How it Works
Casio
Loading...
2323
User Manual [ru]
3 pgs431.55 Kb0
User Manual
2 pgs90.22 Kb0

Casio 2323 User Manual

Hour Minutes 12/24
Module No.2322/2323
GENERAL GUIDE
AA
• Press
A to change from mode to mode.
AA
[Module 2323] [Module 2322]
Timekeeping Mode
Calendar Mode
The operational procedures for Module 2322 and 2323 are identical. All of the illustrations in this manual show Module 2322.
Alarm Mode
Dual Time Mode
2322/2323-1
Stopwatch Mode
ABOUT THE BACKLIGHT
LL
• Press
L to illuminate the display for about 2 seconds.
LL
• The backlight of this watch employs an electro-luminescent (EL) light, which loses its illumi­nating power after very long term use.
• Frequent use of the backlight shortens the battery life.
• The watch emits an audible sound whenever the display is illuminated. This does not indicate
malfunction of the watch.
• The illumination provided by the backlight may be hard to see when viewed under direct sunlight.
• The backlight automatically turns off whenever an alarm sounds.
• When the backlight is turned on, it blinks whenever the minute hand moves. This is normal,
and does not indicate malfunction of the watch.
TIMEKEEPING MODE
• Use this mode to set the current time. An incorrect digital time setting will result in incorrect operation of the calendar.
To set the time and date
PM indicator
1.Hold down
AA
2.Press
A to reset the seconds to 00. If you press
AA
of 30 to 59, the seconds are reset to 00 and 1 is added to the minutes. If the seconds count is in the range of 00 to 29, the minutes count is unchanged.
CC
3.Press
C to move the selection to the hour digits.
CC AA
4.Press
A to increase the hour digits. Holding down
AA CC
5.Press
C to move the selection to the minutes digits.
CC AA
6.Press
A to increase the minutes digits. Holding down
AA
speed.
CC
7.Press
C to move the selection to 12/24.
CC AA
8.Press
A to toggle the timekeeping format between 12-hour and 24-hour.
AA
• When 12-hour format is selected, the indicator P appears on the display to indicate “p.m.” times. There is no indicator for “a.m.” times.
CC
9.Press
C to complete the procedure.
CC
• If you do not operate any button for a few minutes while a selection is flashing, the flashing stops and the watch goes back to the Timekeeping Mode automatically.
To set the hands
When in any Mode, press
BB
of
B advances the time by 20 seconds. Three presses advance by one minute.
BB
Holding down and cannot reverse it.
Minute handHour hand
CC
Hold down
C.
CC
Seconds
12/24
CC
Press
C.
Hour
Seconds
Minutes
CC
C until the seconds digits start to flash.
CC
BB
B with a thin object to advance the analog time setting. Each press
BB
BB
B advances the analog setting at high speed. You can only advance the setting
BB
CC
CC
Press
C.
CC
Hour
Minutes
CC
Press
C.
CC
AA
A while the seconds count is in the range
AA
AA
A changes the hour digits at high speed.
AA
AA
A changes the minutes digits at high
AA
Press
CC
C.
CC
ALARM MODE
When the Daily Alarm is turned on, an alarm sounds for 20 seconds at the preset time each day. When the Hourly Time Signal is switched on, the watch beeps every hour on the hour.
To set the alarm time and to turn the Daily Alarm and Hourly Time Signal on and of
Alarm on indicator
Hourly Time Signal on indicator
Hold down
CC
C.
CC
Press
Hour Minutes
1.Hold down
2.Press
• The format (12-hour and 24-hour) of the alarm time matches the format you select for normal
3.Press
4.Press
5.Press
6.Press
7.Press
8.Press
• At this time Daily Alarm and Hourly Time Signal automatically turn on.
9.Press
• If you do not operate any button for a few minutes while a selection is flashing, the flashing
To stop the alarm
• Press any button to stop the alarm after it starts to sound.
