Casio MRW-S300H series, MTP-VS01GL series Operation Manual
MA1602-EA
Ú
#!3)/#/-054%2#/,4$
Operation Guide 5330/5493
x Your watch may differ somewhat from the one shown in the illustration.
Before Using the Watch for the First Time
x Depending on your watch model, there may be a spacer installed
at the factory around the crown. If your watch has a spacer, you
should remove the spacer before using the watch.
x After removing the spacer, use the procedures in “Crown
Operations” and “To adjust the time setting” to set up the watch
for use.
Click 2
Click 1
30
Crown
To adjust the time setting
When the second hand is at 12o’clock, pull
Crown out to Click 2.
the
Rotate the Crown to change the time setting.
Push the Crown back in.
Note
x When changing the time,
move the minute hand four
or fi ve minutes past your
fi nal setting, and then back it
up to the setting you want.
Crown
Spacer
Solar Charging
A solar panel generates electrical power that charges a built-in (secondary) battery.
The entire face is a solar panel, so power is generated when the face is exposed to
light. Keep the watch exposed to light as much as possible.
Charging the Battery
When you are not wearing the watch, leave it where it is exposed
to light. For stable operation, expose the watch to at least a half
day of light per month.
When wearing the watch, try to keep your clothing from blocking
its face (solar panel). Charging effi ciency is reduced signifi cantly
even if the face is blocked only partially.
Caution!
x The case of the watch may become quite hot when charging. Guard against burn
injury after charging.
x Avoid charging in the following locations, and anywhere else where the watch may
become very hot.
− On the dashboard of an automobile parked in the sun
− Close to an incandescent light source or other sources of heat
− Locations exposed to direct sunlight for long periods
Low Battery Alert
The second hand will jump at two-second intervals to alert you when the charge is
low.
Regular Timekeeping Low Battery Alert
Low charge
To change the day setting
Pull the Crown out to Click 1.
Rotate the Crown towards you to set the day.
Push the Crown back in.
Crown Operations
Some water-resistant models (100meters, 200meters)
have a screw-in crown. When you need to perform a crown
operation, rotate it towards you to unscrew it. Then pull the
crown out. Avoid applying undue force when pulling. The watch
loses its water resistance while the crown is unscrewed. After
performing a crown operation, fully screw the crown back in.
If your watch has a rotary bezel...
You can rotate the bezel to align its ▼ mark with the
minute hand. Then you will be able to tell how much
time has elapsed since aligning the ▼ mark.
Note
x The day setting uses a
31-day month. Make
adjustments for months of
shorter lengths.
x Avoid changing the day
setting between the hours
of 9p.m. and 1a.m.
Otherwise, the day may
not change correctly at
midnight.
Start
Elapsed time
Current
Crown
Loosen
Specifi cations
Accuracy at normal temperature: ±20 seconds a month
Other: Low battery alert
Power Supply: Solar panel and one rechargeable battery
Approximate battery operating time: 3 months (no exposure to light after a full charge)
Charged
2-second jump
Charging Time
The times below are general guidelines for reference only.
Charging Time to Support Daily Use
Exposure Level (Brightness) Approximate Charging Time
Outdoor sunlight (50,000 lux) 8 minutes
Sunlight through a window (10,000 lux) 30 minutes
Daylight through a window on an overcast day
(5,000 lux)
Indoor fl uorescent lighting (500 lux) 8 hours
Charging Time to Recover from Dead Battery
Approximate
Exposure Level (Brightness)
Outdoor sunlight (50,000 lux) 3 hours 20 hours
Sunlight through a window (10,000 lux) 11 hours 72 hours
Daylight through a window on an
overcast day (5,000 lux)
Indoor fl uorescent lighting (500 lux) 168 hours – – –
Note
x Actual charging time depends on environmental conditions.
Charging Time to
1-second Hand
Movement
17 hours 116 hours
48 minutes
Approximate Time
to Full Charge
1
Loading...