Casio ID-12 User Manual
USER’S GUIDE ID-12
• A sticker is affixed to the display of this clock when you purchase it. Be sure to remove the sticker before using
the clock.
• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the
illustration.
PM indicator
Current time
(Hour, minutes, seconds)
1 cm
DATE (month - date)
GENERAL GUIDE
11
1 Time Set buttons
11
Use these buttons to set the current time.
22
2 SET button
22
Use this button when setting the current time.
33
3 RESET button
33
Press to reset the clock after replacing batteries.
Day of the week
1
USER’S GUIDE ID-12
SETTING THE TIME
1. Press the SET button (
2. While the screen you want is on the display, use the Time Set buttons (
Press + to increase
the flashing digits.
22
2) to cycle through the setting screens as shown below.
22
Normal Timekeeping Screen
Year Setting Screen 12-hour/24-hour Timekeeping Screen
Month and Day Setting Screen Time Setting Screen
11
1)
to change the digits that are flashing.
11
Press – to decrease
the flashing digits.
BATTERY REPLACEMENT
Replace batteries whenever the display of the clock becomes dim and difficult to read.
1. Open the battery compartment cover as shown in the illustration.
2. Remove both old batteries.
3. Load new batteries. Make sure that their positive (+) and negative (–) ends face in the correct directions. If you
load batteries incorrectly, they can burst and damage the clock.
4. Replace the battery compartment cover.
5. Press the RESET button (
Battery precautions
• Be sure to load the batteries with their positive (+) and negative (–) ends facing correctly.
• Replace the batteries at least once a year, even if the current batteries are working properly.
• Never charge the batteries that come with the clock.
• Should the batteries ever leak while in the clock, wipe out the fluid with a cloth, taking care not to let any get onto
your skin.
• The batteries that come with the clock lose some of their power during transport and storage.
• Never mix old and new batteries, or batteries of different brands.
33
3). Be sure to press the RESET button (
33
33
3) after replacing batteries.
33
• Holding down + or – changes the flashing digits at high speed.
• You can set the year in the range of 2000 to 2039. The day of the week is set automatically in accordance with
the date setting.
• Pressing + or – while the Time Setting Screen is on the display causes the seconds count to be reset to 00.
• Each press of + or – while the 12-hour/24-hour Timekeeping Screen is on the display toggles between 12-hour
and 24-hour timekeeping.
3. After making the settings you want, use the SET button (
• The clock automatically returns to the Normal Timekeeping Screen if you leave a setting screen on the display
for about three minutes without performing any operation.
22
2)
to display the Normal Timekeeping Screen.
22
2
Loading...