To test the alarm and select an alarm tone
Hold down Each time you test the alarm, a four different alarm tones. The alarm tone you select is used for the Daily Alarm and Hourly Time Signal.
• Note that holding down
CC
CC
AA
A to increase the hour digits. Holding down
AA
timekeeping.
CC
C to move the selection to the left minutes digit.
CC AA
A to increase the left minutes digit. Holding down
AA CC
C to move the selection to the right minutes digit.
CC AA
A to increase the right minutes digit. Holding down
AA CC
C to move Daily Alarm and Hourly Time Signal on and off setting.
CC AA
A to change the status of the Daily Alarm and Hourly Time Signal in the following
AA
sequence.
Both ON Both OFF
CC
C to complete the procedure.
CC
stops and the watch goes back to the Alarm Mode automatically.
AA
A in any mode (except when making any settings) to sound the alarm.
AA
AA
A also changes the mode.
AA
Press
Left
CC
C.
CC
Hour
CC
C.
CC
Alarm/Hourly Time Signal on/off setting
Both OFFBoth ON
minutes digit
Alarm/Hourly Time Signal setting
AA
A changes the digits at high speed.
AA
AA
A changes the digit at high speed.
AA
AA
A changes the digit at high speed.
AA
Daily Alarm
Daily Alarm
Only
only
Press
CC
C.
CC
Right minutes digit
Press
Hourly Time
Hourly Time
Signal Only
Signal only
CC
C.
CC
DUAL TIME MODE
To semt the Dual Time
f
CALENDAR MODE
To set the date
CC
Hold down
C.
CC
Month Day of weekDay
Month
Day of week
Day
1.Hold down
2.Press
3.Press
4.Press
5.Press
6.Press
7.Press
• If you do not operate any button for a few minutes while a selection is flashing, the flashing
CC
C until the month digits start to flash.
CC
AA
A to increase the month digits. Holding down
AA CC
C to move the selection to day digits.
CC AA
A to increase the day digits. Holding down
AA CC
C to move the selection to the day of the week indication.
CC AA
A to advance to the next day. Holding down
AA CC
C to complete the procedure.
CC
stops and the watch goes back to the Calendar Mode automatically.
CC
Press
C. Press
CC
AA
A changes the digits at high speed.
AA
AA
A changes the digits at high speed.
AA
AA
A changes the indication at high speed.
AA
CC
C.
CC
Press
CC
C.
CC
CC
Hold down
C. Press
CC
Hour
Seconds
Minutes
PM indicator
1.Hold down
2.Press
3.Press
4.Press
5.Press
6.Press
• When 12-hour format is selected, the indicator P appears on the display to indicate “p.m.”
7.Press
• If you do not operate any button for a few minutes while a selection is flashing, the flashing
• In the Dual Time Mode, the seconds count is synchronized with the seconds count of the
CC
CC
AA
A to increase the hour digits. Holding down
AA CC
C to move the selection to the minutes digits.
CC AA
A to increase the minutes digits. Holding down
AA CC
C to move the selection to 12/24.
CC AA
A to toggle the timekeeping format between 12-hour and 24-hour.
AA
times. There is no indicator for “a.m.” times.
CC
C to complete the procedure.
CC
stops and the watch goes back to the Dual Time Mode automatically. Timekeeping Mode.
CC
C. Press
CC
AA
A changes the digits at high speed.
AA
AA
A changes the digits at high speed.
AA
Press
CC
C.
CC
CC
C.
CC
Minutes
1/100 second
Seconds
STOPWATCH MODE
The Stopwatch Mode lets you measure elapsed time. The range of the stopwatch is 59 minutes 59.99 seconds.
To use the Stopwatch
CC
1.Press
C to start the stopwatch.
CC CC
2.Press
C to stop the time measurement.
CC
• You can press timing.
3.After you are finished using the stopwatch, hold down
the stopwatch time to all zeros.
CC
C as many times as you want to resume and stop
CC
CC
C to clear
CC
2322/2323-2
Loading...
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use