Casio 5191 User Manual

MA1006-EA

Operation Guide 5152/5191

• Be sure to keep all user documentation handy for future reference.

• Your watch may differ somewhat from the one shown in the illustration.

24-hour hand

Hour hand

Stopwatch minute hand

5191

Stopwatch second hand

Minute hand

Day Day

Crown

Second hand

(Normal position)

First click (Day setting)

Second click (Time setting)

5152

Stopwatch second hand

Minute hand

Hour hand

Stopwatch minute hand

Second hand

To set the time

1. Pull out the crown to the second click.

• This causes the second hand to stop.

2. Set the hands by rotating the crown. Move the minute hand four or five minutes past the time you want to set, and then back it up to the proper setting.

Push the crown back in to the normal position to restart timekeeping.

To set the day

1. Pull out the crown to the first click.

2. Set the day by rotating the crown.

3. Push the crown back in to the normal position.

• Avoid setting the day between 9:00 p.m. and 1:00 a.m. (the day display may not

change in the following day).

Using the Stopwatch

The stopwatch lets you measure elapsed time up to 59 minutes, 59 seconds.

24-hour hand

First click (Day setting)

Second click (Time setting)

Crown (Normal position)

To measure times with the stopwatch

Elapsed Time

Start

To adjust the positions of the stopwatch minute hand and stopwatch second hand

• This procedure should be performed when the stopwatch minute hand and

stopwatch second hand do not return to the zero positions.

1. Press B to reset the stopwatch.

2. Pull out the crown to the second click.

3. Press A to move the stopwatch second hand forward until it points to the zero position.

• The stopwatch minute hand is syncronized with the stopwatch second hand.

4. Push the crown back in to its normal position.

• Note that pulling the crown out also stops the timekeeping second hand. After

performing the above procedure, you should also adjust the timekeeping setting.

Stop Re-start Stop

Clear

■ For watch with the elapsed time bezel Rotate the elapsed time bezel to align the minute hand. After certain amount of time elapsed, read the graduation on the elapsed time bezel which the minute hand points to. The elapsed time is indicated.

• Some water resistant models are equipped with a screw lock

crown.

• With such models, you must unscrew the crown in the direction

noted in the illustration to loosen it before you can pull it out. Do not pull too forcibly on such crowns.

• Also note that such watches are not water resistant while their

crowns are loosened. Be sure to screw the crowns back in as far as they will go after making any setting.

mark with the

Elapsed time bezel

Specifications

Accuracy at normal temperature: ± 20 seconds a month Stopwatch function: Measuring capacity: 59'59''/Measuring unit: 1 second

Battery: One silver oxide battery (Type: SR626SW)

Approximately 2 years on type SR626SW (assuming one stopwatch operation 60 min./day)

Measuring mode: Elapsed time