CatEye HL-EL1020RC operation manual

RECHARGEABLE HEADLIGHT
HL-EL1020RC
Manual
Before using the light, read this manual thoroughly and keep it for future reference.
Design Pat. Pending Copyright© 2017 CATEYE Co., Ltd. EL1020RC-170824 1
WARNING!!!
ENG
• This light emits an extremely powerful beam equiva­lent to automobile headlight so it may cause a hazard­ous situation depending on the beam angle used. Be sure to direct the light beam downward so the driver approaching does not get dazzled.
• Before your trip, please make sure the light is fi rmly mounted to the bracket, it lights up, and the light is not blocked by baggage, etc.
• Always attention to the remaining battery power by checking the indicator periodically while using.
CAUTION!
• Do not stare at the light when it is illuminating. Otherwise it may damage your eyesight.
• Do not place it within children’s reach.
• In preparation for unexpected battery shutoff, we rec­ommend you carry a spare cartridge battery and light.
• Mounting the light unit too close to a wireless comput­er may adversely affect the reading of the computer.
• This product is water-resistant under normal daily use and can be used in the rain. However, do not inten­tionally submerge it in water.
• If the light unit or parts become dirty with mud, etc., clean with a soft cloth which is moistened with mild soap. Never apply paint thinner, benzine or alcohol; damage will result.
Before Initial Use
This unit is shipped with a small charge to check the light. Be sure to charge it before use, according to the instructions “HOW TO CHARGE”.
Light unit
Cartridge battery (BA-6.8TF)
1 HOW TO CHARGE
Standard charging time
Approx.
Charge jack cover
1. Connect the light unit to your PC or a commercial USB battery charger using the USB cable.
(1 – 2) The switch lights up, and charging starts.
Switch button light State (charging rate)
Illuminated in red Charging (less than 50%) Illuminated in orange Illuminated in green Charging is completed
* When your PC is in sleep state, the unit cannot
be charged.
* Use a USB battery charger of 500mAh (USB2.0)
or more. The cartridge can be fast-charged with
high capacity USB battery charger.
5.5 – 15 h
1
Charging (more than 50% )
USB cable (MICRO USB)
USB cable
To PC or USB battery charger
FlexTight™ bracket (H-34N)
2
2. After charging is completed, remove the USB cable, and install the charge jack cover.
* The battery charges to about 80% after approxi-
mately 12 hours.
* Charging and lighting times are approximate
values, and will vary by environmental and user conditions.
LITHIUM-ION BATTERIES
Cautions on recharging
• Avoid charging in direct sunlight or in a vehicle parked under direct sunlight, and make sure to charge only when the ambient temperature is between 41°F and 104 °F (5 and 40°C).
• Before charging, be sure that no dust or other foreign objects attach to the USB plug.
• Do not subject the light to vibrations while charging.
• Once charging is complete, be sure to disconnect the USB plug.
Cautions in use
• Charging, discharging, and storing in high tem­peratures will cause the rechargeable battery to deteriorate faster. Do not place the light inside a vehicle or near a heater.
• When the operating time decreases signifi cantly, the battery life is close to an end. Replace the cartridge battery with a new one.
Cautions on storage
• Cool and dry storage is recommended. For long period storage, it is important to charge the battery 30 minutes every 6 months.
• When you store the cartridge battery alone, be sure to install the cap. Otherwise, damage or a fi re may be caused by short circuit.
Cautions for dispose
Dispose of used cartridge batteries appropriately according to local regulations.
2 HOW TO MOUNT TO A BICYCLE
DialRubber padBracket
2
1
3
Strap
1. Mount the bracket to the handlebar. (1 – 3) Insert the light unit into the bracket until it clicks,
2. and adjust the beam angle. (4)
Beam angle adjustment
Turn on the light on a smooth road at night, and loosen the dial slightly to move the bracket. Adjust the beam angle so it does not direct to a driver approaching and then tighten the dial fi rmly to fi x the bracket.
3. To remove the light unit, pull out it forward while
CAUTION!:
NO!
