Casio 1952, 1955, 1932 User Manual
1623 1667 1668 1678 1807 1808 1809 1852
1853 1854 1855 1891 1932 1952 1955
GENERAL GUIDE
• The configuration of this watch may differ somewhat from that shown in the illustration.
CC
• Press
C to change from mode to mode.
CC
• In any mode, press
• The animated figures perform a variety of different actions, depending on the mode the watch is in.
DD
D to illuminate the display for about two seconds.
DD
Timekeeping Mode Alarm Mode
Stopwatch Mode
G’MIX(E)-1
TIMEKEEPING MODE
EE
• Use
Date
Day of the week
E to switch the display between month/date
EE
and date/day of the week.
BB
• Press
B to play a melody for about 10 seconds.
BB
Pressing any key while a melody is play stops the
melody. The melody that plays depends on when
BB
you press
B.
BB
Hour
PM
indicator
To set the time and date
1.Hold down
2. Press
3. While the seconds digits are selected (flashing), press
4.While any other digits (besides seconds), are selected (flashing), press
• While the day of the week is selected, pressing
• While the 12/24-hour setting is selected, press
5. After you set the time and date, press
• The date can be set within the range of January 1, 1995 to December 31, 2039.
• If you do not operate any button for a few minutes while a selection is flashing, the
Minutes
Seconds
AA
A while in the Timekeeping Mode. The seconds digits flash on the
AA
display because they are
CC
C to change the selection in the following sequence.
CC
Seconds Hour Minutes Year
12/24-Hour
Format
“00”. If you press
to “00” and 1 is added to the minutes. If the seconds count is in the range of 00 to
29, the minutes count is unchanged.
crease the number or
current selection at high speed.
BB
pressing
B returns to the previous day.
BB
mats.
flashing stops and the watch goes back to the Timekeeping Mode automatically.
selected
.
Day of
the week
EE
E while the seconds count is in the range of 30 to 59, it is reset
EE
BB
B to decrease it. Holding down either button changes the
BB
Date Month
EE
E to reset the seconds to
EE
EE
E to in-
EE
EE
E advances to the next day, while
EE
EE
E to switch between the two for-
EE
AA
A to return to the Timekeeping Mode.
AA
ABOUT THE BACKLIGHT
DD
• Pressing
D at any time illuminates the display for about two seconds and causes
DD
an animated figure to appear. The type of animation that appears depends upon
when you press
• The backlight of this watch employs an electro-luminescent (EL) light, which loses
its illuminating power after very long term use.
• The watch will emit an audible sound whenever the display is illuminated. This is
caused by a transistor that vibrates when the EL panel lights up. It does not indicate
malfunction of the watch.
DD
D.
DD
ALARM MODE
Hourly time
signal on
indicator
• See the MELODY LIST at the back of this manual for the names of melodies.
• When the Daily Alarm is switched on, the alarm sounds for about 20 seconds at the
preset time each day. Press any button to stop the alarm after it starts to sound.
When the Hourly Time Signal is switched on, the watch beeps every hour on the
hour.
Hour
Current
time
Minutes
Alarm on
indicator
Mode indicator
This watch include three built-in melodies, which you
can use in any of the following five settings to sound
when an alarm time is reached.
Setting
0. Random play of melodies 1, 2, and 3
1. Melody 1
2. Melody 2
3. Melody 3
4. Beeper
Alarm Sound
To set the alarm time
1.Hold down
• At this time the Daily Alarm is switched on automatically.
2.Press
3.Press
• The format (12-hour and 24-hour) of the alarm time matches the format you select
for normal timekeeping.
• When setting the alarm time using the 12-hour format, take care to set the time
correctly as morning or afternoon.
4.After you set the alarm time, press
• If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Alarm Mode automatically.
• If you do not operate any button for a few minutes in the Alarm Mode, the watch
goes back to the Timekeeping Mode automatically.
To switch the Daily Alarm and Hourly Time Signal on and off
Press
Time Signal in the following sequence.
To test the Alarm
Pressing
It takes about 10 seconds for the alarm sound to finish. You can stop it manually by
pressing any key.
