Casio XJ-H2650 User Manual

MA1202-A

Multi PJ Digital Camera Update Software

User’s Guide

z Be sure to keep all user documentation handy for future reference.
z To obtain the latest version of this manual visit the website at the URL below.

http://world.casio.com/manual/projector/

z The contents of this User’s Guide are subject to change without notice.
z Copying of this manual, either in part or its entirety is forbidden. You are allowed to use this

manual for your own personal use. Any other use is forbidden without the permission of CASIO
COMPUTER CO., LTD.

z CASIO COMPUTER CO., LTD. shall not be held liable for any lost profits or claims from third

parties arising out of the use of this product or this manual.

z CASIO COMPUTER CO., LTD. shall not be held liable for any loss or lost profits due to loss of

data due to malfunction or maintenance of this product, or any other reason.

z The sample screens shown in this manual are for illustrative purposes only, and may not be

exactly the same as the screens actually produced by the product.

1

Multi PJ Digital Camera Update Software

In order to use the PJ Digital Camera (YC-400) with a CASIO projector, you need to first check the
camera’s firmware and update it if necessary. Check to make sure that your PJ Digital Camera is
running firmware Version 1.10 or higher.

To check your firmware version

1. Check to make sure there is no memory card loaded in the PJ Digital Camera. If there is a memory
card loaded, remove it.

2. On the camera, hold down the [MENU] button as you press the [ON/OFF] (Power) button to turn
on power. Keep [MENU] depressed until the version of the camera’s firmware appears on the
monitor screen.

3. After a short while, the version number will disappear from the display.

Important!

z If update software installation is interrupted due to low battery power, the camera will no longer be

able to operate. Be sure to load a fully charged battery into the camera before starting the update
software installation procedure. Note that you perform update software installation at your own risk.

z If you are unable to restart the camera after installing the update software, contact the Authorized

Service Center of your local CASIO distributor or a CASIO service center. Tell them you need
assistance because your camera will not restart after installing YC-400 update software.

z Before installing the update software, be sure you back up the data in camera memory and on the

memory card to your computer’s hard disk.

z Installing the update software can cause changes in the camera’s image memory size, camera

startup time, recording time, recording interval, user settings, etc.

z Note that installation of the update software cannot be undone. Once you install the update

software, there is no way to restore the camera to its original firmware version.

z The product warranty on your camera remains in effect in accordance with the warranty card you

received when you purchased the camera, regardless of whether or not you install the update
software.

Requirements for Installing the Update Software on Your Camera

z The installation procedure temporarily writes the update software to a memory card. The following

items are required for installation: SD/MMC memory card with at least 5MB of free space, and the
USB cable and USB cradle that come with the camera.

z If you do not have an SD/MMC memory card or if you do not have the update software on hand for

some reason, contact your nearest CASIO service center and request installation from them. Note
that if you do request installation, you will need to leave your camera at the CASIO service center
a few days.

2

for