Casio IQ-48 User Manual

MA0612-EA

Operation Guide W-CLO.H

• A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the clock.

• Depending on its model number, the appearance of your clock may differ somewhat from that shown in the illustration.

TO START THE CLOCK

Insert a battery into the battery compartment (

1) with polarity as indicated.

TO SET THE TIME

Turn the hour/minute adjuster (

2) in either direction.

TO CALIBRATE THE SECONDS

<Type 1> Remove the battery to stop the second hand at 12 o’clock position. Replace the battery at a time signal to restart the second hand on the correct second. <Type 2> Slide switch ( restart the second hand.

• The start of the second hand may be delayed depending on the restart timing.

3) to the STOP setting to stop the second hand. Slide (

3) to START on a time signal to

REPLACING THE BATTERY

Low battery power is indicated when timekeeping slows or stops completely. Should either of these symptoms occur, replace the battery immediately. A battery left in the clock after it becomes low or goes dead can leak battery fluid.

1. Remove the old battery.

2. Load a new battery, making sure that its positive (+) and negative (–) ends are facing correctly. Loading

a battery incorrectly can cause it to burst and damage the clock.

Battery precautions

• Keep batteries out of the reach of small children. If a battery is swallowed accidentally, contact your physician immediately.

• Be sure to load the battery with its positive (+) and negative (–) ends facing correctly.

• Never charge the battery that comes with the clock.

• Should a battery ever leak while in the clock, wipe out the fluid with a cloth, taking care not to let any get

onto your skin.

• Replace the battery at least once a year, even if the current battery is working normally.

• The battery that comes with the clock loses some power during transport and storage.