Casio IC-01 User Manual

MA1312-EA

Operation Guide IC-01

Hour hand Manecilla de hora Ponteiro das horas

Second hand Manecilla de segundos Ponteiro dos segundos

OK BIEN BOM

MAL

RUIM

Minute hand Manecilla de minutos Ponteiro dos minutos

+/–

Hour/minute adjuster Ruedecilla de ajuste de las horas/minutos Regulador das horas/minutos

Analog clock battery compartment Compartimento de la pila del reloj

analógico Compartimento da pilha do relógio

analógico

Digital display battery compartment Compartimento de la pila de la

pantalla digital Compartimento da pilha do

mostrador digital

SET AJUSTE SET

RESET REPOSICIÓN REPOSIÇÃO

Battery Compartments Compartimentos de la pila Compartimentos das pilhas

OK BIEN BOM

MAL

RUIM

Operation Guide IC-01

 A sticker is afﬁ xed to the glass of this clock when you purchase it. Be sure to remove the sticker before using

the clock.

 Depending on the clock model, the conﬁ guration of your clock may differ somewhat from that shown in the

illustration.

OPERATING PRECAUTIONS

 Do not use or store this clock in areas exposed to temperature extremes, strong magnetism, strong vibration,

or strong impact.

 Heat can shorten battery life and cause malfunction. Keep the clock away from heaters and direct sunlight

when using it.

 Never use the clock in a bathroom or any other area subject to high humidity.  Never try to take the clock apart. Doing so can cause malfunction.  To clean the clock, use a soft, dry cloth or a cloth moistened in a solution of water and a mild neutral

detergent. Wring out all excess moisture from the cloth. Never use thinner, benzene, alcohol or other similar

agents.

 Be sure to keep all user documentation handy for future reference.

Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any damage or loss suffered by you or any third party arising through the use of this product or its malfunction.

Important!

 The times indicated by the analog clock and the digital display are not coordinated with each other. Use the

procedures below to conﬁ gure the time settings of each one.

CONFIGURING ANALOG CLOCK SETTINGS

To start clock

Insert a battery into analog clock battery compartment with polarity as indicated.

To set time

Turn the hour/minute adjuster in either direction.

To adjust seconds

Remove the battery to stop the second hand at 12 o’clock position. Replace the battery at a time signal to restart the second hand on the correct second.

 The current time setting may be slightly off, depending on the timing when you load the battery to restart

timing.

CONFIGURING THE DIGITAL TIME SETTING

1. Press the SET button to cycle through the setting screens as shown below.

Current Time Screen

DATE (month-date)

Year Setting Screen

Month and Day Setting Screen

Day of the week

PM indicator Current time

(Hour, minutes)

12-hour/24-hour Setting Screen

Time Setting Screen

2. While the screen you want is on the display, use the + and – buttons to change the digits that are ﬂ ashing.

Press + to increase the ﬂ ashing digits.

 Holding down + or – changes the ﬂ ashing digits at high speed.  You can set the year in the range of 2000 to 2099. The day of the week is set automatically in accordance

with the date setting.

 Pressing + or – while the Time Setting Screen is on the display causes the seconds count to be reset to 00.  Each press of + or – while the 12-hour/24-hour Setting Screen is on the display toggles between 12-hour

and 24-hour timekeeping.

Press – to decrease the ﬂ ashing digits.

+ 1 hidden pages