9
10
H2
H1
H2
M
M
M
Insert the handle for the trash basket (H1) into the back of the trash basket (H2).
Slide the trash basket (H2) down the rails that are located behind the door (M) as shown.
Page 11
9
ASSEMBLY INSTRUCTIONS
D
C
11
13
A3
B
Washer
Adapter
A
12
a. Remove washer and adaptor from faucet (C).
b. Insert faucet (C) through the main cart frame
(A). Tighten in position using the washer and adaptor removed.
Place the cutting board (D) on the main cart frame (A).
A garden hose is required for this step.
To attach the garden hose to the unit: There are two pieces to the Connector (B). Separate the two pieces to slide a cut garden hose through the collar. Then insert the end of the garden hose to the Connector. Now screw the collar to the other part of the Connector to fasten the garden hose. Finally attach the two pieces of the Connector together.
Page 12
10
NOW AVAILABLE!
Centro Countertop Corner Leaf (# 85-1147-4/ A01301)
o Extend your counter space
o Arrange your Centro BBQ and Centro Cuisine outdoor
appliances at a 45° angle
o Connect your Centro BBQ and Centro Cuisine outdoor
appliances for a seamless outdoor kitchen experience.
Design inspired,
Chef admired
EASY CLEAN GREASE COLLECTION SYSTEM
Completely removable lower casting and grease tray.
PERFORMANCE AND DURABILITY
Cast iron cooking grates, warming rack and heat plates. Durability and performance.
PRECISION PORTED BURNERS
U-shaped stainless steel grill burners accurately deliver up to 14,200 BTU each.
SURE-START IGNITION
Enjoy the endurance and reliability.
+ ++ =
S
E
a
Sink & Preparation Centre Breakfast CentreCounter Top Corner Leaf
2800 3800 4800
5800 6800
Step 1
Attach the front connect plate (B) to (A) by using #1 (×2), #2 (×2) and #3 (×2).
#1×2
Sink & Preparation
Centre
Breakfast CentreCounter Top
Corner Leaf
Loading...