MA1005-EA
Operation Guide 5170
• Your watch may differ somewhat from the one shown in the illustration.
Minute hand
Hour hand
30
(Light Button)
First click
(setting day)
Second click
(setting time)
Second hand Day
To set the time
1. Pull out the crown to the second click.
• This causes the second hand to stop.
2. Set the hands by rotating the crown.
Move the minute hand four or five minutes past the time you want to set, and then
back it up to the proper setting.
3.
Push the crown back in to the normal position to restart timekeeping.
To set the day
1. Pull out the crown to the first click.
2. Set the day by rotating the crown.
3. Push the crown back in to the normal position.
• Avoid setting the day between 9:00 p.m. and 1:00 a.m. (the day display may not
change in the following day).
About the backlight
• Hold down
• Pressing
• The backlight of this watch employs an electroluminescent (EL) light, which loses
• Frequent use of the backlight shortens the battery life.
• Leaving the backlight on for a long time or turning on the backlight while battery
■ For a watch with an elapsed time bezel
Rotate the elapsed time bezel to align the
minute hand.
After certain amount of time elapsed, read the graduation on
the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
• Some water resistant models are equipped with a screw lock
• With such models, you must unscrew the crown in the
• Also note that such watches are not water resistant while
LL
L to illuminate the face of the watch.
LL
LL
L illuminates the display for about one second.
LL
its illuminating power after very long term use.
power is low can cause the hands of the watch to stop momentarily.
crown.
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
their crowns are loosened. Be sure to screw the crowns back
in as far as they will go after making any setting.
Crown
(normal position)
mark with the
50
40
30
Elapsed time bezel
Specifications
Accuracy at normal temperature: ± 20 seconds a month
Battery: One silver oxide battery (Type: SR621W)
Approximately 2 years on type SR621W (assuming one backlight operation for 5 sec./
day)
10
20
1