Centrimaster IQIC User Manual
Chilled beam Flexicool® IQIC
0
0
10
20 30 40 50
500
1000
1500
IQIC-300
IQIC-240
IQIC-180
IQIC-120
Chilled beam Flexicool® IQIC
Functions
• FPC
• High air flow
• Controls
• Comfort control
• Heating
The chilled beam Flexicool® IQIC is an integrated system for ventilation,
cooling and heating, fulfilling most needs for indoor climate. These supply
air beams are designed to manage high cooling effects that, because of good
mixing with room air, provide comfort and low air velocities in the occupied
zone. The top side of IQIC is covered, and it is designed for ceiling mounting.
Its dimensions are suited for a ceiling module sized 600 mm. The chilled beam
is equipped with adjusting rails for the adjustment of air flow, cooling effect
and flow pattern. The simple adjustment of flow pattern makes it possible to
adapt to changing conditions in the room.
Quick Selection
Cooling effect in W incl supply air
Product Facts
• Chilled beam IQIC for ceiling
mounting
• Suited for standard 600 mm
ceiling module
• Capacity and flow directions
easily adjustable
• Bottom plate can be pushed aside
to enable adjustments of capacity
as well as check-up and cleaning
• Patent pending for the sound
attenuator
• Fastening brackets for quick and
easy mounting - lift up - snap on
Product code example
Chilled beam IQIC for ceiling
mounting, suited for ceiling module
600 mm, manufactured by Fläkt
Woods. With stepless adjustment of
air flow and flow pattern.
Chilled beam IQIC-180-1-1-1
The diagram shows the approximate cooling ef fect Ptot in W with water flow qw = 0,05 l/s, t emperature
difference between room air and supply air Δt= 8 °C, pressure drop 70 Pa on the air side and max. sound
pressure level LA10 = 30 dB(A).
Supply air flow, l/s
Fläkt Woods 1
Specifications are subject of alteration without further no tice.
Chilled beam Flexicool® IQIC
Application and function,
material
Function
The chilled beam IQIC is designed for ceiling mounting,
and it is suited for ceiling modules of size 600 mm both
in length and width, which means that it is flush with the
ceiling surface.
The air flow can be adjusted by means of the patented
adjusting rails with which the length of the holes in the
supply air duct is changed. This can easily be done with
normal adjustments. A regulating damper is normally not
required.
The adjustable hole lengths allow different air
distribution (two-way, one-way and middle positions).
The simple adjustment of air distribution and capacity
makes it possible to adapt to changing conditions in the
future.
Before delivery, the hole lengths of standard beams
are preset at the longest possible position to provide a
starting position for later adjustment. Individual adjustment of hole lengths is available at the factory. In this
case, all beams are marked and must be identified at
delivery and assorted at the building site.
The beam can be supplied with a coil for heating water.
The bottom plates can be pushed aside to allow easy
cleaning and adjustment of air flow.
An enclosure with movable bottom plates is available as
an accessory. This provides a simple way of accessing the
connections and valves. The fitting piece is designed to be
placed on the T-profiles of the ceiling.
The purging nipple is included in the standard delivery.
Material
The casing is mainly made of galvanized steel sheet and
aluminium profiles, and it is powder painted in white.
The standard colour NCS 0502-Y, gloss level 30, which
corresponds to RAL 9010.
Coil made of copper pipe with connection, Øout = 15 mm,
and aluminium fins. Maximum working pressure 1,6
MPa.
Fläkt Woods 2
Specifications are subject of alteration without further no tice.
Loading...