Cecilware EL2 Operators Manual

Electric Short Order Stove

Operator Manual

EL24SH

Grindmaster-Cecilware

4003 Collins Lane, Louisville, KY 40245 USA
Phone: [phone] Toll Free: 800.695.4500
Fax: [phone]
Web: gmcw.com Email: [e-mail]

Safety Information .....................................2

Unpacking...................................................3

Installation..................................................3

Cleaning......................................................3

Parts List......................................................4

Wiring Diagram..........................................4

Thank you for purchasing this quality Stove. For your safety and the safety of others, read all warnings
and the operator’s manual before installing or using the product. Properly instruct all operators. Keep
training records. For future reference, record serial number here:

Table of Contents

©2016 Grindmaster-Cecilware

Printed in USA

0516 Form # CW-337-01

Part # 390-00084

Grindmaster-Cecilware provides the
industry’s BEST warranty. Visit gmcw.com
for warranty terms and conditions.

Model: EL24SH

2 Cecilware

®

Electric Short Order Stove

Safety Information

Important Safety Information

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.

WARNING

• Do not deform power cord.

• Follow national and local electrical codes.

• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.

• Use only on a dedicated circuit load that is properly protected and capable of the rated load. Do not use
extension cords, as this could result in electrical shock, overheating, and fire.

• Risk of electrical shock. Disconnect power before servicing or cleaning unit. Contact Grindmaster-Cecilware
Technical Service for service assistance.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agents, or similarly
qualified persons in order to avoid a hazard.

• Due to the heat a stove may produce, it must be placed with at least 1 inch clearance from all surfaces at
side and rear.

FAILURE TO COMPLY TO THE ABOVE RISKS PERSONAL INJURY, SHOCK HAZARD, FIRE, OR DAMAGE TO
EQUIPMENT.

CAUTION

• Read and understand the operating instructions in this manual thoroughly. Only allow properly trained
persons to operate this machine.

• Stay alert at all times during operation.

• Operate with care. Surfaces will get very hot and may cause serious burns.

NOTICE

• Keep operating area clean.

For your safety and the safety of others, read all warnings and the operator’s manual before installing or using
the product.

DANGER: This term warns the user of imminent hazard that will result in serious injury or death.
WARNING: This term refers to a potential hazard or unsafe practice, which could result in serious injury or

death.

CAUTION: This term refers to a potential hazard or unsafe practice, which could result in minor or moderate

injury.

NOTICE: This term refers to information that needs special attention or must be fully understood.

Electric Short Order Stove Cecilware

®

3

Unpacking

Carefully lift unit out of shipping container, and inspect
immediately for shipping damage. Your Stove was
shipped in a carton designed to give it maximum
protection. It was thoroughly inspected before leaving
the factory. File any claims for shipping damage or
irregularities directly with the carrier.

Installation

Component Assembly

Legs are shipped with unit in a plastic bag. Screw in the
legs hand tight. Level unit after final installation.
Height may be adjusted by turning the feet up or down
as desired.

Clearances

Distance required between combustible and non­combustible material: 1” rear and 1” sides.

Electrical Installation

FOR QUALIFIED SERVICE PERSONS ONLY
Before connecting the stove read the electrical

specification label located on the back of unit. Verify
that the power supply available matches the
information on this label.

Preparing Stove

Before using stove for the first time, heat elements for
three to five minutes to burn off protective coating.
This also hardens the surface of the solid heating
elements.

Cleaning

Solid heating elements are easily cleaned with a damp
cloth after each use. Clean dirt and spills with powder
cleanser and a non-scratch scrub pad. Wipe off cleanser
with a damp cloth. After cleaning, rub a few drops of
cooking oil onto the surface of the elements, and then
switch on the elements for a few minutes to re-harden.

Stainless steel exterior surfaces can be cleaned with
powder cleanser and a non-scratch scrub pad, rubbing
with the grain of the stainless steel. Rinse and wipe dry,
and then polish with a soft cloth.

If you need help, call Grindmaster-Cecilware Technical
Service Department, [phone] or [phone]
(USA & Canada only) (Monday through Friday 8 AM - 6
PM EST). Please have the model and serial number
ready so that accurate information can be given.

Prior authorization must be obtained from
Grindmaster- Cecilware for all warranty claims.

Grindmaster-Cecilware provides the industry’s
BEST warranty. Visit our website at GMCW.com
for warranty terms and conditions.

WARNING: Electrical shock hazard. This is high

voltage equipment. Make sure main disconnect is off
before connecting stove.

NOTICE Unit must only be installed and operated

with legs provided by manufacturer.

CAUTION: To avoid burns, allow stove to cool

before cleaning.

CAUTION: Disconnect power from stove before

attempting electrical repairs.

Grindmaster-Cecilware

4003 Collins Lane, Louisville, KY 40245 USA
Phone: [phone] Toll Free: 800.695.4500
Fax: [phone]
Web: gmcw.com Email: [e-mail]

Grindmaster-Cecilware provides the
industry’s BEST warranty. Visit gmcw.com
for warranty terms and conditions.

©2016 Grindmaster-Cecilware

Printed in USA

0516 Form # CW-337-01

Part # 390-00084

Wiring Diagram

Parts List

PART # DESCRIPTION

B0000AL TERMINAL BLOCK

B007A STRAIN RELIEF

C097A LINE CORD (SINGLE PHASE)

G218A SOLID HEATING ELEMENT
L313A INFINITE SWITCH
M060A INFINITE SWITCH KNOB

M172S LEGS (SET OF 4)
R361A BOTTOM COVER

C164A PILOT LIGHT