OK
Screw
*1
4
pressing down on the release button (
Be sure to tighten the dial by hand. When you
tighten it too hard with a tool, the screw thread may be stripped.
Check the dial and screw (*1) on the bracket pe-
riodically, and use them without any loosening.
Round off the cut edge of the bracket strap to
prevent injury.
5
Release button
).
5
CO
., LTD.
3 SWITCH OPERATION (SWITCHING THE LIGHTING MODE)
WARNING!!!: Do not use this light on a public road.
The ON/OFF and lighting modes are selected using a switch. *2 When you turn the light on, it lights up in the last lighting mode you used. (Mode memory function)
* The light unit may get hot depending on the condition the light is used in but it is not a malfunction. When it gets hot, protection circuit activates and it auto-
matically lowers brightness level. One it is cooled down, the light recovers the previous brightness level.
OFF ON
Press and hold
Switch (Indicator)
Press and hold
*2
Approx.
Middle
5 h
Approx.
Low
15 h
Approx.
12 h
HyperConstant
Double-click
*2
Hi Hi
Remaining battery capacity (Battery indicator)
When the switch lights up, there is little remaining battery power.
Switch button light Remaining battery power
Illuminated in orange 50 - 30 %
Illuminated in red 30 - 15 %
Flashing in red Less than 15%
4
HOW TO REPLACE THE CARTRIDGE BATTERY
Remove the cartridge battery according to the procedure. (1 – 2) To install the cartridge, reverse the procedure.
CAUTION!: Make sure the lock pin fi ts fi rmly into the cartridge battery.
If not locked fi rmly, the cartridge battery may drop off and it may cause sudden turn off.
1
2
Cartridge battery
Click Click
Lock pin
OK
NO!
Approx.
2 h
Approx.
150 h
Flashing
SPECIFICATIONS
Light source High-intensity LED x 2 Cartridge battery Li-ion 3.6v 6800 mAH : BA-6.8TF Charge Micro USB plug
Hi : Approx. 2 hours Middle : Approx. 5 hours
Operating time
Standard charging time Approx. 5.5 – 15 hours
Temperature range
Recharge/discharge number of times
Dimensions/weight
* The specifi cations and design are subject to change without notice.
Low : Approx. 15 hours HyperConstant : Approx. 12 hours Flashing : Approx. 150 hours * Average runtime at 20˚C.
Charging : 41˚F – 104˚F (5˚C – 40˚C) Operating : 14˚F – 104˚F (-10˚C – 40˚C)
About 300 times (until the rated capacity drops to 70%)
4-45/64" x 2-13/64" x 1-55/64" (119.3 x 56 x 47.3 mm) /
9.04 oz (256.3 g) (Including the cartridge battery)
SPARE/OPTIONAL PARTS
5338827N
FlexTight™ bracket
5341831N
Helmet mount
5342440
Center fork bracket
5343200
Cartridge battery (Li-ion 3.6v 6800 mAH)
(BA-6.8TF)(H-34N)
5342730
USB cable
(MICRO USB)
LIMITED WARRANTY
2-year Warranty : Light unit only (Deterioration of the cartridge battery is out of warranty)
CatEye products are warranted to be free of defects from materials and workman­ship for a period of 2 years from original purchase. If the product fails to work during normal use, CatEye will repair or replace the defect at no charge. Service must be performed by CatEye or an authorized retailer. To return the product, pack it carefully and enclose the warranty certifi cate (proof of purchase) with instruc­tion for repair. Please write or type your name and address clearly on the warranty certifi cate. Insurance, handling and transportation charges to CatEye shall be borne by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights.
Please register your CatEye product on the website. http://www.cateye.com/en/support/regist/
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan Attn: CATEYE Customer Service Section Phone : (06)6719-6863 Fax : (06)6719-6033 E-mail : support@cateye.co.jp URL : http://www.cateye.com
[For US Customers] CATEYE AMERICA, INC.
2825 Wilderness Place Suite 1200, Boulder CO 80301-5494 USA Phone : 303.443.4595 Toll Free : 800.5.CATEYE Fax : 303.473.0006 E-mail : service@cateye.com
Loading...