• Note that if 0 is set as the alarm sound, pressing
melodies. The sound that is randomly selected when the next alarm time is reached
will probably be different from the one that sounds when you press
AA
A while in the Alarm Mode. The hour digits flash on the display be-
AA
selected
cause they are
CC
C to change the selection in the following sequence.
CC
EE
E to increase the selected digits and
EE
either button changes the selection at high speed.
EE
E while in the Alarm Mode to change the status of the Daily Alarm and Hourly
EE
Both OFF
ALM: Daily Alarm
SIG : Hourly Time Signal
BB
B sounds the currently selected alarm sound.
BB
.
Hour Minutes Alarm Sound
BB
B to decrease them. Holding down
BB
AA
A to return to the Alarm Mode.
AA
Daily Alarm Hourly Time
only Signal only
BB
B randomly selects one of the
BB
Both ON
BB
B.
BB
STOPWATCH MODE
Hours
Mode indicator
Minutes
Seconds
1/100 seocnd
To record split times
EE
1.Press
E to start the stopwatch.
EE
BB
2.Press
B to display the timing up to that point. Stopwatch timing continues internal-
BB
ly.
BB
3.Press
B to clear the split time and to continue time measurement on the display.
BB
• You can repeat steps 2 and 3 as many times as you want.
EE
4.Press
E to stop the time measurement.
EE
BB
5.Press
B to clear the stopwatch to all zeros.
BB
To time first and second place finishes
EE
1.Press
E to start the stopwatch.
EE
BB
2.Press
B when the first finisher crosses the line, and record the time.
BB
EE
3.Press
E when the seconds finisher crosses the line.
EE
BB
4.Press
B to display the finishing time of the second finisher.
BB
BB
5.Press
B to clear the stopwatch to all zeros.
BB
The Stopwatch Mode lets you measure elapsed time,
split times, and two finishes. The range of the stopwatch is 23 hours, 59 minutes, 59.99 seconds.
• Animated figures appear on the display while the
stopwatch is measuring an elapsed time.
• If you do not perform any key operation while in
the Stopwatch Mode, the watch automatically returns to the Timekeeping Mode (except when an
elapsed time measurement is in progress.
To measure elapsed time
EE
1.Press
E to start the stopwatch.
EE
EE
2.Press
E to stop the stopwatch.
EE
• You can resume the measurement operation by
EE
pressing
E again.
EE
BB
3.Press
B to clear the stopwatch to all zeros
BB
(0H00’00”00).
MELODY LIST
G’MIX(E)-2
1623
1 TECHNO
2 HAPPY HOUSE
3 JUNGLE
All of these are CASIO original melodies.
1667
1 No woman no cry
2 Get up, stand up
3 I shot the sheriff
1668
1 I love rock’n roll
2 Never
3 The wild one
1678
1 Best of my love
2 In the night
3 Take your time
T-9730266
T-9750085
T-9710138
1853
1 Young alien types
2 Popyura
3 Kandy pop
T-9790188
1854
1 Look into the past
2 Tombo in 7/4
3 Upa neguinho
T-97A0366
1855
1 SOUL YOUR SMILE
2 PIECES
3 Duck
T-97A0367
1891
1 La isla bonita
2 Bamboleo
3 Tú me amas
T-9790189
1807
1
2
3
All of these are CASIO original melodies.
HIGHER AND HIGHER
music by GTS
ruling!!
music by BG-999
FAKE YOUR GAME
music by
groove treasurers feat.d-secrets!
1808
1 Gimme!Gimme!Gimme!
2 Another moment follows
3 Day after day
1809
1 Move over
2 Somebody to love
3 If it makes you happy
1852
1 Beach baby
2 Runaway
3 Sék’ sé bon
T-9750086
T-9750087
T-9790187
1932
1 Push it
2 Fly girl
3 Real love
1952
1 Desperado
2 Lotta love
3 Have you ever seen the rain?
1955
Take my breath away
1
(love theme from TOP GUN)
Oh pretty woman
2
(main theme from PRETTY WOMAN)
My heart will go on
3
(love theme from TITANIC)
T-9830006
T-9830005
T-9830004
Loading...